10. A 15 N force is applied at the end of a wrench that is 0.25 m long. The force makes an angle of 47 degrees with the wrench. Draw the vector diagram of this situation and determine the magnitude of the torque of this force.

10. A 15 N force is applied at the end of a wrench that is 0.25 m long. The force makes an angle of 47 degrees with the wrench. Draw the vector diagram of this situation and determine the magnitude of the torque of this force.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter8: Rotational Equilibrium And Dynamics

Section: Chapter Questions

Problem 2P: A worker applies a torque to a nut with a wrench 0.500 m long. Because of the cramped space, she...

See similar textbooks

Related questions

Q: 23. Some amount of energy is transferred by heat into a system. The net work done by the system is…

A: given data networkdone (dw) = 50 J internal energy (du) = 30 J amount of net heat =?

Q: 10. The index of refraction of beer is about 1.35. What is the speed of light in beer?

A: Given: The refractive index of the beer is 1.35.

Q: If you want to build the equivalent capacitor with a parallel plate capacitor with dielectric…

Q: A car drives east for two hours at 40 miles per hour. After stopping for two hours, it then drives…

Q: Find force Mass=2.334 kg Acceleration=0.6 m/s2

A: Introduction : In this question we are provided with value of mass and acceleration.with these data…

Q: 9 V R₁ M *3Ω 502 10 Ω 2 4 R3 1. What is the value of V₁? a. 6 V b. 8 V c. 9V 2. What is the value of…

A: Given circuit with three resistors and one battery.

Q: J The specific heat capacity of water is the amount of energy (in Joules) required to raise the…

Q: Doppler uses ultrasound to measure blood flow velocities. Assume that the device emits sound at a…

A: Given the Parameters : Frequency of device, F = 3.5 MHz = 3.2 × 10³ Hz Speed of sound in tissue = Vs…

Q: Find the Current Voltage-44 Volt Resistance 5.5 Ohm

A: We have a circuit with a voltage of V=44 V and a resistance of magnitude R=5.5 ohm. We need to find…

Q: * The frequency of the sound audible to the :human ear a-0-20 HZ b-20-400HZ c-20-20000HZ d-20-1000HZ…

A: in this question multiple choices question is being asked .

Q: 4) Two containers of equal volume each hold samples of the same ideal gas. Container A has twice as…

A: Write the ideal gas equation when the pressure and volume are constant.

Q: A ship whose velocity relative to the water is 20 km/h is moving in a river where the water flows at…

A: Given : v1 = 20 km/h v2 = 6 km/h

Q: Jack what is Joe race up the hill and back down in at 0.1 5C Jack recorded a time of 8.9×10^-6 for…

A: Write the expression for the time dilation and substitute the required values.

Q: How much louder is a 50 dB sound than a 10 dB sound? A 5 times B 25 times C 40 times D 10 000 times

A: The unit of loudness of sound is called decibel. It is denoted by dB. The loudness is a measure of…

Q: A bus is 106 m long runs at 12 m/s. Find the time ?

A: Introduction : In this question we are provided with value of distance and speed . With these data…

Q: Light strikes a mirror at 15°. What is its angle of reflection? A 13° B 15° с 30° D 75°

Q: Which of the following does NOT demonstrate Newton's first law of motion? A bicycle moving in a…

A: As per the Newton's first law of motion 'an object continues to be in a state of rest or uniform…

Q: Which of the following is the correct physical explanation for the dangers posed by large currents…

A: During electrocution, the energy is proportional to the current.

Q: A plane is flying north with a 51 meters per second. If a wind, at 17 meters per second, is blowing…

Q: An 82.0 kg-diver stands at the edge of a light 5.00-m diving board, which is supported by two narrow…

Q: A person tosses a quarter off of the Eiffel tower (h = 324 m) with a downward velocity of magnitude…

Q: 7A car increases its speed from 40kph to 55 kph within 5 seconds while a bicycle increases its speed…

A: We need to comment on the answers to the given questions based on force, acceleration and velocity.…

Q: A ship's sonar uses a frequency of 22.5 kHz. The speed of sound in seawater is 1533 m/s. a). Draw a…

A: Given : Frequency (f) = 22.5 kHz Speed of sound in water (v) = 1533 m/s Speed of ship (vs)= 0 m/s

Q: Find the time Speed=66.23 km/hr Distance=22 km

A: Given data : Speed=S Distance=d Required : Time

Q: A car is moving with uniform acceleration. it covers 200 m in 2 sec and 220 m in next 4 sec. the…

Q: A rectangular loop of wire has area A. It is placed perpendicular to a uniform magnetic field B and…

Q: Consider a Carnot thermal machine. During a reversible process the system a) is close to equilibrium…

A: In reversible process system always roam around the equilibrium state. All the parameters are remain…

Q: 3) The flux of the electric field (24 N/C)t + (30 N/C)j + (16 N/C)k through a 5.0 m² disk placed in…

Q: How do you estimate the performance of a refrigerator? a) By a coefficient of performance that can…

A: Performance of refrigerator

Q: In your own words, explain Faraday’s Law of Induction. Why was the theory so revolutionary? As far…

Q: 13) Your lungs hold 4.2 L of air at a temperature of 27°C and a pressure of 101.3 kPa. How many…

Q: 2) By what primary heat transfer mechanism does the sun warm the earth? A) conduction B) convection…

A: Conduction is the transfer of heat energy by direct contact, convection is the movement of heat…

Q: Consider the circuit shown below, with a battery of emf E = 20. V, and resistors R1 = 2.0 Ω, R2 =…

Q: Determine the magnitude and direction of the force on an electron traveling 7.75 x 10 5 m/s…

A: Given: velocity of an electron = 7.75×105m/s (in east) magnetic field strength = 0.45T (vertically…

Q: 21) How much heat is required to raise the temperature of a 225-g lead ball from 15.0°C to 25.0°C?…

Q: chapter 4.3 5) The position of a particle moving along the y axis, starting from the origin at t =…

A: Instantaneous speed is explicit as the rate of change of position over a very short period of time…

Q: You shine a flashlight due north and send it through a linear polarizer so that the light is…

A: Polarization is a property applying to transverse waves that specifies the geometrical orientation…

Q: What is the total energy stored in the following 3-charge system? 2 nC + 2 cm 2 cm -1 nC O 22.5 μ Ο…

A: Given Three charges are arranged as shown in the figure. We have to calculate the total energy…

Q: Find the Current Voltage-44 Volt Resistance-5.5 Ohm

Q: Press the hotspot that indicates the crest of the wave.

A: A Crest point on a wave is the maximum value of an upward displacement within the cycle.

Q: What is the diameter of a 1.00-m length of tungsten wire whose resistance is 0.12 Ω

Q: 3.A wave on a string has a frequency of 58 Hz and a speed of 31 m/s. What is the wavelength of this…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: If 0.8 A of current flow through a light bulb connected to a 120 V outlet, the power consumed is

A: We know thatP=V×IWhereP=powerV=voltageI=current

Q: 3.5m

A: We have a block of mass m=4 kg which is initially at point 1 (at rest so velocity v1=0) that is at a…

Q: A 5000 kg aircraft towed at 10 m/s collides with a smaller aircraft that is 3000-kg mass initially…

A: Given data as per question m1 = 5000kg u1 = 10m/s m2 = 3000kg

Q: The position versus time for a certain particle moving along the x-axis is shown in the figure. 1.…

Q: Bulb A, B, C are 60 W lightbulbs. Bulb D is 100 W lightbulb. Which light bulb will be the dimmest? A…

A: Power of the bulb is given as P =V2RR =V2PThus, R∝1PSo,the resistance of bulbs A,B and C are and…

Q: Two people with a combined mass of 127 kg hop into an old car with worn-out shock absorbers. This…

A: In the given question, Total mass of people (m) = 127kg Compression in spring (x) = 9.10cm = 0.091m…

Q: Alpha particles (mass = 6.7 × 10^-27 kg, q = +2e) are accelerated from rest through a potential…

Q: There is a satellite that makes circular orbital motion 600 kilometers above the Earth's surface.…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

100%

Pls help ASAP.

10. A 15 N force is applied at the end of a wrench that is 0.25 m long. The force makes an angle of
47 degrees with the wrench. Draw the vector diagram of this situation and determine the
magnitude of the torque of this force.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The fishing pole in Figure P10.22 makes an angle of 20.0 with the horizontal. What is the torque exerted by the fish about an axis perpendicular to the page and passing through the anglers hand if the fish pulls on the fishing line with a force F=100N at an angle 37.0 below the horizontal? The force is applied at a point 2.00 m from the anglers hands. Figure P10.22
Find the net torque on the wheel in Figure P10.23 about the axle through O, taking a = 10.0 cm and b = 25.0 cm. Figure P10.23
A student rides his bicycle at a constant speed of 3.00 m/s along a straight, level road. If the bikes tires each have a radius of 0.350 m, (a) what is the tires angular speed? (See Section 7.3.) (b) What is the net torque on each tire? (See Section 8.5.)
What are the necessary conditions for equilibrium of the object shown in Figure P12.1? Calculate torques about an axis through point O.
(a) Is it possible to calculate the torque acting on a rigid object without specifying an origin? (b) Is the torque independent of the location of the origin?
A soccer player extends her lower leg in a kicking motion by exerting a force with the muscle above the knee in the front of her leg. She produces an angular acceleration of 30.00 rad/s2 and her lower leg has a moment of inertia of 0.750kg-m2 What is the force exerted by the muscle if its effective perpendicular lever arm is 1.90 cm?
A worker applies a torque to a nut with a wrench 0.500 m long. Because of the cramped space, she must exert a force upward at an angle of 60.0 with respect to a line from the nut through the end of the wrench. If the force she exerts has magnitude 80.0 N, what magnitude torque does she apply to the nut?
A grinding wheel is in the form of a uniform solid disk of radius 7.00 cm and mass 2.00 kg. It starts from rest and accelerates uniformly under the action of the constant torque of 0.600 N m that the motor exerts on the wheel. (a) How long does the wheel take to reach its final operating speed of 1 200 rev/min? (b) Through how many revolutions does it turn while accelerating?
Suppose you exert a force of 180 N tangential to a 0.280-m-radius 75.0-kg grindstone (a solid disk). (a)What torque is exerted? (b) What is the angular acceleration assuming negligible opposing friction? (c) What is the angular acceleration if there is an opposing frictional force of 20.0 N exerted 1.50 cm from the axis?
A force of F=(2.00i+3.00j) N is applied to an object that is pivoted about a fixed axle aligned along the z coordinate axis. The force is applied at the point r=(4.00i+5.00j)m. Find (a) the magnitude of the net torque about the z axis and (b) the direction of the torque vector .
The fishing pole in Figure P10.28 makes an angle of 20.0 with the horizontal. What is the torque exerted by the fish about an axis perpendicular to the page and passing through the anglers hand if the fish pulls on the fishing line with a force F = 100 N at an angle 37.0 below the horizontal? The force is applied at a point 2.00 in from the anglers hands.
What force must be applied to end of a rod along the x-axis of length 2.0 m in order to produce a torque on the rod about the origin of 8.0k Nm ?