Find the fluid force (in lb) on the vertical plate submerged in seawater (use 64 pounds per cubic foot for the weight density of seawater). 6 ft 3 ft 14ft1
Q: To test the heat transfer for the famous Goodyear blimp, a small-scale prototype is being tested in…
A: Given Data: Cylinder Diameter D = 1.2 m Cylinder Length L = 6 m Wind Velocity V = 6 miles/hr Wind…
Q: Solar collector 2 W₁ RAD 3 Turbine 4 Condenser Q
A:
Q: has A disk is into a fixed axis of rotation through its center as shown, and a cord wraps around it,…
A: (a) Write the given data. ω0=2.2 rad/sα=6.4 rad/s2 CCWr=1.52=0.75 m
Q: The sketch shows a flat plate aligned parallel to an incompressible airstream. Assume a velocity…
A: Given Data: flat plate aligned parallel to an incompressible airstream Find: Assume a velocity…
Q: Question 1: The density and associated percent crystallinity for two polypropylene materials are as…
A:
Q: 4) High humidity air is used conditioning of dough before baking. An air stream at 40 °C and 30%…
A: Given data, Initial air temperature, Ti = 40 °C Initial relative humidity of air, ∅i=30% Final…
Q: Which of the following statements is TRUE on the enforcement of IPRS? ОО O The accused infringer…
A: option a are -true. the acused have always chance to prove them that they are not committed and…
Q: In a convergent divergent passage normal shock wave forms in the divergent section. The entropy…
A: 1) After the shock wave the randomness of the molecules increases. 2) So, the velocity will increase…
Q: In the two-pipe system, water flows continuously from the inner pipe and air from the outer pipe…
A: Given: Pressure in both the inlet pipes are 1 bar and there is no changes in the pressure. At 1 bar…
Q: oes up the smoke stack and the remaining 82% is taken away by cooling water that is drawn from a…
A: Given-Information:- Power output = 800 MweThermal efficiencyηth = 31% To-Determine:- Flow rate of…
Q: Three blocks are connected by two cords, and are arranged as shown above. (The pulleys are…
A: Given: To find: Force P needed for block A to reach 16 ft/s in 2.5 seconds
Q: A small circuit board is fitted with a heat sink of a base of 4-cmx4-cm. The heat sink contains 20…
A:
Q: A metal cube of 0.1 m sides is being cooled down uniformly from 300°C to 30°C by placing it in cold…
A:
Q: Problem 2: Rod AB has a mass of 10-kg and a uniform cross-sectional area. The piston has a mass of…
A: Solution: Given Data: mAB=10 kgmp=15 kgN=500 rpmθ=60o To Find: Forces on pin A and pin B.
Q: A continuous and aligned fiber-reinforced composite is to be produced consisting of 33 vol% aramid…
A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…
Q: A heat machine and a pipe through which water flows at a flow rate of 0.05kg/s are in interaction.…
A: To find: Whether the statement made by the engineers are correct that is, if the power given to the…
Q: 1. 0 100 kN/m 3 100 KN 5 7 100 kN/m 10 ►x (m)
A:
Q: I need proper explanation previous one was not good. 1) Evaluate whether the following statement is…
A:
Q: 9-61. Determine the location y of the centroid for the beam's cross-sectional area. 15 mm 400 mm 15…
A: Given data:- Upper flange length=300 mm lower flange length =200 mm web length=400 mm thickness for…
Q: Figure Txy 1 of 1 σx LI
A: Given system,
Q: The engineering stress-strain curve below was obtained for a precipitation hardened Aluminum alloy.…
A: Given:
Q: = Consider a plane wall 100 mm thick and of thermal conductivity 120 W/m-K. Steady-state conditions…
A: Heat flux flowing in the material is defined as total heat transferred in the material per unit…
Q: A roadway sign weighs 5.3 kN and is supported by a structural pipe that has an outside diameter of…
A:
Q: 3-61E A long, solid cylinder of radius 2 ft hinged at point A is used as an automatic gate, as shown…
A:
Q: A drive shaft running at 2500 rpm has outer diameter of 60mm and inner diameter of 40mm. The…
A:
Q: A continuous and aligned fiber-reinforced composite is to be produced consisting of 33 vol% aramid…
A:
Q: The coefficient of kinetic friction between the 30-mm- diameter pin and the pulley is 0.25.…
A: (a) To find: The tension required to raise the load. Given: The radius of the pin is r=15 mm. The…
Q: Calculate the specific humidity if the relative humidity is 50% and the capacity of the air…
A:
Q: Heat is conducted through a material with a temperature gradient of – 9000 K/m. The conductivity of…
A: Given Temperature gradient dTdx = -9000 km Conductivity of the material k = 25 Wm.k Convective…
Q: (MO14) 4. Design a quick return mechanism with 270 cm stroke, time ratio of 3, fixed link length of…
A: Consider the given data, Crank length, s= 97.5cm Time ratio, t=3 Fixed link length, l=75cm Stroke,…
Q: 19 Under the assumption of very small motions and neglecting friction, determine the natural…
A:
Q: A system consists of 2 kg of carbon dioxide gas initially at state 1, where p₁ = 1 bar, T₁ = 300 K.…
A:
Q: for an It costs 10.2 per kwh to heat a home, the interior temperature of the home is 20°C, and the…
A: Given: Cost = 10.2 ¢ per kWh Interior temperature = 20 C Outside temperature = -10 C Area, A = 2 m2…
Q: Air is blown into the electronic parts of a computer from one opening by the fan, and air is…
A:
Q: Consider an AISI 304 stainless steel cylindrical rod with a diameter of 20 mm and a length of 100 mm…
A: According to question:- diameter of the rodd=20mmLength of the rodL=100mm=0.1mTemperature…
Q: THE DEAM LOAD SUPPORTS SHOWN. A CROSS SECTION THE REACTIONS AND "B" ARE 4001b/ft DETERMINE INTERNAL…
A:
Q: Compute the moments of inertia with respect to the X-X and Y-Y centroidal axes for the following…
A: Given: To find: Moment of inertia about centroidal axis
Q: Determine the % efficiency of the Rankine steam cycle heat engine if the steam enters the turbine as…
A: GivenP1=10MPaT1=450oCP2=160kPa saturated steam
Q: A 10-cm shaft rides in a 10.03-cm sleeve and 12-cm long, the clearance space (assumed to be uniform)…
A: Given Data- D=10cm d=10.03cm L=12cm Dynamic viscosity=0.11 Pa.S N=100rpm We have to find heat…
Q: Fundamental.7 deals with the equation of motion. The use of the equation of motion to solve this…
A: To find: The tension in the sting. Given: The initial position of the bob is θ1=0°. The final…
Q: 2. 8" X Y Y 6" -X
A:
Q: Required information A Diesel cycle has a compression ratio of 22 and begins its compression at 87…
A:
Q: A three-point bending test was performed on an aluminum oxide specimen having a circular cross…
A: Given data:- Material aluminum oxide For circular cross-section Radius (r)=5.6 mm fracture load…
Q: A traveling wave propagating down a long string has an equation of motion given by y(x,t) = 6 sin [7…
A: given y(x,t) = 6 sinπ43π-3.8t
Q: Suppose linear elastic spring is compressed 2cm from its at-rest position, and then the spring is…
A: Given data x1=2 cmx2=5 cmk=1800 N/cm Here, k is the spring constant. Now we have to find out the…
Q: A drum A, of mass 200 kg, external diameter 380 mm and radius of gyration 150 mm, rotates on…
A:
Q: The automobile has a weight 3.158-lb and travels forward at 8ft/s when it crashes into the wall and…
A:
Q: The components of an electronic system dissipating 150 W are located in a 5-ft-long horizontal duct…
A:
Q: For some given binary phase diagram, describe how you would: find the temperatures and compositions…
A: Given: For a binary phase diagram To find: Temperatures and compositions of all eutectic,…
Q: (M011) 1. Find the degrees of freedom of the following mechanisms. a. J Cam contact P Pin in slot
A:
Trending now
This is a popular solution!
Step by step
Solved in 4 steps with 1 images
- A man weighs 170 lb on the surface of the earth. Compute his weight in an airplane flying at an elevation of 28 000 ft.The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.Find the elevation h (km) where the weight of an object is one-tenth its weight on the surface of the earth.
- The flat surface shown is submerged vertically in water. Find the fluid force against the surface. The weight density of water is 62.4lb/ft'. -8 ft 8 ft 8 ft Enter the exact answer. F = i lbA rectangle 10 feet wide and 8 feet deep is submerged vertically in water with its upper edge lying in the surface. Find the force on one side of the surface using integration. The specific weight of water is 62.4 pound per cubic foot.lb The trough below contains a fluid with a specific weight of 54 ft ³ trapezoidal wall below. The measurements are given as follows: A = 3.4 feet B = 2 feet C = 4.9 feet Give your answer in pounds-force. 165 A B Find the total force on the
- The flat surface shown is submerged vertically in water. Find the fluid force against the surface. The weight density of water is 9810 N/m. 6m 5m 8m Enter the exact answer. F = %3DGiven that the weight density of water is 9810 N/m3, calculate the fluid force (in Newtons) on a rectangular 1.4m 1.4m flat plate submerged horizontally in water at a depth of 2m. Give your answer correct to two decimal places without the units.One cubic foot of glycerin has a mass of 2.44 slugs. Find its specific weight in (a)lb/ft3and in (b)kN/m3.
- 1. A beaker of circular cross section of radius 8 cm is filled with mercury up to a height of 6 cm. Find the force exerted by the mercury on the bottom of the beaker. The atmospheric pressure = 105 N m. Density of mercury - 13600 kg/m3 . Take g =101- A 60 cm square gate has its top edge 12 m below the water surface. It is on a 45 angle and its bottom edge is hinged as shown in Fig. What force P is needed to just open the gate and its Water location? Hinge 2- A tank containing water is shown in Fig. Calculate the total resultant force acting on side ABCD of the container and the location of the center of pressure. y = 62.4 Ib/ft3 Water -20 ft 3- Find the total pressure and position of center of pressure FREE WATER SURFACE on a triangular plate of base 2 m and height 3 m which is immersed in water in such a way that the plane of the plate makes an angle of 60 with the free surface of the water. The base of the plate is parallel to water surface and at a depth of 2.5 m from water surface. 4- The 200 kg, 5 m wide rectangular gate shown in Figure 05m is hinged at B and leans against the floor at A making an Water angle of 45° with the horizontal. The gate is to be opened 3m from its lower edge by applying a normal force at its…A semicircular plate of radius 5ft rests vertically on its diameter at the bottom of a pool filled with water to a depth of6ft. Assume that the water’s weight density is62.4lb/ft3.•Find the force exerted by the water against on side of the plate.