27. An input sequence xn)= { 2, 1, 0, I, 23 DSP system having an im pu lse is applied to a Sequence hon) =5,3,2,13 Determine the Olp sequence poo duced by (a) Linego Canvolution & (6) veoify the same thoough cioculao convolution,

Q: Find the initial value using Laplace transformed 5/s3+2s2+11

A: Given: The Laplace transformed function is Fs=5s3+2s2+11

Q: Q2: The closed loop transfer function of a system is given by G(Z) 1 1+ G(Z) Z2 – Z +1 Find the pole...

A: Closed loop transfer function of a system given.  Find the location of poles  Damping ratio Natural ...

Q: Q4/: A full-wave bridge rectifier at (2:3) transformer with a [77 sin(2n x 100 x 103t)] rms input si...

A:

Q: E Realuce Hhe block diagpoun shewn b RQ. Gz Gi Hi 3.

A:

Q: Show all working explaining detailly each step

A:

Q: A balanced positive sequence star connected source with VLL=220V is connected to a delta connected l...

A: Delta connected (8-j6) impedance is converted to star connected load. so, star connected load will b...

Q: Q3. The switch in the circuit below was opened for a long time and at t=0 is closed. i) Find i2(0") ...

A: In the circuit, resistance and capacitance are consist,  Find the current shown in the circuit after...

Q: Q1) If the radius of a circle is 16 cm, what angle in degrees is subtended by an arc of 7 cm ?

A:

Q: Q1) If D = (2y² + Z)ax + 4xyay + xaz C/m2, find (a) The volume charge density at (– 1, 0, 3) (b) The...

A: Volume charge density (ρv)=∇·D ∇·D=∂Dx∂x+∂Dy∂y+∂Dz∂z Flux= ∫ρvdv  

Q: Solve the following

A: The capacitors connected in parallel in the upper part is reduced to, C1=1+1     =2 μF The capacitor...

Q: Matlab script from q2 onwards.

A: Question 3.  We have to Find C:  As We don't have the resources to solve MATLAB Queries. So I have s...

Q: A series RLC circuit, R=1000 Ohm, L=500 mH, C=1 microFarad , is given in Fig.1. a. Find the trans...

A:

Q: Acoustic speech signal can be converted into a sinewave signal by using Transceiver O There is no co...

A: We use sound transducer to convert the acoustic speech signal into sinewave signal .

Q: 5.6 Figure 5.33 shows the timing diagram for the S and R inputs for an SR flip-flop. Complete the di...

A:

Q: How can self inductance be defined? What will happen to the self inductance of the coil if the numbe...

A: When charges move with a constant velocity, the charges produce a static magnetic field. A current c...

Q: Qs: A silicon sample contains NA = 1016cm-3 Indium (In) acceptors %3D atoms and a certain number of ...

A: Given: NA=1016 cm-3 Indium(In) acceptors atomsT=300 K△E=0.16 eV acceptor level above Ev  

Q: I liked how you break down these problems . Please double check and see if the answers are right. Ca...

A:

Q: 2. A In the given network, each capacitor has C = 4.00 µF and Vab = +28.0 V. Calculate the: a. Total...

A: to calculate the charge across the capacitor we must know the value of capacitance and the voltage a...

Q: why the CMOS inverter circuit below contains two opposite- type MOSFET transistors (nMOS and pMOS)? ...

A: Cmos is complementary mos or it work as inverter so when 1 is applied at input it gives 0 when 0 is ...

Q: 5.7 Explain how the arrangement of gates shown in Figure 5.34 gives an SR flip-flop. Figure 5.34 Pro...

A: Truth table of SR flip flop, S R Q+ 0 0 Q (Hold) 0 1 0 (Reset) 1 0 1 (Set) 1 1 Invalid st...

Q: What are the conditions of being a signal? Give examples.

A: A signal is a capacity or an informational collection addressing an actual amount or variable. Typic...

Q: Example 19: The range of spread of gate-cathode characteristics for a certain thyristor can be Vcc l...

A:

Q: A carrier signal 4 sin (2n * 5 * 105 t) volts is amplitude modulated by audio signal [0.2 sin 3(2n *...

A: Given data, ct=4sin2π×5×105 Vmt=0.2sin32π×500t+0.1sin52π×500t V

Q: Set-up the circuit shown in Fig. 11. a l RO c 12 R2 e + VO + V2 V11 ´ 13 V1 R1 R3 V3 5 V b d f Figur...

A: Note: This is an experimental question. you have to perform the experiments for some questions. I wi...

Q: A coil consists of 100 turns of wire in shape of circle placed in the y-z plane. The loop has an are...

A: Turns=100area=1m2The first one is given by B1=-10x→t2The second one is B2=20x→sin2ωtFind the voltage...

Q: A ring and a disk both are centered at (7, 6, 5) and are both lying on the plane y = 6. The ring has...

A: As the ring has a negative charge, the electric field will be directed towards the ring. Calculate t...

Q: why the gain at low end of the amplifier in linear-frequency plot often ? called the DC gain

A:

Q: Correct answer: 3.2%

A: VDC =Vm -4.17 IDCC = 40-4.17 ×4075=37.76

Q: Please explain why only half of the waves are kept for the voltage across compared to that across th...

A: Given:

Q: What is  the effects of Electric Current on Human Body?

A: An electric shock is experienced by the nervous system when the electric current passes from the bod...

Q: The output frequency of a half-wave recțifier with a 60 Hz sinusoidal input is (a) 30 Hz b) 60 Hz) e...

A: Given, In a half wave rectifier, the input signal frequency is  fin=60 Hz

Q: Q2) a) an infinit line charge pL=20nc/m along z axis in free space, find the work done on a point ca...

A:

Q: The following resistors are connected in parallel: 1.0M ohm,2.2M ohm, 56M ohm, 12 M ohm and 22 M ohm...

A: The obstruction offered to the smooth flow of current is called resistance. The electrical element o...

Q: 4V 5V T 32ミ 213 Find I and v qt 3,2 and 62

A:

Q: QT: Consider a parallel plate capacitor with plate area of 1 cm², plate separation of 1 mm with SiO2...

A:

Q: Please solve only (i), (ii), (iii). Thanks.

A:

Q: A 10.8-2 resistor, a 11.8-uF capacitor, and a 16.4-mH inductor are connected in series with a 130-V ...

A: current is maximum at resonant frequency. For series RLC resonant frequency=12πLC current at resonan...

Q: Thanks :)

A: Given the circuit: 1. We need to calculate ID and Vo for two sets of Vi given below. Vi=0 V ,0.3 V ...

Q: Q3) a point charge of 2uc at origin and a sphere of radius Im with a uinform charge distribution pv-...

A:

Q: The input voltage Vi of the following circuits is a triangular signal with an amplitude of 18Vpp, th...

A:  

Q: JA 111.0 V DC power supply is connected in series with an 2.15 × 10-3 N resistor and an inductor. If...

A: Voltage V =111 V Resistance R =2.15×10-3 Ώ Voltage across inductor VL =28 V Time  t1 =4.09 st2 =5.15...

Q: Thanks :)

A: NOTE: Since you have posted a question with multiple subparts, we will solve the first three subpart...

Q: Desing a circuit in order to maintain VL = 3.3V with variation of thechargeIL from 0 to 100mA. Also ...

A: It is basic zener diode circuit .

Q: Given below is a schematic for a simple LED flashlight, as well as the values therein. If the LED wo...

A: Note: Since you have posted a question with multiple subparts, we will solve the first three subpart...

Q: why the frequency fT is called the ? unity gain frequency

A: Unity gain frequency one of the important  parameter in frequency response.

Q: Q1) If the radius of a circle is 16 cm, what angle in degrees is subtended by an arc of 7 cm ?

A: Angle = Arc/ radius

Q: Draw the power triangle for combined loads. The combined loads are one capacitor and one inductor, a...

A: Draw the power triangle for combined loads. The combined loads are one capacitor and one inductor, a...

Q: Find iL(t) for t > 0 for the circuit of figure. Assume steady state conditions exist at t = 0¯.

A: Transient response is the response of a system which is the change in transient(equilibrium) or stea...

Q: Question2. Consider a 10 KVA, 200/400 V, 50 H: single-phase transformer has the following test resul...

A: Single phase transform short and open circuit test parameters given.  Find the efficiency of the tra...

Q: 2. A 3-phase, 75 MVA, 11-8 kV star-connected alternator with a solidly earthed neutral point has th ...

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again.

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.