Need ASAP. Answer carefully with step by step solution please thank you 1. Determine the equivalent impedance and the equivalentadmittance.-jionJisn12n

Answered: Image /qna-images/answer/1332b326-2231-4804-a890-a3ce4997b7c1.jpg

Answered: • 1. Determine the equivalent impedance…

Science

Physics

• 1. Determine the equivalent impedance and the equivalent admittance. -jion jlsn 12A

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 19P: At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?

See similar textbooks

Related questions

Q: A co-efficient coupling of 0.58 linked the two inductors with a mutual inductance of 25 uH. What is…

A: Coupling factor is given by : k = M/√L1L2 Where M = Mutual inductance L1= inductance of one…

Q: Describe the cutoff condition in a BJT circuit?

A: The cutoff mode is the opposite of saturation. A transistor in cutoff mode is off, there is no…

Q: Explain capacitive reactance?

A: Capacitance of a capacitor is the amount of charge it can achieve.

Q: Calculate the equivalent impedance of a three-branch parallel network given the following…

Q: purely resistive RLC series purely inductive purely capacitive

A: The current is in phase with voltage in this graph.

Q: List any two applications of LCR circuits.

A: Introduction: An LCR circuit has three components, a resistor, a capacitor, and an inductor. All…

Q: DC generator of AC generator including the rectifier both having the same voltage output, Which is…

A: Rectifier is used to covert ac current to dc current. Hence it's more preferable to use the…

Q: (II) For a 120-V rms 60-Hz voltage, an rms current of 70 mApassing through the human body for 1.0 s…

A: Given data: RMS voltage, Vrms=120 V Frequency, f=60 Hz RMS current, Irms=70 mA=70×10-3A Time taken,…

Q: Prob.19. Find the load impedance Zz so that maximum power can be transferred to it in the circuit as…

Q: An RLC circuit has resistance R = 225 Ω and inductive reactanceXL = 175 Ω. (a) Calculate the…

A: (a). write the expression for phase angle of the circuit and solve for capacitive reactance.

Q: 12. A loaded zener regulator is shown in Figure 3-76. Vz = 5.1 V at Iz = 49 mA, IZK = 1 mA, Zz = 72,…

A: Given values, Vz=5.1VIz=49mAIzk=1mAZz=0 ohmsIzm=70mA

Q: 5. For the following pair of voltage and current, indicate whether the element involved is a…

A: Solution to ur question is as follows. Hope this will be helpful for you.

Q: Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut,…

Q: Determine the maximum magnetic flux through an inductorconnected to a standard outlet ( ΔVrms = 120.…

Q: Does inductance depend on current, frequency, or both? What about inductive reactance?

A: The inductance, L, of an inductor depends upon its make and it is independent of the current as…

Q: In pure inductive circuit, the power is O maximum normal O infinite zero

A: We need to tell what is the power in a pure inductive circuit.

Q: When an inductor is connected to a sinusoidal voltage source with a 120 V amplitude (maxim emf).…

A: Given: V = 120 v Im =3A

Q: 22. A simple RL circuit includes a 0.125-H inductor. If the circuit is to have a characteristic time…

Q: If the resistance in an RLC circuit remains the same, but thecapacitance and inductance are each…

Q: In an L-R-C series circuit, what criteria could be used to decide whether the system is overdamped…

A: An underdamped system moves quickly as compared to the overdamped system. The criteria of resistance…

Q: Is this circuit capacitive or inductive? Give two reasons.

A: Given:- A circuit is given above in the figure The R, C, and L are in the series. Find:- Is the…

Q: - 6 In an oscillating LC circuit, the maximum charge on the capacitor is 4.5 x 10 current through…

Q: Example: Ф2 2cos(21,), find the mutual inductance. 1 = 2 * 10-3t %3D

Q: 6. For 2 inductors La and Le with values 150µH and 200µH.Calculate (3M) 1. Total inductance when LA…

Q: Can there be an induced emf in a circuit at an instant when the magnetic flux through the circuit is…

A: Faraday's Law gives us the concept of the induced emf being equal to the rate of change of magnetic…

Q: How would you shape a given length of wire to give it the greatest self-inductance? The least?

A: The expression for the self inductance is,

Q: Suppose you want to increase the time constant of an RL circuit. How might you do that? Increase R…

Q: Induced potential difference of 5V is developed across a coil when the current flowing through it…

A: Given: The induced potential difference, V= 5 v Current decrease at the rate of di/dt=-25 A/s A…

Q: 11 - Four resistors, one uncharged capacitor and two inductors are arranged as shown in the figure.…

A: Just after the switch is closed. Capacitor will behave as a wire And, Inductor will behave as open…

Q: What must be the capacitance for a station at 1700 kHz ? What is the inductance (assumed…

Q: -. A charged 30 µF capacitor is connected to a 27 mH inductor. What is the angular frequency of free…

Q: Explain why the brightness of an incandescent bulb connected in series with an inductor will…

Q: 3. Calculate: a. VG b. Voa c. Vor 1. 0.50 If o = 1000 rad/sec %3D Calculate: V = 120 volt a. The…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Need ASAP. Answer carefully with step by step solution please thank you

1. Determine the equivalent impedance and the equivalent
admittance.
-jion
Jisn
12n

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
5. Find v₁ across the inductor below. lotěst A V₂ m 0.14 + 6. Find the voltage across a 5 µF capacitor if the current through it is i(t) = 3e 2000t mA Assume that the initial capacitor voltage is zero.
An A.C. circuit consist of a resistor of 50 and inductor of 10 mH connected in series with 50 V, 50 Hz supply. What capacitance should be connected in series with the circuit to obtain maximum current ? What will be the maximum current ? m a d - an
Cathode Ray Oscilloscope: The oscilloscope can be used as a voltmeter, therefore, Select one: a. It should have a very large resistance O b. It should have a very small resistance C. It can't be used with AC signals d. It can't be used with DC signals
At time zero an 80 μF capacitor with an initial charge of 12 μC charge is connected across a 15mH inductor. What is the charge on the capacitor and what is the current through the inductor 0.6 ms after the circuit is connected?
In an A.C. circuit, if the impedance is 500 ohm and reactance is 400 ohm, the resistance of the resistor is: O a. 640.3 ohm O b. 100 ohm O c. 300 ohm O d. 900 ohm
Which of the following waves have the minimum wavelength? O a. X-rays O b. Infrared rays O .Ultra violet rays O d. Radio waves
In a certain LCR series resonant circuit, Vc = 25 V, V = 25 V, and VR = 20 V. The value of the source voltage is а. 20 V O b. 25 V О с. 70 V O d. 50 V
What is the impedance of a one microfarad capacitor at 60 Hertz?