Lab #2

.docx

School

Baruch College, CUNY *

*We aren’t endorsed by this school

Course

2001

Subject

Physics

Date

May 15, 2024

Type

docx

Pages

2

Uploaded by ColonelSnailPerson237 on coursehero.com

Name: Yasmin Benzriouil Lab Partners: Sakhna Mainouna Diatta, Andrew Page, Jonathan Mahadeo, Greg Laghiti Title: Gravitational Acceleration Objective of Experiment: the goal of this experiment is to measure g, the gravitational acceleration near the surface of the Earth and to compare it with the known value g = 9.81 m/ s2. Procedure: Cut a paper tape, about 1.5 m long. Attach the weight to one end of the tape using an alligator clip. Pass the other end of the tape underneath the black carbon paper of the spark machine and hold it steady. Turn on the sparker and release the weight. Turn o n the sparker after the weight hits the floor. Make sure the tape leaves the sparker before it hits the floor. If you set the sparker frequency to 40 Hz then the time difference between two adjacent points is 1/40 s. For example, let the time at y 0 be t = 0 s. Then the time at y1 is 1/40 s, the time at y2 is 2/40 s, ···, the time at y14 is 14/40 s and so on. Theory of underlying Physics: That gravitational physics can stay the same when air resistance is negatable. (Free fall) Experimental Data Y0-Y1= 10cm =0.1m V1= 4.4m/s Y1-Y2= 12cm =0.12m V2= 4.7m/s Y2-Y3= 11.5cm =0.115m V3= 4.5m/s Y3-Y4= 11cm =0.11m V4= 4.28m/s Y4-Y5= 10.4cm =0.104m V5=3.98m/s Y5-Y6=9.5cm =0.095m V6=3.7m/s Y6=Y7=9cm =0.09m V7=3.5m/s Y7-Y8=8.5cm =0.085m Y8-Y9=8cm =0.08m Y9-Y10=7.4cm =0.74m Y10-Y11=6.7cm =0.067m Y11-Y12=6.2cm =0.062m Y12-Y13=5.5cm =0.055m Y13-Y12=5cm =0.05m Y12-Y13=4.3cm =0.043m
0.03 0.05 0.08 0.10 0.13 0.15 0.18 3.4 3.6 3.8 4 4.2 4.4 4.6 4.8 Velocity Y2-Y1/X2-X1 =-9.2cm/s^2 (-9.2-9.81)/9.81*100 6% Calculation and Error Analysis/ Conclusions and Sources of Error In comparison to the expected outcome, our results showed a significant decrease. This discrepancy could be attributed to our handling of the line paper, potentially inducing friction by applying force upon release. Most likely this was the case with our lab and eventually the numbers began to decrease in a linear form as shown on the graph instead of increase in a linear form which is the proper behavior for this lab. The observed error deviates from our anticipated outcome, considering our knowledge of the gravitational force as 9.8 m/s². We had assumed our calculations would closely approximate this value; however, our obtained result different greatly as it was in the negatives due to the measurements of the intervals measured during the experiment slowly decreasing each interval instead of increasing this once again was most likely due to human error when making the dot and conducting the overall lab.
Your preview ends here
Eager to read complete document? Join bartleby learn and gain access to the full version
  • Access to all documents
  • Unlimited textbook solutions
  • 24/7 expert homework help