Match the stress value to the described soil stresses based on the stratified soil layers below:1.0 m, 1.5 mTH650 kN4-1.5 mNeutral Stress1.7 m2.8 mEffective Stress for Fat Clay2.1 mEffective Stress for Clayey SandAy 17.0 kN/m+y 185 kN/mY-19.0 kN/m²Figure 3y 19.2 kN/m¹Effective Stress for Sand Layers at the Top20m+--2.0m900 KN+Fine silty sandSMClayClayey sandSCFat clayCH 25.73 kN/m^240.27 kN/m^219.72 kN/m^264.75 kN/m^2<

Match the stress value to the described soil stresses based on the stratified soil layers below: 10m 1.5m 650 kN -15m Neutral Stress 1.7 m 2.8m Effective Stress for Fat Clay 21m Effective Stress for Clayey Sand y 17.0 kN/m' y 185 kN/m 7-19.0kN/m' 7-19.2 kN/m² Figure 3 Effective Stress for Sand Layers at the Top 20m 900 KN -2.0m Fine silty sand SM Clayey sand SC Fat clay CH

Match the stress value to the described soil stresses based on the stratified soil layers below: 10m 1.5m 650 kN -15m Neutral Stress 1.7 m 2.8m Effective Stress for Fat Clay 21m Effective Stress for Clayey Sand y 17.0 kN/m' y 185 kN/m 7-19.0kN/m' 7-19.2 kN/m² Figure 3 Effective Stress for Sand Layers at the Top 20m 900 KN -2.0m Fine silty sand SM Clayey sand SC Fat clay CH

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.24P

See similar textbooks

Similar questions

A particular soil failed under a major principal stress of 300 kN/m2 with a corresponding minor principal stress of 100 kN/m2. If for the same soil the minor principal stress has been 200kN/m2. Determine the failure angle in degree for Φ = 300.
Dry Sand H, Groundwater Table Clay Refer to the soil profile shown. Given H1 = 8.85 m., and H2 4.01 m If the ground water table rises by 2.19 meters, determine the change in effective stress (numerical value only, in kPa) at the bottom of the clay layer Properties of dry sand Gs = 2.51, e = 0.65 Properties of clay. Gs = 2.72, e = 0.84. Round off to two decimal places. Activate Windows Go to Settings to activate Windows. < Question 18 of 20 2 A Moving to another question will save this response. ASUS C8O CD 80 5n E R- T Y H]
Q: For the soil profile shown in figure. Determine: The effective stress (o') at level (A). Soil 1 k = 0.2 cm/sec Y sat = 19 kN/m³ Soil 2 k = 0.4 cm/sec Y sat = 21 kN/m³ Datum D EL + 2.0 m EL 0.0 m EL - 1.0 m EL - 4.0 m EL - 10.0 m
A soil profile is shown in figure below. Dry sand 6m Ydry = 16.5 kN/m³ B Groundwater table Saturated sand 13m Ysat = 19.25 kN/m² C Dry sand Saturated sand Clay Calculate the following: a. Effective stress at point A in kPa. b. Effective stress at point B in kPa. c. Effective stress at point C in kPa. 5.
Caculate the total, neutral and effective stress (kPa) at the base of each soil layer listed below. Assume the water table rest 4 m below ground surface and that there is a capillary rise of 1 m above the water table. Provide your answers in kPa to 1 decimal place. Use 9.81 kN/m3 as the unit weight of water. Total Neutral Effective Silty Sand: 5m thick, γt = 17.5 kN/m3, γsat = 18.5 kN/m3, Blank 1 Blank 2 Blank 3 Clay: 4m thick, γt = 16.5 kN/m3, γsat = 17.8 kN/m3, Blank 4 Blank 5 Blank 6 Sand: 6m thick, γt = 17.3 kN/m3, γsat = 18.1 kN/m3, Blank 7 Blank 8 Blank 9
surface layer QY A Soil profile consists of a surface of Line sand 6m thick with unit weight of 16-5 kN/m³ and clay layer of 8m thick beneth the Sand layer. the water table is located at adepth of 4m below the ground surface: submergend for line Sand is 10.4 kN/m², Gs love clay layer is 2.7 & wc %. = 30% Calculate the eflective stress at the middle of clay Layer. + 6m 4M DW.T Fine Sand 8m clay 8=165& M2 sub = 1o.y tw G3=2=7 w;. = 30%.
consolidated drained triaxial test was conducted on a granular soil. At failure (σ1^')/(σ3^' ) = 4.0. The effective minor principal stress at failure was 100 kN/m2. Compute angle of friction^' in degrees. a. 39 b. 41 c. 37 d. 35
B) For the soil profile shown in Fig. (2), determine 1- The effective and total stress at point A. 2- The effective and total stress at point B. 3- The effective and total stress at point C. Fig.2 5.0m 4.0 m 6.0 m Sand G=2.67 e 0.78, S,= 25% A.V Clay G=2.75 e=0.69 B Clay Ysat 19 kN/m²
Problem l: For Problem Number 30. A layered soil has the following data; H= 1.5 m k,= 10°cm/sec k2= 3.0 x 10°cm/sec H2= 2.5 m H3= 3.0 m k3= 3.5 x 10°cm/sec 30) Determine the ratio kH(eq)/K vleg). a) 36.80 b) 37.27 c) 35.40 d) 33.90
Plot the variation in the effective stress (o') for the given soil profile. Plot your answer here below. Gs = 2.65 e = 0.50 Gs = 2.65. 1.80 m 0.90 m Zone of Capiary Rise Gs= 2.65, e= 0.5 S= 45% Free Surface o = 42 % 1.80 m Gs = 2.71
7. A specimen of soil was collected from a depth of 10 m in a deposit of clay. The ground water table coincides with the ground surface. For the soil, LL = 65, PL = 33, and at 17.5kN/m³. Estimate the undrained shear strength Su of this clay for the following cases (a) If the clay is normally consolidated. (b) If the preconsolidation pressure is 210kN/m². (refer to Skempton's and Ladd et al.'s relations and Bjerrum's correction for undrained shear strength)
A soil profile, under surcharge load of 25 kN/m2 at ground level, consists of 6m sand and 3m clay layer. Ground water table is 2m below sand layer. Dry unit weight and saturated unit weight of sand is 15.80kN/m3 and 16.90kN/m3 respectively. Clay layer, Gs=2.67 and saturated unit weight is 18.80 kN/m3. Determine a)Increase in stress at the mid layer of clay b) With dewatering 2m, what is the stress increase at the mid layer of clay c) How much must the water level be lowered to me more effective than the surcharged load?