4. The Voltmeter connected across load (Bulb) will measure [Choose any one answer] Potential Difference + 5. A constant current source supplies a electric current of 200 mA to a load of 2kQ. When the load changed to 500, the load current will be 0700mA O8A O12A

4. The Voltmeter connected across load (Bulb) will measure [Choose any one answer] Potential Difference + 5. A constant current source supplies a electric current of 200 mA to a load of 2kQ. When the load changed to 500, the load current will be 0700mA O8A O12A

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter7: Electricity

Section: Chapter Questions

Problem 13P

See similar textbooks

Related questions

Q: Calculate the rate of the flashlight’s energy consumption. Suppose a flashlight has 6.8 × 102 C…

A: Given data: Charge (q) = 6.8×102 C Time (t) = 0.35 h Voltage (V) = 3.00 V Required: Power (P)

Q: 3. If two different wires having identical cross-sectional areas carry the same current, will the…

A: The average velocity due to electric field that an electron attains in a material is known as drift…

Q: The radius of 22-gauge Nichrome wire is 0.32 mm.(A) Calculate the resistance per unit length of this…

Q: 3. If a current drawn by a circuit with a resistance of 4.3 kN doubles when you halve the…

Q: QUESTION 9 A solar panel measures 80 cm x 57 cm. In direct sunlight, the panel delivers 3.1 A at 15…

A: Given,

Q: 3. A battery is used to supply current to a resistor. Assume the voltage drop across any wires used…

Q: A 3.5-kn resistor is connected across a D cell battery (1.5 V). What is the current through the…

A: Given data: Resistance (R) = 3.5 kΩ Voltage (V) = 1.5 V Required: Current (I) in mA

Q: 8) Wire is wrapped around the equator of an Earth globe of radius 15cm, making ten complete trips.…

Q: 3. A 60 W electric bulb is connected to a 120 V power line. What is the magnitude of current passing…

A: Hi, you have posted multiple questions without specifying which question to be solved so we will…

Q: 1. A 1000 W television was used to watch BTS concert for1 hour and 30 minutes. How much energy is…

Q: Date: A wire 50 m long and 1 mm in radius is connected to a battery 9.11 V with a current of 36 A.…

A: Given data: Length of the wire l =50 m Radius r =1 mm Battery voltage V =9.11V Current I =36 A

Q: 1. A wire 50 m long and 1 mm in radius is connected to a battery 9.11 V with a current of 36 A.…

Q: Problem 1: A power source supplies a prescribed voltage and is used to power a light bulb. If…

A: Required :: How would current affect if another light bulb is connected in series.

Q: 11. Consider a wire with conduction electron density 5.9 x 1028 5. If the diameter of the wire is…

Q: QUESTION 3 Which of the following is true for this BJT circuit? 6V The base-emitter and…

A: Option C is the right answer

Q: 2. What is the equivalent resistance of ttwo NOn resistars and one 5n resistor connected n 4.)…

A: Given: Resistance, R1 = 10 ohm Resistance, R2 = 10 ohm Resistance, R3 = 5 ohm Voltage source, V = 50…

Q: Suppose that each headlight of a car uses 3A and that the driver accidentally left the headlights…

A: Given: Voltage, V=12 V Each headlight uses current, I=3A The battery has rated 80 Ah it means it can…

Q: 6. A light bulb having resistance of 100 draws 200Ma current form a battery. a) Find the voltage…

Q: Question #4. Given a conductive wire of length L = 1 meter and diameter d = 0.32mm, what will be its…

A: Resistivity is a property of the material. It doesn't depend upon the geometry of the wire.

Q: In 2.0 s, 6.25 x 1018 electrons pass through a given point. How much current passes through this…

A: Given information: The number of electrons pass through the point (n) = 6.25×1018 The time taken…

Q: 3. Determine the currents I. k and h in the branches of the network shown in the figure, arbitrarily…

Q: 5. A constant current source supplies a electric current of 200 mÃ to a load of 2kN. When the load…

A: Write the given values with the suitable variables. I1=200 mA=200×10-3 AR1=2 kΩ=2×103 ΩR2=50 Ω

Q: 4.) The SMSAT automotive team is assembling a car for the school, and they are trying to work with…

A: We know, Power, P = V I where, P is power, V is voltage and I is current. I = P/V I = 50W/ 24 V =…

Q: 3. a) Calculate the resistance per unit length of an iron wire, which has a radius of 1.5 mm. The…

Q: 4. Which wire will produce a dimmer bulb? 5. Which wire offers greater resistance to current flow?…

A: AWG wiresize (solid) Resistance per1000 m (ohms) 12 5.21 18 20.9 Since Resistance per…

Q: Electrons in an X-ray tube are accelerated through 1.00×102 kV and directed toward a target to…

Q: Problem 2: Suppose you have a 2.2 cm diameter rod of pure silicon that is 22 cm long. > A What…

A: Given: The length of the wire is 22 cm. The diameter of the wire is 2.2 cm. The resistivity of the…

Q: 2. A 200-km-long high-voltage transmission line 2 cm in diameter caries a steady current of 1000 A.…

Q: 3. Smartphone chargers are usually labeled with their current output in A (amps). Suppose your…

A: Let us take a standard Q as battery capacity in mAh, I1 be the current rating of charger, and V be…

Q: What is the resistance of an immersion heater that increases the temperature of 1.0 kg of water from…

Q: A particular electronic-code lock provides over 500 billion combinations. Moreover, it can sustain…

Q: What would be the direction of conventional current if the coil of wire is connected in a battery?…

Q: 5. A constant current source supplies a electric current of 200 mA to a load of 2kO, When the load…

Q: 4. If you change the resistivity of the resistor, is the effect like changing the length or changing…

A: Solution: The resistance of any resistor is directly proportional to length and inversely…

Q: 4. A small but measurable current of 123 pA exists in a copper wire whose diameter is 2.46 mm.…

A: Current density is given by J=I/A Drift speed is v=J/ne, where n is electron density (electrons per…

Q: 2) A capacitor of 2 MF with an initial charge of Qo= loC IS connected OCTOSS 100 ohms resistor at…

Q: 4. The Voltmeter connected across load (Bulb) will measure [Choose any one answer] Potential…

A: Voltmeter connected in parallel to circuit and it measure potential difference.

Q: A0.460-mm-diameter silver wire carries a 10.0 mA current. Part A What is the electric field in the…

A: Given: The diameter of the wire is 0.46 mm. The current in the wire is 10 mA.

Q: A 120 V power line is protected by a 15 A fuse.What is the maximum number of 500 W lamps that can be…

A: The power consumed by the resistance, P = V × I Where, V = voltage I = current

Q: Problem 1: Suppose you have an extension cord having a resistance of 0.065 Q. Part (a) Find the…

A: Given data: Resistance of an extension cord (R) = 0.065 Ω Current flow through the cord (I) = 5.4 A…

Q: 11) A power of 0.5 W a certain resistor dissipates, when connected to a 3 V potential difference.…

Q: General Physics Module Phys 1011 AAU 4. Batteries are rated in terms of ampere - hours (A .h). For…

Question

4. The Voltmeter connected across load (Bulb) will measure [Choose any one answer]
Potential Difference +
5. A constant current source supplies a electric current of 200 mA to a load of 2kn. When the load changed to 500, the load current will be
O700mA
O8A
O12A
O9mA
6. To measure A.C voltage the knob should be at

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Question 4

VIEW

Question 5

VIEW

Message from expert

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?
(a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss the difficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P=I2 RP = .)
A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a 100,00- resistor, a switch, and a 6.00-V voltage source, (a) What is the RC time constant of the circuit? (b) What is the initial current through the circuit, when the switch is closed? (c) How long does it take the current to reach one third of its initial value?
. An electric car is being designed to have an average power output of 4,000 W for 2 h before needing to be recharged. (Assume there is no wasted energy.) (a) How much energy would be stored in the charged batteries? (b) The batteries operate on 30 V. What would the current be when they are operating at 4,000 W? (c) To be able to recharge the batteries in 1 h, how much power would have to be supplied to them?
Unreasonable Results (a) What current is needed to transmit 1.00 102 MW of power at 10.0kV? (b) Find the resistance of 1.00 km of wire that would cause a 0.0100% power loss. (c) What is the diameter of a 1.00-km-long copper wire having this resistance? (d) What is unreasonable about these results? (e) Which assumptions are unreasonable, or which premises are inconsistent?
If electrical energy costs 0.12 per kilowatt-hour, how much does it cost to (a) burn a 100-W lightbulb for 24 h? (b) Operate an electric oven for 5.0 h if it carries a current of 20.0 A at 220 V?
Unreasonable Results (a) To what temperature must you raise a resistor made of constantan to double its resistance, assuming a constant temperature coefficient of resistivity? (b) To cut it in half? (c) What is unreasonable about these results? (d) Which assumptions are unreasonable, or which premises are inconsistent?
Unreasonable Results A 1.58-V alkaline cell with a 0.200- internal resistance is supplying 8.50 A to a load, {a) What is its terminal voltage? (b) What is the value of the load resistance? (c) What is unreasonable about these results? (d) Which assumptions are unreasonable or inconsistent?
A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V. (a) What average current does the phone draw from its battery? (b) Calculate the energy stored in a fully charged battery if the phone requires charging after 5.00 hours of use.
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.