The Effect of Substrate Concentration, Enzyme Concentration, Ph and Temperature on Enzyme Activity”

In this lab or experiment, the aim was to determine the following factors of enzymes: (1) the effects of enzymes concentration the catalytic rate or the rate of the reaction, (2) the effects of pH on a particular enzyme, an enzyme known and referred throughout this experiment as ALP (alkaline phosphate enzyme) and lastly (3) the effects of various temperatures on the reaction or catalytic rate. Throughout the experiment 8 separate cuvettes and tubes are mixed with various solutions (labeled as tables 1,3 & 4 in the apparatus/materials sections of the lab) and tested for the effects of the factors mentioned above (concentration, pH and temperature). The tubes labeled 1-4 are tested for pH with pH paper and by spectrophotometer, cuvettes 1a-4a was tested for concentration and cuvettes labeled 1b-4b was tested for temperature in four different atmospheric conditions (4ºC, 23ºC, 32ºC and 60ºC) to see how the enzyme solution was affected by the various conditions. After carrying out the procedures the results showed that the experiment followed the theory for the most part, which is that all the factors work best at its optimum level. So, the optimum pH that the enzymes reacted at was a pH of 7 (neutral), the optimum temperature that the reactions occurs with the enzymes is a temperature of 4ºC or

This experiment looked at how substrate concentration can affect enzyme activity. In this case the substrate was hydrogen peroxide and the enzyme was catalase. Pieces of meat providing the catalase were added to increasing concentrations of hydrogen peroxide in order to measure the effect of hydrogen peroxide concentrations on the enzyme’s activity. The variable measured was oxygen produced, as water would be too difficult to measure with basic equipment.

In the experiment we used Turnip, Hydrogen Peroxide, Distilled Water, and Guaiacol as my substances. On the first activity, Effect of Enzyme concentration of Reaction Rate for low enzyme concentration, we tested three concentrations of the turnip extract, and hydrogen peroxide. For the Turnip Extract I used 0.5 ml, 1.0 ml, and 2.0 ml. For hydrogen peroxide we used 0.1 ml, 0.2 ml, and 0.4 ml. We used a control to see the standard, and used a control for each enzyme concentration used. The control contains turnip extract and the color reagent, Guaiacol. We prepared my substrate tubes separately from the enzyme tubes. My substrate tube

The use of multiple test tubes and Parafilm was used for each experiment. Catechol, potato juice, pH 7 phosphate buffer, and stock potato extract 1:1 will be used to conduct the following experiments: temperature effect on enzyme activity, the effect of pH on enzyme action, the effect of enzyme concentration, and the effect of substrate concentration on enzyme activity. For the temperature effect on enzyme activity, three test tube were filled with three ml of pH 7 phosphate buffer and each test tube was labels 1.5 degrees Celsius, 20 °C, and 60 °C. The first test tube was placed in an ice-water bath, the second test tube was left at room temperature, and the third test tube was placed in approximately 60°C of warm water. After filling the test tubes with three ml of the

Students will be observing normal catalase reaction, the effect of temperature on enzyme activity, and the effect of pH on enzyme activity in this experiment. The enzymes will all around perform better when exposed in room temperature than when it is exposed to hot and cold temperatures. This is based on the fact that the higher the temperature, the better the enzymes will perform, but as the temperature reaches a certain high degree, the enzymes will start to denature, or lose their function.

The role of an enzyme is to catalyse reactions within a cell. The enzyme present in a potato (Solanum Tuberosum) is catechol oxidase. In this experiment, the enzyme activity was tested under different temperature and pH conditions. The objective of this experiment was to determine the ideal conditions under which catechol oxidase catalyses reactions. In order to do this, catechol was catalyzed by catechol oxidase into benzoquinone at diverse temperatures and pH values. The enzyme was exposed to its new environment for 5 minutes before the absorbance of the catechol oxidase was measured at 420 nm using a spectrophotometer. The use of a spectrophotometer was crucial for the collection of data in this experiment. When exposed to hot and cold temperatures, some enzymes were found to denature causing the activity to decrease. Similarly, when the pH was too high or low, then the catechol oxidase enzyme experienced a significant decrease in activity. It can be concluded after completing this experiment that the optimal pH for catechol oxidase is 7 and that the prime temperature is 20º C. Due to the fact that the catechol oxidase was only tested under several different temperatures and pH values, it is always possible to get a more precise result by decreasing the increments between the test values. However, our experiment was able to produce accurate results as to the

Effect of pH on Enzyme Activity. 1. Dependent Variable. amount of product (glucose and fructose) produced 2. Independent Variable. pH 3. Controlled Variables. temperature; amount of substrate (sucrose) present; sucrase + sucrose incubation time

Introduction: Starting out with some background information, I know that enzymes are biological catalysts. The enzyme that I used for this experiment was potato juice. Enzymes make reaction rates go faster. They lower activation energy, making chemical reactions. Temperature has an effect on canola cultivars. The higher temperature decreased stem diameter, but room temperature had thicker stems. So I believe the same will happen for the catechol oxidase; the solution will react faster at room temperature. Other enzymes can also have different effects such as the enzyme in cattle serum. The enzyme lost activity in room temperature. With that being said room temperature can also be detrimental with specific enzymes. Fungus also

These results show how temperature of extreme high, or low affects enzyme activity. The highest rate of enzyme activity occurred at 37 Cº. Anything that was hotter or cold than 37 Cº slowed the reaction rate. As I thought, 100 degrees would denature the enzyme, and that was the case. The data provided shows exactly what temperatures enzymes work best, and worst. The objective was achieved as we discovered the different reaction rates under different temperatures. The results are reliable, as we know enzymes do not work well when under extreme heat or denaturation occurs. What I learned in this experiment was that enzymes don’t work well under cold temperatures because they tend to move slower. My hypothesis did not quite match, because I thought they work best at lower temperatures.

Background and Introduction: Enzymes are proteins that process substrates, which is the chemical molecule that enzymes work on to make products. Enzyme purpose is to increase the rate of activity and speed up chemical reaction in a form of biological catalysts. The enzymes specialize in lowering the activation energy to start the process. Enzymes are very specific in their process, each substrate is designed to fit with a specific substrate and the enzyme and substrate link at the active site. The binding of a substrate to the active site of an enzyme is a very specific interaction. Active sites are clefts or grooves on the surface of an enzyme, usually composed of amino acids from different parts of the polypeptide chain that are brought together in the tertiary structure of the folded protein. Substrates initially bind to the active site by noncovalent interactions, including hydrogen bonds, ionic bonds, and hydrophobic interactions. Once a substrate is bound to the active site of an enzyme, multiple mechanisms can accelerate its conversion to the product of the reaction. But sometimes, these enzymes fail or succeed to increase the rate of action because of various factors that limit the action. These factors can be known as temperature, acidity levels (pH), enzyme and/or substrate concentration, etc. In this experiment, it will be tested how much of an effect

Lab six requires students to observe the effects of pH and enzyme concentration on catecholase activity. Enzymes are organic catalysts that can affect the rate of a chemical reaction depending on the pH level and the concentration of the enzyme. As pH comes closer to a neutral pH the enzyme is at its greatest effectiveness. Also at the absorbance of a slope of 0.0122 the enzyme is affected greatly. The pH effect on enzymes can be tested by trying each pH level with a pH buffer of the same pH as labeled as the test tube and 1mL of potato juice, water, and catechol. This is all mixed together and put in the spectrophotometer to test how much is being absorbed at 420nm. As the effect on enzyme concentration can be tested almost the same way. This part of the exercise uses different amounts of pH 7-phosphate buffer and potato juice, and 1mL of catechol mixed together in a test tube. Each substance is put in the spectrophotometer at a wavelength set tot 420nm. The results are put down for every minute up to six minutes to see how enzyme concentration affects reaction rate. The results show that the pH 8 (0.494) affects the enzyme more than a pH of 4 (0.249), 6 (0.371), 7 (0.456), and 10 (0.126). Also the absorbance is greatest at a slope of 0.0122 with test tube C that has more effect on the reaction rate, than test tube A, B, and D.

The lab leaders and the Punk Rock Warlord prepared three different concentrations of catechol oxidase by extracting potato juice (because it contains lots of catechol oxidase). Pure catechol, a 5mL test tube, 1mL/5mL

The aim of my investigation is to see how pH affects the activity of potato tissue catalase, during the decomposition of hydrogen peroxide to produce water and oxygen.

Catechol, in the presence of oxygen is oxidized by catechol oxidase to form benzoquinone (Harel et al., 1964). Bananas and potatoes contain catechol oxidase that acts on catechol which is initially colorless and converts it to brown (Harel et al., 1964). In this experiment, the effect of pH on the activity of catechol oxidase was conducted using buffers ranging from pH2 to pH10. Two trials were conducted due to the first trial results being altered by an external factor. The results were acquired by taking readings every 2 minutes for 20 minutes from a spectrophotometer and then recorded on to the table. The data collected in the table were then made into graphs to illustrate the influence of pH on the catechol oxidase catalyzed reaction. After analysis, the data revealed that pH did have a significant influence on the enzyme as recorded by absorbance per minute. However, the data was collected was not accurate due to external factors, thus the results are debatable and should be experimented again for validation.

Enzymes are high molecular weight molecules and are proteins in nature. Enzymes work as catalysts in biochemical reactions in living organisms. Enzyme Catecholase is found on in plants, animals as well as fungi and is responsible for the darkening of different fruits. In most cases enzymatic activities are influenced by a number of factors, among them is temperature, PH, enzyme concentration as well as substrate concentration (Silverthorn, 2004). In this experiment enzyme catecholase was used to investigate the effects of PH and enzyme concentration on it rate of reaction. A pH buffer was used to control the PH, potato juice was used as the substrate and water was used as a solvent.