Cross Section k2,5m 6 m- | A75m 1ス5m Determine the Bending Stress at Sectlon D-D

Q: 1. The cross section of a continuous one way slab in a building is shown in the figure. The slabs ar...

A:

Q: 34. The plastic limit and liquid limit of a soil are 36% and 54% respectively. The percentage volume...

A:

Q: W18 x 46 of A992 steel with Fy= 345 MPa and Fu= 450 MPa is connected to a plate at each flange hown....

A: Given:- Fy=345MPa Fu=450MPa W18x46 A992 steel To find:- a)effective net area b) allowable strength  

Q: 20KN 20KNE 50m2

A:

Q: A swimming pool has a width of 4 m and a side profile as shown. Determine the location of the center...

A:

Q: When a vehicle that is presented for inspection will not fit in the building because it is too tall,...

A: A sticker obtained from either the Department of Motor Vehicles through an authorized inspection cen...

Q: in the World water balance done by UNESCO 1975, what is the percentage of polar ice in term of perce...

A: Fresh water is the water that is used for drinking and other daily use purposes.  Most of the freshw...

Q: 8 kN 4 kN ID B 3 m 3 m -3 m

A:

Q: 5. A steel punch can be worked to a compressive stress of 800 MPa. Find the least diameter of hole w...

A: To determine least diameter of the hole that can be punched for the given steel plate.   Given, Allo...

Q: bearings of six lines radiating from a S88°52'W a) AB, N43° 24'E b) AC, N78°53'W. c) AD, S64° 42'E d...

A:

Q: Describe both interior angle method and bearing methods in traversing using a theodolite.

A:

Q: A contract can be terminated during the construction of a project. There are a variety of reasons fo...

A: To Explain:  Three types of termination of contract which impact the cycle of project and consequenc...

Q: A dam is designed for a return period of (30) years. It will require (5) years to complete the const...

A:

Q: The force F acts on the gripper of the robot arm. The moments of F about points A and B are 210 N m ...

A: Given:- The force F acts on the gripper of the robot arm The moment of the force F about point A = 2...

Q: Problem 2. You are tasked with constructing a rolled fill with a total volume of 35,000 m^3. The bor...

A: Given data: Required volume of fill =35000 m3 Borrow pit properties: w=15%γ=19.1 kN/m3Gs=2.75 Fillin...

Q: Given an evapotranspiration rate of 5 mm day-1, what is the corresponding amount of water lost to th...

A: Rate of evapotranspiration = 5 mm/day  area of land = A = 5× 104 number of hour in water lost = 60 h...

Q: Determine support reaction

A:

Q: A soil sample in its natural state has, when fully saturated, a water content of 32.5%. Specific gra...

A: Please refer the attached image for complete solution. THANK YOU.

Q: V. R 6R Liner velacity distribution V. V. V.

A: If an obstruction is placed normal to the direction of flow. The flow strikes the object straight an...

Q: 1. Determine the stiffness matrix K for the assembly. Take A-300 mm2 and E-200 GPa for each member. ...

A:

Q: right

A:

Q: is performed in a simply-supported reinforced concrete beam, it yields the  following values of un-f...

A: Given:- Floor Dead Load = 80 kN, Floor Live Load = 10 kN/m, Wind Load = 60 kN, and Earthquake Load =...

Q: Problem no. 2 Determine the displacement at C. USE: E = 29X103 ksi, I = 1200in4.

A: Given: E= 29 *10 3 ksi, I = 1200 in4 To Find: Displacement at C using moment area method

Q: The isohyets for annual rainfall over a catchment basin were drawn. The area of strips between the i...

A: Given data,

Q: Summative Assessment - Geometric Method Determine the Deflection at D. Use the Any Geometric Method ...

A:

Q: Determine The buoyant force acting on the heavier sphere in kN 2. The tension in the rope in kN 3. T...

A:

Q: as a horizontal base 3 ft. long and 2 ft. below the water surface. The vertex of the gate is 4 ft. b...

A: Pressure at bottom is :P=γw2+4=62.46=374.4lbft2Centroid =2+234=4.6667ftso,Total pressure force :FP=γ...

Q: State the principles of proportionality and superposition in developing unit hydrograph.

A: A hydrograph is a graph or plot that depicts the rate of water flow as a function of time at a speci...

Q: 15 15 430 y- -y 15 100 All dimension in mm N- N

A:

Q: 1. Discuss the difference between the experimental and computational member forces.    2. How can ...

A:

Q: A WT 8x13 of A992 steel is used as a tension member. The connection is with 7/8-in. diameter bolts a...

A:

Q: The

A:

Q: Assuming the section is uncracked, Compute the cracking moment in KN.m.

A:

Q: Two concentrated loads of 100 kN and 200 kN advance along a girder with a 20-metre  span, the distan...

A:

Q: Sieve Size Sieve opening (mm) Percent Finer 3 in. 76.2 100% 2 in. 50.8 90% 1 in. 25.4 80% #4 4.75 75...

A: Given the sieve sizes and percentage finer soil in those sieves.

Q: Megajaya Sein. Bhd. is a consulting company specialized in analyzing and designing bridges in Alar ...

A:

Q: Imperfections in solids, are they good or bad? Why?

A: Solution: When there is an availability of irregularity in the structure pattern of crystal arrangem...

Q: The average water surface area in a reservoir is 5000ha, calculate the water surface elevation in me...

A: As per water balance Equation ∑Inflow - ∑Outflow = Change in Storage Final elevation = Initial Eleva...

Q: normal

A: Given data - Load (F) = 20kN Area(A) = 50 m² Normal stress(P) =?

Q: W = 1100kg/m^3 Weight of beam AC = 0.08 kN/m Find the following: 1. Internal loads at point A in kN....

A:

Q: Find the approximate height of water upstream of the dam or the headwater in meters, such that an ai...

A:

Q: A rectangular gate 1.6 m wide is used as a partition as shown. One side has linseed oil filled to a ...

A:

Q: Determine support reaction

A: To determine the support reactions.   We can determine the reactions at supports A and B by drawing ...

Q: Q4) From the following data, calculate the average rainfall over the area: Isohyet (mm) Average 25 A...

A:

Q: Situation 9: A beam is loaded as shown in the figure. Its cross-sectional properties are also given....

A:

Q: Reinforce Concrete: A rectangular isolated beam has a clear span of 8.0m and carries a service live ...

A: Given: The clear span of the beam is 8.0 m. The service load is 60 kN/m The self weight is 15 kN/m T...

Q: a) Suitable cements are necessary for concreting operations in the building of massive pile caps for...

A: Suitable cement is necessary for concreting operations in the building of massive pile caps for a hi...

Q: The diameter of the tube is 3.020mm. The surface tension of water at 20°C is equal to 0.070, For a w...

A:

Q: How many board feet are contained in a piece of lumber measuring 6" x 6" x 16"?

A:

Q: High-rise buildings such as skyscrapers require a sophisticated elevator system to avoid congestion ...

A:

Steel Framing

A steel frame consists of a skeleton frame structure comprising of horizontal I-beams and vertical steel columns fitted in a rectangular grid building construction to brace the floors, walls, and the roof of the building held onto the frame. Due to the implementation of this methodology, the construction of the skyscrapers was feasible.