Answered: 3. Given:wye to delta(balanced), abc…

3. Given:wye to delta(balanced), abc sequence VAB=240 angle -20 Load impedance%=20 angle 40 deg Find the phase and line currents

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.24MCQ: Consider a three-phase Y-connected source feeding a balanced- load. The phasor sum of the line...

See similar textbooks

Related questions

Q: A 50 μF capacitor is connected to a 100 V, 200 Hz supply. What is the the real power and the apparen...

Q: A Fimd X[n] from frequency sigal by usingIf Engineering & numerical analysis

Q: Given G3(V,W,X,Y,Z) = Σm(0,2,4,6,7,8,10,11,12,13,14,16,18,19,29,30). Derive the POS and SOP.

A: POS(product of sum) and SOP(sum of product) both are complements to each other. POS represent with t...

Q: Redraw the common emitter high frequency response

Q: H.W. In the network in Figure shown below, Vo is knovn to be 8 45°V. Compute Vs: -j22 V.

Q: Calculate the thermal load associated with a change in temperature equal to +/- 20 for a bridge. The...

A: Given Thermal variation +- 20 Length of span = 171.74m height =90m Thermal load on bridge = ?

Q: At every point in the space ar x ag = 1 Select one: O Incorrect, a O Incorrect, it is -ag O None of ...

Q: The peak to peak voltage is 10 V. The RMS voltage for the experiment, measurement of voltage and fre...

Q: Node anelysis at Node Vy 3 - V-V2 + Vi-V 4 a v,- 3 V2 + V, - V3 = 12 3v, - 2v2 - V3 -12 - O Node ana...

Q: Value of the capacitor’s voltage amplitude VC ?

Q: Shockley's equation defines the. characteristics of the FET and are unaffected by the network in whi...

Q: If a line charge of -16 nC/m is at x = -6 m and y = 4 m, find the electric field intensity E at G(-2...

A: By assuming infinite line charge of uniform line charge density -16 nC/m.

Q: 3. Figure 2 shows the step responses collected from a number of different systems. For each response...

A: Control systems are represented by transfer function. This can be written in both time domain and s...

Q: Referring to the filter in the system as shown in Figure 2.1, solve the difference equation. т (k) %...

Q: If A = 4a, + 3ap – 5a, the component of A parallel to the surface o = 27 is; Select one: O -4ap О 4а...

Q: Find the relative permittivity εr of the dielectric material present in a parallel-plate capacitor i...

Q: A 110V(rms), 60HZ AC source is connected to a motor, which can be represented by a resistor and an i...

Q: The impulse response of a linear time invariant (LTI) system is given as sin(32t) sin(16t) h(t) a) S...

Q: [Q2] 23 analog signals (each is bandlimited to 11kHz) are transmitted simultaneously over a channel ...

Q: 6. Obtain I, in the circuit of Fig. 2.45. 2/0° A 10/90° V j2 Ω -j4 2 1Ω 4/0° A 1Ω Fig. 2.45

Q: 4. Draw an electric circuit for the following problems. V= d(Ln V, +ſV,.dt)/dt

A: We need to draw an electronic circuit as shown below: V=dln V1+∫V2.dtdt

Q: 1. Two sheets of aluminum foil (2.5cm wide by 1.0m long) and two sheets of 0.1mm thick polystyrene d...

Q: An unbalanced delta-connected load is connected across the lines of a 4-wire balanced three-phase su...

A: Given unbalanced delta-connected load is connected across the lines of a 4-wire balanced 3-phase su...

Q: qe im or to K(s + 4) G(s) = s(s + 1.2)(s + 2) range of K that keeps the system stable. e value of K ...

Q: Ofind a-pont values Iecsat) Ves Ccadot)- sketch De load Line and indicate on the Sketch IcQ,YCEQ! to...

A: We need to find out current and voltage for given circuit and load line equation for given circuit

Q: A certain transmitter radiates 9 kW with the carrier unmodulated and 10.125 kW when the carrier is a...

Q: In cylindrical coordinate system, p = 2, ø = defines a; Select one: O Vector Surface Point Line O No...

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12mA and Vp=-4V. Determine Id. a.aro...

Q: z-7 +3z-1- 2z-3 +1 A right-sided sequence has a z -transfom X(z)= 3z-9 Find the index and the value ...

Q: The voltage across a 5 µF capacitor is v(t) = 10 cos 6000 t V The current through the capacitor is (...

Q: 33. For the network of Fig. 7.102, determine: a. Ipo and VGsg b. Vps- с. Vр. o-16 V 2 k2 1 M2 VGS (T...

Q: p-channel JFET used in Digital technology as_____. a.switch b.rectifier c.invertor d.amplifier

A: JFET is a fully controlled device with help of applied gate voltage between the gate and source . B...

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12mA and Vp=-4V. Determine Vs. a.0 V...

Q: 70ohma R2-470oh 330onm CURRENT CALCULATED(m CURRENT VOLTAGE (V) VOLTAGE MEASURED CALCULATED MEASURED...

A: The resulting current is determined by the load which means load decides current. Current lag or lea...

Q: 22) A 4-pole, 240-V, lap-wound, series motor has armature and series fie resistance of 0.3 2, and 0....

Q: OA new 3D dynamic/high resolution surveillance camera is being placed on a A-10 Thunderbolt (warthog...

A: a) EsVcs=11+kakmsτm+1.ktEsVcs=sτm+1sτm+1+kakm.ktEs=sτm+1sτm+1+kakm.kt.vcs ....................

Q: 1. Set up the circuit shown using a function generator for the source voltage Vs. Set the function g...

A: Ans.(1) Given:

Q: Problem 2. Determine the minimum and maximum value of Vi for proper operation of the Zener diode. 91...

Q: What is the cut off frequency of a RC low pass filter of the first order.

Q: The voltage across a 5 uF capacitor is v(t) = 10 cos 6000 t V The current through the capacitor is (...

Q: Problem: Given the following electrical circuit. Please develop the state-space representation with ...

Q: A certain electrical element draws the current i(t)= 10cos4t A at a voltage v(t)= 120cos4t V. Find t...

Q: The nameplate rating of a shunt motor is 150hp,600 volts, 205A, and 1700 rpm. The resistance of the ...

Q: Q 2: Find V1, V3, Vab, Is for the following cct. network R sel! 619 241 shes, cep R, R2 E- 50 30 18 ...

Q: Q1/A sinewave is shown in Fig. below. Determine its amplitude, periodic time and frequency I (mA) +5...

A: In step -2

Q: 8. A 3300 resistor, 100mH inductor and 150nF capacitor are connected in series across a 1kHz source....

Q: Y (s) U (s) 250 U s² + 15s + 250 what is its sampling frequency and its z- Eransform?

Q: Find the potential aference acress each resistor in the figure belon. (R, -5.10 n R,-4.20 nR,-20n, R...

A: Given:R1=5.10ΩR2=4.20ΩR3=2.80ΩR4=2.20Ω Circuit diagram:

Q: The voltage across a 5 uF capacitor is v(t) = 10 cos 6000 t V The current through the capacitor is (...

Q: 2. The input to a full-wave bridge type rectifier with silicon diodes is V, = 10 Vms- Determine: a.)...

Question

3. Different person to answer

3.
Given:wye to delta(balanced), abc sequence
VAB=240 angle -20
Load impedance=20 angle 40 deg
Find the phase and line currents

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Digital Modulation Scheme (Amplitude-Shift Keying [ASK], Phase-Shift Keying [PSK], Frequency-Shift Keying [FSK])

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Draw Wye- Delta three phase transformers connection ( no-load and full-load) in Lt-spice
1. The following are the given for the circuit below: VRY = 220 cis 0°, VYB = 220 cis -120° and VBR = 220 cis -240°. IR = 10 cis 0°. The load is balanced and delta connected. Determine the: (a) Impedance per phase (b) Current per phase (c) Line currents. B R reellle relllle momm Y RY Iy IB ĪR B R ZBR VYB ZRY
2. In the balanced three-phase wye-delta system, find the line currents. 220/0° V 9-j6 2 220 –120° V 22 ww 9-j62 9-j62 220/120° V
A generator and load are connected in Wye –Wye connection, see figure below.Get the line current ib and phase voltage VANUse a frequency of 100Hz
Determine the line currents in the three-phase circuit of the figure given below, where Van = 450 / 0° V, Vbn=450 Z-120° V, and Vcn=450 120° V. Please report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 180 degrees. Vcn Van a n Vbn Ia Ih I 6-j8Q2 A 6-j8Q2 N 6-j8Q2
A balanced three-phase Delta connected voltage source supplies Delta connected three-phase symmetrical load through a three-phase line at 50 Hz as shown in the figure below. Please, answer the following using ZL=0.4+j 0.8 N and Zab = Zbc = Zca=10.3+j 14.1 N. A I a Zz Z. ca I 400 20° v +1 400Z-120° v Ic SOURCE LINÉ LOAD Part F: Calculate the reactive power of the three-phase Delta load in terms of VAr. 4002-240° v
Two delta connected loads are connected in parallel and powered by a balanced Y-connectedsource. The smaller of two loads draws 10 kVA at a lagging power factor of 0.75 and the largerdraws 25 kVA at a leading power factor of 0.8. The line voltage is 400 V. Calculate a) The powerfactor at which the source is operating. b) The total power drawn by the two loads. c) The phasecurrent of each load.
In a balanced system, the phasor sum of the line-to-line voltages and the phasor sum of the line-to-neutral voltages are always equal to zero. (a) False (b) True
Consider a single-phase load with an applied voltage v(t)=150cos(t+10)volts and load current i(t)=5cos(t+50)A. (a) Determine the power triangle. (b) Find the power factor and specify whether it is lagging or leading. (c) Calculate the reactive power supplied by capacitors in parallel with the load that correct the power factor to 0.9 lagging.
Consider a three-phase Y-connected source feeding a balanced- load. The phasor sum of the line currents as well as the neutral current are always zero. (a) True (b) False
In a three-phase balanced Y-Y system, the source phase currents have a magnitude of 9 A. The magnitude of the current on each load is Select one: O a. 9A O b. 12 A O c. None of these O d. 27 A In a three phase Y connected generator, the phase voltages are 2 kV. The magnitudes of the line voltages are Select one: O a. 3464.1 V O b. 6000 V Oc. 2000 V O d. 1154.7 V
In a three-phase wye-connected source, the three phase currents are 12/15° A, 12Z- 105° A, and 12Z135° A. What must the three line currents be? O 12/45° A, 12Z – 75° A. and 12/165° A O 12/15° A. 122 – 105° A, and 12/135° A - 6.93/45° A. 6.93Z- 75° A, and 6.93/165° A O 6.93Z15° A. 6.93Z – 105° A. and 6.93Z135° A