A hydropower station has a gross head of 14.4 meter Head loss in water conductor system is 0.5 meters generates a power of 16.5 MW.Calculate the optimum discharge in cubic meters per second considering the efficiency of c) 85 %d) 87 %e) 92 %

Answered: Image /qna-images/answer/431d255d-9ada-4d24-8775-e66e22a3ba66.jpg

Answered: c) 85 % d) 87 % e) 92 %

Engineering

Electrical Engineering

c) 85 % d) 87 % e) 92 %

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: 4. The unbonded strain gauge accelerometer of Figure P4 natural frequency of 175 Hz and an input ran...

A: Given data is- Maximum current I=50 mAGauge FactorGF=2.1Resistance R=120 ΩLength at zero acceleratio...

Q: Two impedances Z=2+j4 and Z= R+j0, are connected in parallel. Determine R so that the pf of the circ...

Q: 0- Find current in 3 ohm resistance by Thevenin's Theorem then by mesh theorem 09. -30 V 5 A 20 30 2...

A: SOLUTION:- Mesh analysis, 6i1+30 =0i1 =-306 = -5Aloop (2),-30+2(i2-i3)+2i2 = 04i2-2i3...

Q: 6/0° A j2 N 6Ω I, j4 Q 30/30° V 8Ω Find I, in Fig. using mesh analysis. Answer: 3.582/65.45° A. ll

Q: i) Discuss the effect of a series circuit as an unloaded voltage divider, when it is loaded ...

A: Loaded circuit- A circuit which is applied to the load in which the power consumed is known as loade...

Q: In a series-parallel circuit, the two parallel branches A and B are in series with C. The impedances...

Q: Answer the following questions (a)What is a clock signal? (b)Differentiate between positive going p...

A: 1) A clock signal oscillates between high and low states in electronics, particularly synchronous di...

Q: Find the voltage across 10-ohm resistor. 10ix 12 Ω 15Ω 4Ω 8Ω ix 6Ω V 102 10Ω 12 V 24 V

Q: What is the largest resistance multimeter can measure?

A: Multi meter- A multi meter is an electronic instrument for measuring voltage, current, and resistan...

Q: 3. Refer to the circuit shown C 120V, 60HZ Z = 10+j12 2 (a)What is the power factor? (b) What is the...

Q: DETERMINE ETH,RTH,IB,IC,IE,VB,VC,VE ,VCE

A: In this question, We need to determine the Thevenin voltage Eth , Rth , collector current, emitte...

Q: 5. Find Io in the circuit of Fig. 1.33. ww 1, -j22 j6 2 ww 60-30° V 10Ω Fig. 1.33

A: This question belongs to circuit theory . It is based on the concept of calculation of equivalent im...

Q: Problem 1 What elevation or height of a column of mercury will cause a pressure of 667.08 kPag?

A: Given, Gauge pressure (Pg) = 667.08kPag i.e kilo Pascal gauge

Q: d paper. Show your complete solution. Find the Thevenin equivalent at terminals a-b of the circuit i...

Q: a) Design an NMOC inverter with a resistive load (Find the value of R and W/L) for VDD = 5 V and P =...

A: Given the circuit, as shown below: a) We need to design an NMOS inverter with a resistive load for ...

Q: 5ix 15 kQ 20 kQ + vị- 8 mA 10 kQ (+- 60 V

A: By applying KCL we get the required solution. Kirchoff current law states that sum of incoming curre...

Q: A 633.0 nm laser was aimed at 33.0° toward a 25 mm grating. The first order defracted laser light wa...

Q: Find the voltage across 10-ohm resistor. * 10ix 12 2 15Ω 4Ω 82 ix 6Ω 10Ω 12 V 24 V 1 V O 0.1 V 0.7 V...

A: Consider the given circuit,

Q: assume an operational amplifier is working on inverting amplifier in which it takes input resistance...

A: Given

Q: Determine the efficiency of a 1,500 kVA, 2,300 V, 3 phase, Y-connected alternator which operates at ...

A: Efficiency = output power / input power Input power = output power + losses Losses= copper losses + ...

Q: R3 = 1.5 k2 moa R1 = 1 kN R2 3 kN Vs= 12 V 2 mA o b

Q: Which one of the following equations is correct? The mesh at which each equation might be derived is...

A: While applying mesh-analysis in a loop, we take (+) sign while moving from - to + terminal of a batt...

Q: 3. Which color represents digit 7 in resistor color code? 4. Determine the value of a resistor which...

Q: OR gate with a small circle on the output

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 A B R1 R3 R5 10 V1 12 R...

Q: Explain the working of Moving iron Attraction type of Instrument with a neat diagram Explain the sig...

Q: . What are the possible energy losses in the building you are reciting now? List them, explain and d...

Q: What is your understanding about capacitors and inductors at steady state.

Q: Find the bandwidth and center frequency of the bandstop filter of the figure. Round your answer to t...

A: Circuit diagram is given as, Calculation of Rth Rth=8+3=11 Ω

Q: What value of resistance should be placed in parallel with a 50 microfarad capacitor in order to hav...

Q: To detect a fire in a room, 3 (three) smoke detectors are used. If only one detector is active, the ...

A: Given, if only one detector is active, the fire alarm remains inactive. The new alarm becomes active...

Q: b) Evaluate , y dx dy where R is the region bounded by the parabola y2 4x and x? = 4y. %3D

A: It is given that: I=∫∫RydxdyRegion bounded by parabolay2=4xx2=4y

Q: 37. Find the voltage V and the current through each indue in the circuit of Fig. 12.91. 20Ω 3Ω. 50 V...

Q: If R, has twice the value of R2 and R2 has three times the value of R3, what would b voltage Vx in v...

Q: Given tree impedances: zl = 10 + j0, Z2= 3 + j4 and Z3 = 8 – j6. Impedances Z2 and Z3 are connected ...

Q: -j2 2 j6 2 +. 40 /30° V V, 4) 5/0° A 3Ω 10 Ω Determine voltage Vx.

Q: A coil having a resistance of 30 ohms and an inductance L is connected in parallel with a resistor h...

Q: 11 To increase the voltage in the system, :the modules are connected in (ähäi 2) .Series .Parallel

A: Given, To increase the voltage of the system, the modules are connected in ____.

Q: 1 Obtain C(0.5), C(1.5) and C(2.5) under unit impulse input using the modified z-transform. (T=1) R(...

A: The block diagram is shown below,

Q: A load of 120 MW at a power factor of 0.8 lagging can be delivered by a 3-phase transmission line. T...

A: per phase power =3 phase power 3Given 3 phase power = 120 MWso per phase power = 1203 = 40 MWPer ph...

Q: The x (t) signal is given in the picture. Plot the signal y(t) = x(−2t − 2).

Q: Calculate the value of R shown in Figure 1 if the power supplying the source voltage Vs is 120W ZA 1...

Q: Find the electric field intensity needed to balance the earth’s gravitational attraction on an elec...

Q: Demorgan's (B + C) 3. SOP truth table А В | С АВ | ВС BC X 000 0 0 1 1 1 1 1 0 0 1 1 1 1 1 1 1

Q: I'm having a difficulty in understanding this Design of Armature (Stator) of AC GENERATOR. PL...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: The armature winding of a 4-pole, 250 V d.c. shunt motor is lap connected. There are 120 slots, each...

A: Here, we have an armature winding. The slots and conductors are defined. The current taken by the mo...

Q: j162 j40 2g j40 2 24 2 DO V/30 キーji2 j4 2 =-0 -j10 2= j9 2 10Ω 32 82 ee

Q: The magnetic flux density in a region of free space is given as B= 6xax -9yay + 3zaz T. the force on...

A: Force F = integral (Idl×B) Where B is the flux density in the region.

Q: Q3 Given z,=(3+j4)² and z,= 2.5jej40x a. Find z¡+Z2 b. Find the magnitude and phase of z,z2

A: Given Z1=(3+j4)2 Z2=2.5ej40π

Q: 60 V 10 N 20 N ww 16 N

Concept explainers

Spherical Coordinate System

The spherical coordinate system is a three-dimensional coordinate system for space where the position of a point is specified by three numbers- the radial distance of that point from a fixed source, its polar angle measured from a certain zenith, and the azimuth angle. Its orthogonal projection on the reference plane passes through the source and is measured from the direction of constant reference on that plane which is orthogonal to the highest level. It can be viewed as a three-dimensional version of the polar coordinate system.

Question

A hydropower station has a gross head of 14.4 meter Head loss in water conductor system is 0.5 meters generates a power of 16.5 MW.
Calculate the optimum discharge in cubic meters per second considering the efficiency of

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
In a 33 kV overhead line, there are 3 units in the string of insulators. If the capacitance between each insulator to pin and earth is 9% of self-capacitance of each insulator. Find distribution of voltage over three insulators and string efficiency.
Short term and long term effects of wind energy on power system
Sun of currents
A generator operating at 50 Hz delivers 1 p.u. power to an infinite bus through a transmission circuit in which resistance is ignored. A fault takes place reducing the maximum power transferable to 0.5 p.u. Where as before the fault, this power was 2.5 p.u. and after the clearance of the fault, it is 2 p.u. The value of 8 is max
50. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the following: a. Ohmic value of the resistor b. Capacitive reactance E. capacitance in microfarad
a) Explain briefly how electricity can be sold to a grid by use solar energy. b) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20 MW for farm as a whole, in year 2020, the farm produced a total energy 43416MWH, find a capacity factor.
Discuss thr impact of wind energy on power system
Solve for the following Requirements Load Voltages Line Currents Source Complex Power
A single-phase energy meter having meter constant of 200 rev/kWh is operating on 230V, 50 Hz supply with a load of 10A and at unity power factor for three hours continuously. The number of revolutions shown by the meter during this period is
A resistor, in series with a 138-microfarad capacitor, is connected to a 60-cycle source.If the voltage drop across the capacitor is 115 volts and the power taken by the circuitis 922 watts, calculate (a) the circuit current, (b) the ohmic value of the resistor, (c) theline voltage, (d) the circuit power factor. draw the circuit diagram
(b) An inductive load consisting of resistor, R and inductor, L in series feeding from a 240430° Vrms, 50 Hz supply consumes 6 kW at lagging power factor of 0.88. (i) Determine the current through the load. (ii) Find R and L. (iii) Draw the phasor diagram of supply voltage and current.