The addition of dimethylglyoxime, H2C4H602N2, to a solution containing nickel(Il) ion gives rise to a precipitate: Nickel dimethylglyoxime is a bulky precipitate that is inconvenient to manipulate in amounts greater than 135 mg. The amount of nickel in a type of permanent-magnet alloy ranges between 22% and 38%. Calculate the sample size that should not be exceeded when analyzing these alloys for nickel.

The addition of dimethylglyoxime, H2C4H602N2, to a solution containing nickel(Il) ion gives rise to a precipitate: Nickel dimethylglyoxime is a bulky precipitate that is inconvenient to manipulate in amounts greater than 135 mg. The amount of nickel in a type of permanent-magnet alloy ranges between 22% and 38%. Calculate the sample size that should not be exceeded when analyzing these alloys for nickel.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter12: Gravimetric Methods Of Analysis

Section: Chapter Questions

Problem 12.1QAP

See similar textbooks

Similar questions

GRAVIMETRIC ANALYSIS The addition of dimethylglyoxime, H2C4H602N2, to a solution containing nickel(Il) ion gives rise to a precipitate: Nickel dimethylglyoxime is a bulky precipitate that is inconvenient to manipulate in amounts greater than 135 mg. The amount of nickel in a type of permanent-magnet alloy ranges between 22% and 38%. Calculate the sample size that should not be exceeded when analyzing these alloys for a nickel.
A 0.3780-g copper (II) sulfate pentahydrate (CuSO4 5H2O, MM = 249.68 g/mol) is subjected to gravimetry in order to precipitate out the copper (II) iodate (Cu(IO3)2, MM = 413.351 g/mol). In order to produce the precipitate, potassium iodate (KIO3, MM = 214.001 g/mol) is needed to be added. To carry out the reaction, how much mass (in grams) of KIO3 is required?
Consider a solution that contains 0.10 M AsO43 and 0.15 M CO32. Solid Co(NO3)2 is added to separate these two anions. Ksp of Co3(AsO4)2 = 6.8 x 1029 and Ksp of COCO3 = 1.0 x 10 %3D 10 Assume the volume change is negligible. As solid Co(NO3)2 is added to this solution, which solid will precipitate first and what is the [Co2*] needed to maintain the maximum separation of AsO43 and CO32? COCO3 precipitates first and [Co2+]max = 9.1 x 10-7M COCO3 precipitates fırst and [Co2+]max = 1.9 x 10-9 M Co3(AsO4)2 precipitates first and [Co2+]max = 1.9 x 10-9 M None of these Co3(AsO4)2 precipitates first and [Co2*]max = 9.1 x 10-7M Co3(AsO4)2 precipitates first and [Co2*]max = 6.7 x 10-10 M COCO3 precipitates first and [Co2*]max = 6.7 x 10-10M
A 0.8000-g sample of iron ore containing 21.00% Fe is analyzed gravimetrically. If the final precipitate (assumed to be Fe,03) contains 20.0 mg of Al,O3 by mistake, what percentage of Fe does the analyst find?
Predict three (3) correct apparatus used for the procedures experiment run by a chemist below. Determination of phosphorus in plant food will produced magnesium ammonium phosphate, MgNH4PO4.6H2O, precipitate. The precipitate was kept in a crucible and dry at 130 °C for 2 hours. Then, the precipitate was cooled for 15 minutes in a condition of low moisture atmosphere. The precipitate is weighed until constant weight is obtained.
Hydroxyapatite, Ca₁(PO)(OH)₂, has a solubility constant of Ksp = 2.34 × 10-5⁹, and dissociates according to Ca₁0(PO4)(OH)₂ (s) = 10 Ca²¹(aq) + 6 PO³(aq) + 2 OH¯ (aq) Solid hydroxyapatite is dissolved in water to form a saturated solution. What is the concentration of Ca²+ in this solution if [OH ] is fixed at 5.90 × 10-4 M? [Ca²+] = M
1. 3M KOH is added to the precipitate and the tube is heated again. The solution is then centrifuged and the supernatant is separated from the precipitate. The precipitate is still brown-black, and the supernatant solution is yellow. The supernatant is acidified with HCI. thioacetamide is added and the solution is reheated. A yellow precipitate forms. A. Which cationts) is definitely present in the unknown? Select all answer cholces that apply. A. Cu2 B. None of these ions C. Sn4+ D. BO+
The literature value of the Ksp for calcium iodate is 6.47 × 10–6 at 25 °C. Use the following equation to calculate the percent error in your determination of the solubility product for calcium iodate. Note: Do not be alarmed if your average deviation is very large. This is not uncommon in Ksp experiments, even under the most careful conditions. Percent error = (|experimental value - literature value|)/ (literature value) X 100%
In an experiment to determine the concentration of H2SO4 in a brand of toilet cleanser, 10.0 cm3 of the cleanser was first diluted to 250.0 cm3 with distilled water. 25.0 cm3 of the diluted cleanser were titrated with 0.320 mol dm–3 NaOH solution, using methyl orange as indicator.If 29.2 cm3 of NaOH solution is used, what is the concentration of H2SO4 in the undiluted toilet cleanser?a. 2.30 mol dm–3b. 4.60 mol dm–3 c. 9.20 mol dm–3 d. 11.50 mol dm–3
Hydroxyapatite, Ca,(PO4),(OH)₂, has a solubility constant of Ksp = 2.34 x 10-59, and dissociates according to Cao (PO)(OH)₂ (s)10 Ca2 (aq) + 6PO (aq) + 2OH (aq) Solid hydroxyapatite is dissolved in water to form a saturated solution. What is the concentration of Ca2+ in this solution if [OH] is fixed at 3.40 x 10-4 M? [Ca²+] = M
Hydroxyapatite, Ca,(PO)(OH)₂, has a solubility constant of K-2.34 x 10-59, and dissociates according to Cao (PO)(OH)₂ (s) = 10 Ca² (aq) + 6PO (aq) + 2OH(aq) Solid hydroxyapatite is dissolved in water to form a saturated solution. What is the concentration of Ca²+ in this solution if JOH is fixed at 8.30 x 10M? |Ca²1 M
A chemist has a 50.0 mL sample of 0.010 M Na₂C₂O4 at 25 °C (solution A, oxalate ion = C₂04²-). An aqueous solution of Ca(NO3)2 with a volume of 50.0 mL (solution B) is added to solution A, at the same temperature. Above what minimum concentration must Ca(NO3)2 in solution B be, prior to mixing, to cause CaC₂O4 to precipitate given that for CaC₂O4, Ksp = 2.7 x 10-⁹ at 25 °C? Enter your answer with two significant figures, without units, and in millimolarity (mM) where: millimolarity = (molarity)(1000)