Shunt dc generator supplies 220 V at 90A .The resistance of Armature and shunt field winding are 0.04 and 110 ohm respectively.Assume the total brush drop is 2 V. Your answer the emf generated is. . O 215 V 220 V 225 V 230 V If An 4-pole lab wound dc generator has 120 slot at each 8 conductors per slot,flux is 0.03 Wb. the speed of dc machine is....

Shunt dc generator supplies 220 V at 90A .The resistance of Armature and shunt field winding are 0.04 and 110 ohm respectively.Assume the total brush drop is 2 V. Your answer the emf generated is. . O 215 V 220 V 225 V 230 V If An 4-pole lab wound dc generator has 120 slot at each 8 conductors per slot,flux is 0.03 Wb. the speed of dc machine is....

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The .. of the hysteresis loop is a measure of energy ..... lost per cycle a) area. b) Type. c) Frequency d) No one of the above. Fringing effect is a phenomena occurs in . a) Transformers. b) Electrical field. c) Air gap d) All of the above.
Fill in the following blanks:1. Lap winding is suitable for ……. Voltage, …… current d.c. generators.2. The critical resistance of the d.c. generator is the resistance of ……. .
A three-phase, 4-pole, 1,500 rpm alternating having a double layer-windings with 18 turns per coil. The slots per pole per phase are 10 and the coil span is 22 slots. The spread phase is 60 degrees and the flux per pole is 0.0625 Weber. If the armature windings are wye connected. a) Determine the generated voltage per phase and the line to line voltages. b) If the alternator is delivering a three - phase load of 1,200KW at 0.8 lagging power factor what is the line current of the alternator
A thicker wire is used in the DC series field winding than DC shunt field winding in DC machines. * O because it carries the load current. O to prevent mechanical vibrations. O to provide strength. O to produce large flux. The speed of a DC motor can be changed by varying - armature resistance circuit O flux per pole O voltage source O all of above
1. In a transformer, which options are correct:A. Works on Faraday’ law and Ampere’s lawB. DC current in the primary winding will produce voltage output in the secondary windingC. Copper losses are caused by reluctance in magnetic circuitD. Frequency of input power source will not govern the voltage induced in secondary circuit.2. Voltage ratio of input voltage and output voltage in IDEAL transformer depends on:A. Leakage fluxB. Magnetization currentC. Copper loss currentD. Turns ratio3. The core of transformer must have:
A small single-phase 60 Hz transformer has 10.2 W at no load. The core has a volume of 750 cm3. The maximum flux density is 10,000 G and the hysteresis constant of the core is 0.0005. Using the Steinmetz law on hysteresis loss, find the eddy current loss.
3 For a coil, each turn faces (2t4 – t³ – 2t) milliwebers of flux. The value of induced EMF in coil for 100 turns coil at 2 sec is, (in Volts).
The emf generated in each conductor of a 6-pole simplex wave armature winding is 0.48 V. If the armature has 42 slots and 125 commutator segments, and there are four turns per armature winding element, find the terminal voltage of the generator. a. 288 V b. 264 V c. 192 V d. 240 V
Question: A 4 Pole DC Generator Is Wounded Lap. It Rotates At 500rpm To Be Able... A 4 pole DC generator is wounded lap. it rotates at 500rpm to be able to generate 150 V of open circuit voltage. What is the percentage decrease in the exixting flux per pole if a frequency of 10 rps can produce 120 V? %.
There are 144 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors in each slot and all the conductors in a phase are connected in series. Coil span is 1500 electrical and the flux per pole is 0.05 Weber sinusoidallly distributed. Calculate the emf induced per phase.
A short shunt compound DC generator supplies a load of 10A at a voltage of 10 volts. If the resistances of Armature, shunt field and series field windings are 0.01 ohm, 1 ohm and 0.00 ohm respectively. c) write down the factors to improve the generated voltage. Generated Voltage is 10.2 V
7 A three-phase, 60-cycle, 32-pole synchronous generator has a sinusoidally distributed air-gap flux of 0.025 weber/pole. The armature core has 324 slots. The armature winding is Y-connected. There are two coil sides per slot and two turns per coil. The coil pitch is 9 slots. Find the generated voltage between the line terminals. Ans. 2,445 V