PROBLEM NO. 2 A Three-Phase Transmission Line has three conductors spaced equally at 2 meters apart. The radius of each conductor is 0.54 cm. Calculate the Inductance in Henry per meter. Write your Final Answer with correct Engineering Notation and SI UNIT.

PROBLEM NO. 2 A Three-Phase Transmission Line has three conductors spaced equally at 2 meters apart. The radius of each conductor is 0.54 cm. Calculate the Inductance in Henry per meter. Write your Final Answer with correct Engineering Notation and SI UNIT.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.33P: Consider the three single-phase two-winding transformers shown in Figure 3.37. The high-voltage...

See similar textbooks

Related questions

Q: Q1 ▪ A small industrial plant has the following loads: ▪ Twenty (20), 200HP motors (only half of…

A: A Small Interatrial Plant:

Q: You are given the circuit shown below. Note that the connected to the + terminal of the capacitor…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: (i) Find the current in. (ii) Find the current iz (iii) Find the current is. (iv) Find the output…

A: The required parameters can be calculated by using the characteristics of ideal operational…

Q: For the circuit shown determine Vx V2 5V- R4 1k 11 0.02 A Vy

A: We need to find out the voltage across the resistor .

Q: Q7) A modem transmits a two dimensional signal (X,Y) given by: X = cos(2π0/8) and Y = sin(20/8)…

A: Disclaimer Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: a b c 000 1 001 1 010 0 011 1 100 1 101 0 110 0 0 F

A: The basic digital circuit is solved as shown below.

Q: In the laboratory, the diode has been tested on DC. and it conducts a current of 1mA at a voltage…

Q: QB) Draw the transmitter and receiver block diagrams of QAM.

Q: A electrical company provides power to a house at 220V AC and can supply up to 600A, for a maximum…

A: Given data: The resistance is R=0.02 Ω The voltage is 220 V

Q: D 라라라 Ip 42 OHỌ HO 19 2 b3 (sly sandu

Q: Consider the system defined by where x = Ax + Bu y = Cx A =1₁²₁9₁ B = [¹]₁ a) Test the…

A: Introduction Controllability and observability Controllability is the capacity of a control system…

Q: A. What is the advantages and disadvantages of using negative feedback? B. Why the bandwidth of the…

A: We need to explain the advantage and disadvantage, we need to explain bandwidth of op amp and slew…

Q: Determine the Fourier transform of the signal cos(2лfot). 1.3 Determine the Fourier transform of the…

Q: • Draw the circuit diagram to implement the expression x=(AC+BD+ER + FED)

Q: t Q4) Determine the total power to transmit an information signal with 15KHz for WBFM system when…

A: Given: Information signal frequency, fc=15 KHz, Bandwidth of WBFM signal = 120 KHz, Modulation…

Q: Determine i(t) for t >0 in the following circuit if is(t) = 5u(t) A. is 2Ω 8/29 H 1/8 F

A: In this question We need to determine the current in the inductor. We are solving this problem…

Q: Figure 2-32 Closed-loop system. R(S) Ge(s) Controller Gp(s) Plant D(s) C(s)

A: We need to find out the output due to both input.

Q: What resistance value would you have to change R2 to such that the net currents through R4 and R5…

Q: length of cross arm must be: a. decrease b. increase c. constant d. connected to ground e. Non of…

Q: A current divider consists of 10 resistors in parallel. Nine of them have equal resistances of 60…

Q: A crystal diode having internal resistance rf, = 20ohm is used for half-wave rectification. lf the…

A: Introduction Half-wave rectification Half-wave rectification is a method used in electrical…

Q: 4. If the spacing between the conductors of the transmission line is made to be large compared to…

Q: 2. (a) An ideal, zero-phase highpass filter has frequency response {} So, |w| س > we ,1 for n = 0…

A: Given: a) Frequency responses of High Pass filter as, Hhpω=0,ω<ωc1,ωc≤ω≤π, b) Frequency…

Q: 12 кг 10 кл (1) 6та Обка Озка J Io

Q: Show all complete solutions. An LTI continuous-time system has the frequency response function…

Q: What statement best describes the following signal: 1 13 2π -лt+ x(1) = }} sin -∞0 <1 < 00 33 A…

A: It is a sinusoidal signal with some phase deviation. Hence it is a : 1) Real signal 2)…

Q: IN QA QB TOF Time IN 15 PT Q ET QA IN 3s - PT TON Time Q ET- QB Time (s) Time Time (s)

A: For TON : When input IN is turned ON, elapsed time ET will start increasing by specified time -…

Q: 1. For the circuits shown below, if A=∞, Calculate a) The overall input resistance, Rin b) The…

A: An Electrical circuit and A=∞, To find: a) The overall input resistance, Rinb) The output…

Q: Problem 3. Find the transfer function, V₁(s)/V(s), for the electrical network shown in Figure 3,…

Q: A house and lot is on sale at a cash price of P 12.5 million. However a buyer has an option to buy…

A: A house Sale:

Q: An FM signal, 2000 sin(27x10t+2sinx10¹) is applied to a 5002 antenna. Determine the carrier…

A: Given, FM signal is S(t) = 2000 sin(2π×108t + 2 sin(π×104t)) This FM signal is applied to an…

Q: Consider the system defined by =42+61u 21-691 a) Test the controllability of the system. b) Test the…

Q: #5 Find the phasors V and I corresponding to (i) v(t) = 290 cos (377t-15°) V; i(t) = -8 sin (377t +…

Q: SOLVE STEP BY STEP IN DIGITAL FORMAT In the following exercise use the model of the ideal diode plus…

A: Given diode circuit as follows.

Q: a. b. C. d. 12/0° V j Find the Thevenin voltage, use mesh analysis to find VTH, clearly indicate the…

A: Since you have posted a question with multiple subparts, we will provide the solution only to the…

Q: 2. R1 302 Given the following circuit: V1 -2V (1) Mesh Analysis (2) Nodal Analysis (3) Superposition…

A: Given: The given circuit diagram is, To solve for the current through resistor R1 and the power…

Q: Activity 1: The following circuit uses two Zener diodes with reverse breakdown voltage of 5.1 V for…

A: Zener diode:

Q: 2. Consider the circuit shown in Fig 2, where i(t) = 0.03 cos (250t+ A 100 μF 20 Ω Figure 2: Circuit…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Consider the RLC circuit shown below; 1- write the state space description only. 2- Classify the RLC…

A: RLC Circuit:

Q: 2. Find the impedance Z₁ for maximum average power transfer and the value of the maximum average…

Q: c) Four diodes are used to construct a single phase full-wave bridge rectifier circuit which is…

Q: X(s)=(-5s-7)/((s+1)(s-1)(s+2)), -1<Re(s)<1 expression a) draw the zero-pole graph b) find the…

A: In this question We need to determine the inverse laplace transform and plot the graph. We know…

Q: Figure 6-118 Control system. B-6-28. Consider the system shown in Figure 6-118. As- suming that the…

Q: PLEASE STATE REASON AND SHOW YOUR WORK FOR ALL QUES- TIONS. 1. Consider the signal z(t) = 7…

A: Given, Signal is x(t) = 7 cos(2π10t - π/4) Reference signal is xo(t) = cos(2π10t) We need to…

Q: (a) Consider the circuit shown in Fig. 22(a). 10A 552 I Fig. 22(a) (i) Write down the node-voltage…

Q: Question 3 Consider a causal LTI system with impulse response h[n] and system function H(z) , D=1 (1…

Q: 2. Solve for the currents and voltages in each resistor in the schematic using Kirchoff's Laws. 18V…

A: In this question We need to determine the current and voltage in each resistor. We are solving this…

Q: A 200V long-shunt generator delivers 100A, has an armature resistance of 0.050, a series field…

Q: The switch in the following circuit has been closed for a long time and is opened at t = 0. Find…

Q: In a hydro-electric station the volume of water which can be utilized per annum is 5* 10m³ with a…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

PROBLEM NO. 2 A Three-Phase Transmission Line has three conductors spaced equally at 2 meters apart.
The radius of each conductor is 0.54 cm. Calculate the Inductance in Henry per meter. Write your Final
Answer with correct Engineering Notation and SI UNIT.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Schering Bridge is used to find ____________. a. capacitance b. pressure c. inductance d. frequency
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
Calculate the inductance per phase per meter for a three- phase double-circuit line whose phase conductors have a radius of 4.1 cm with the horizontal conductor arrangement as shown in Figure below A B A' C' B' 6m -6m 7 m 6m- 6m
Each conductor of a 3-0 overhead line is suspended from a cross arm of a steel tower by a string of 4 suspension insulators. The voltage across the third 33 kV. The shunt capacitance between each insulator and the earth is 1/8th of the capacitance of the insulator itself. Find the voltage across string and string efficiency. D-128 Lod Fa
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
Develop the mathematical relationships for the design of the inductance and capacitance of a three-phase double circuit line. A three-phase double circuit line consists of two identical three-phase parallel circuits as shown in the figure below. The circuits are operated with a1-a2, b1-b2, and c1-c2 in parallel.
Problem 1 - Series en Parallel AC networks [19] Look at the circuit in Figure 1 and determine the following: (a) Total Admittance. (b) Total Impedance. (c) Total Current (l:). (d) Current (I1) through impedance Z2. (e) Current (12) through impedance Z3. (f) Current (I3) through impedance Z4. (g) Is this an inductive or capacitive circuit? A. B Zs 220V;50HZ Figure 1 (h) Voltage across Z1. (i) Voltage across A and B. G) Voltage across Zs. Z1 = 3 + j5 ohm Z2 = 10 + jo ohm Z3 = 5 + j15 ohm Z4 = 10 – j30 ohm Zs = 20 – j30 ohm Admittance and Impedance in rectangular notation. All currents and voltage in polar notation. Take voltage as reference.
THREE-PHASE TRANSFORMERS
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit.
One advantages of load balancing is that each phase conductor carries the ? current value
#Three phase
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --