Draw the directed linear graph of the systems, plot the normal tree, and obtain the equations of state in standard A-matrix form.

Q: 29 Design a circuit based on the topology of the non-inverting amplifier, using only 10ks resistors,…

A: The output of an inverting amplifier is out of phase with the input signal, whereas the output of a…

Q: A power system has 200 buses including 40 generator buses. For the load flow analysis using…

A: Given data, Total number of busbar n = 200. Number of generators = 40.

Q: 5 = 14 2k 3k 4k 13 A a) habel b) KVL 8. c) KCh d) Set of equations

A: All the loop currents and node voltage s are labled.

Q: Q.1 The fundamental period of the signal x(t) = 10cos2 (10nt) is A. To = 0.5 B. To = 0.2 C. No…

A: Introduction: The fundamental period of a…

Q: You are an electronic engineer who is working on the design, production and implementation of…

A: The one bit full adder can be designed based on the truth table and the simplified Boolean…

Q: The following time diagram corresponds to: Clock D(input) Q(output) Select one: O a. Positive edge…

A: Given timing diagram is  We need to identify the element that gives the output Q(output) for the…

Q: The dimensional equivalence of the quantity "momentum OMIT! Ob-ML²T2 OCMLT the fundamental…

A: Momentum is given by formula, Momentum = Mass×Velocity.

Q: Let X(jo) be the Fourier transform of x(t), where [w, X(jw) = 1. Find the energy and the power of…

A:

Q: 2. A linear, time invariant system has an impulse response h(t)=u(t). Determine the output of the…

A:

Q: Complete the timing diagrams to document the behavior of a D-latch and a D-flip-flop.

A: The latch is a device that changes its output during the level trigger of the clock whereas the…

Q: Is there a list of potential problems that might occur with various forms of electronic…

A: Electronic communication: Electronic communication refers to any type of communication that is…

Q: A power system has 200 buses including 40 generator buses. For the load flow analysis using…

A: One of the fundamental power system studies performed at the stage of power system planning, design,…

Q: Problem 2. Calculate the electric field between the plates of a 4.7 uF capacitor that are separated…

A: In this question We need to determine the electric field between the plates.  We know electric field…

Q: A 220 V, 60 Hz circuit draws a current of 11 A with a power factor of 0.8 lagging. Find the…

A:

Q: 84V 1252 www 259 32 21V

A:

Q: Q3. A large industrial plant receives 3-phase electric power from the local utility. The following…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: 84V 1252 BS2 392 www. 21V

A: When more than one source is present in the electrical network, the Superposition theorem is used.…

Q: Find the following: DC gain, inductor current ripple and output voltage ripple:   For DC-DC Buck…

A: Types of Basic DC-DC Converters Buck Converter Boost Converter Buck Boost Converter

Q: 1. Find out whether the following vector fields are solenoidal or conservative in nature. a) F = b)…

A: For field to be solenoidal, divergence must be zero. For field to be conservative, curl must be…

Q: the high pulse lasts 1.725 ms, what angle does the servo motor have? 1.120.3 degrees 2.130.5…

A:

Q: An alternator is supplying a load of 300 kW at 0.6 p.f. lagging. If the power factor is raised to…

A: Given data, An alternator is supplying a load of P=300 kW at pf cosϕ=0.6 lagging. The alternator…

Q: VI 12 OA₁ OA₂ + VOI R₁ R3² RG R₂ 102 R₁ m R₂ OA3 + R₂ FIGURE 2.20 Triple-op-amp instrumentation…

A:

Q: Determine R and X₁ given the following values of impedance. Z = 780 + j 350 R = 2 and XL = Z = 560…

A:

Q: Vs1 R₁ ia R3 ww ic R₂ You are correct. Your receipt no. is 157-2141 ? Submit Answer Incorrect. Tries…

A: Given data Vs1=127 VVs2=68 VR1=6 ΩR2=50 ΩR3=15 ΩR4=23 ΩR5=12 Ω We have to determine the value of the…

Q: 5V 2Ω P, 10Ω 5V 2Ω

A: Given data, Circuit diagram is given as,

Q: A three-phase, 17.32 kVA, 400-V star connected alternator is delivering rated load at 400 V and pf…

A:

Q: P4. The following data is read on the name plate of a three-phase cage induction motor: output power…

A:

Q: Part-A. Derive expressions for the system variables using differential equations Given the circuit…

A:

Q: Use the distrbutive law to wite : 4(6x-7)

A: Given expression is 4(6x-7) Distributive property over multiplication and subtraction. A(B-C) = A*B…

Q: P1. Determine the number of poles, the slip, and the frequency of the rotor currents at the rated…

A:

Q: The transfer function of a system is given by What is the DC gain of the system? Take b=0.5 G(s) =…

A: Given, The transfer function of a system, Gs=s+bs3+1+bs2+b-1s+1-b. And b=0.5.

Q: Find the Transfer Function of Lag Compensator of Given Figure.

A:

Q: 1 If 2 ohm resistor is connected across the open circuit terminal. Using Thevenin's and Norto…

A:

Q: A unity feedback system has the following G(s) G(s) = 2 s+3 Use the LaPlace Transform to calculate…

A: Given, A unity feedback system has, Gs=2s+3. Hs=1. Input is unit step function, rt=ut.

Q: Question 7 If you have a short series of diminishing pulses that go from ground to some positive…

A: Design an RC integrator circuit:

Q: A factory is supplied by a single-phase network of 220 V - 50 Hz. It contains in parallel: - 2…

A: As per the guidelines given to us, we can only provide the solution to the first three subparts of…

Q: (a) The control input is the elevator deflection angle u(t) = 8(t). Define the output as y(t) = 0…

A: Solution of question (1): The given linear time-invariant ODE is y...+0.74y..+0.92y=1.2u.+0.18u. The…

Q: (b) A 12 kVA, 1.1kV/110V single phase transformer is running at a primary RMS voltage of 1.1kV and…

A:

Q: A unity feedback system has the following G(s) 2 G(s) = 8+3 Use the LaPlace Transform to calculate…

A: Given , A unity feedback system has, Forward path transfer function, Gs=2s+3. Feedback transfer…

Q: 2. Evaluate the curl of the vector field at (π/2, 0, π/2). F =

A:

Q: 33. Obtain numerical values for the two mesh currents i, and is in the circuit shown in Fig. 4.61.…

A: Given data, Circuit diagram is given as,

Q: 20V 452 852 ↓3A 652

A: The Norton equivalent circuit is solved as shown below.

Q: An operator expects the system load to be constant for the next few hours at 360 MW. a) How many…

A: Given: In this question, the given details are, An operator expects the system load to be constant…

Q: 1. Suppose the input signal x(t) and the impulse response h(t) of a continuous-time LTI system are…

A: In this question We need to output signal y(t) of this system.  We are solving this problem using…

Q: Find the KCL EQUATIONS KVL equations and set of equat

A: Since you have posted the questions with multiple subpart and so we are supposed to answer 3…

Q: .: If the audio signal series (10, 19, 26, 31, 40, 6), calculate the SNR of a communication system…

A: To find SNR of a communication system:

Q: 10 V + 1Ω 10 V source power F + 7 A source power = 2 Ω www - 2011 10ΩΣ V2 + Copyright ©2015 Pearson…

A: In this question We need to determine the power across the 10V voltage source and current source 7A.…

Q: s it possible to have a 4-variable function f(w, x, y, z) that has more prime-implicants than…

A: No, it is not possible to have a 4-variable function f(w,x,y,z) that has more prime implicants more…

Q: 4. Draw the circuit structure of a TCR. By changing the firing angle of thyristors, how can we…

A:

Q: Q2/ For a source produces an equiprobable, symbols which has entropy 2.80735 bit per symbol, find…

A: Given: A discrete source with equi-probable symbols has entropy = 2.80735 bits/symbol, To find:…