Answered: 3. A power station has a quarterly…

3. A power station has a quarterly energy output of 11,100,000 kWh. Its utilization factor is 80% and the reserve over the peak load is 4000 kW. The rated capacity of the plant is. kW.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: Categorize each of the following signals as an energy signal or a power signal, find the energy or…

Q: state space model

Q: What is the asnwer for B please

A: Given response curve:According to thread question we need to find the type of filter in figure (b)?

Q: 1.18 A toroidal core of mean length 15 cm and cross-sectional area 10 cm² has a uniformly…

A: Given Data:A torroidal core with,Mean length Cross sectional area The supply voltage Frequency…

Q: A diode at room temperature (VT=25mV) conducts 1.2 mA when its forward voltage is 0.7 volts. What…

Q: In the circuit given below, R = 34 2. Find Vousing nodal analysis. 3V 30 V 60 52 3052 R>Vo 60 92 The…

Q: Describe the significance of power phases and voltage regulation modules on a motherboard,…

A: Power Phases and Voltage Regulation Modules (VRMs) play a critical role in a computer's motherboard,…

Q: A small current loop L, with magnetic moment 5a, A/m² is located at the origin while another small…

A: Every current carrying wire produces its own magnetic field. The direction of magnetic field is the…

Q: Question 2: For a metal-SiO2-Si capacitor having NA= 5 x 10¹6 cm-3 and d = 8 nm, calculate the…

A: For a metalSiO2-Si capacitor having NA= 5 x 1016 cm-3 and d = 8 nm. Calculate the minimum…

Q: Find the Laplacian of the following scalar functions. evaluate at (1,2,3). a) V₂=2.x.².z b)…

Q: 3.1 ● Procedure: Voltage dividing law. E -12V R1 www 27002 R2 ww 1000 www R3 4700 Calculate the…

A: The given circuit isWe need to determine the voltage drop across each resistor.

Q: Problem 2.8: If the interconnection in Fig. P2.8 is valid, find the total power developed in the…

A: Basically Two rules are there in ideal sources interconnection.1) Two or more different ideal…

Q: - A 3-phase, A connected, 400 V, 6 pole, 50 Hz, induction motor has the following equivalent circuit…

A: Given the equivalent circuit constants for the induction motor:R1 = 0.68 ohmX1 = 2.78ohmR2 =…

Q: 2. A full-wave bridge rectifier is operated from a 50 Hz, 220 V rms line. It has a 100 µF filter…

Q: 4) The following system is: a) Type one-second order e) Type two-second order 5) The following…

A: In this question, we need to choose the correct option. What is type and order of the given system.…

Q: Simplify the Boolean expression. (ABC) (C+B+C) +C=¯

Q: Design a circuit that compares two 2-bit numbers, A = {a₁, a₁} and B = {b₁, bo}, and produces the…

Q: Q2:A: Consider the sampled data control system shown in Fig.(3). Find an equation for the response…

A: The sampled data control system is shown below,

Q: K S(S+1)(S+5) Q4:A: Compensate the system with the open loop transfer function G(s)=; to meet the…

A: Compensate the system with the open loop transfer function to meet the following…

Q: V₁> V₂> R₂ www ww R₁ Prove: Vo = 2 K/²² ( 1 + R₁ R₂ R₂ RG W :) (V₂ - V₁ www R₂ R₂ www RG R₂ ww

Q: Q4: A: For the unity feedback closed loop system, having forword transfer function G(s)= k/(…

Q: : A lossless transmitting (Antenna 1) and receiving (Antenna 2) antennas operating at 1 GHz with…

A: The Friss equation is given by : Pr= Pt * (1/4πR)2 * (Gt Gr)* ( c/f)2Pr= Received powerPt=…

Q: I aksed for non inverting op amp configuration and the zero and poles value is also not same. Dont…

Q: 18.10 Find the a parameters for the circuit in Fig. P18.10. Figure P18.10 1 + 1 kn V₁ 10-4 V₂ 1₂ +…

Q: Consider the system has the following characteristic equation, use Routh's criterion to find the…

A: The characteristics equation is given asnow, we need to calculate the value of k for sustained…

Q: Explain with the aid of your investigations why a minimum separation between the individual wind…

A: A minimum separation between individual wind turbines in a large wind farm is necessary to avoid…

Q: In the circuit given above, the switch was opened at t=0 after being closed for a very long time.…

A: The circuit diagram,

Q: 500 W b 3.0 d €25.0 30. a 402 W 6.0⁰ M 502 5.02 2.02 e 75.0 100Ω W

A: Here resistor network given and Equivalent resistance is found between nodes b and dBy using…

Q: voltage across R5 has to be measured with a voltmeter. What percentage error is expected in…

A: Given Data:A DC resistive circuit with,Input voltage = Resistors,To Find:Percentage error of the…

Q: Consider the series RLC circuit in Figure Q4. The initial current is 4A and the initial voltage…

Q: For the first order system with transfer function: C(s)/R(s) =2/2S+! a) Find the time response for…

A: given ,C(s)/R(s) =2/2S+1we have to find a) Find the time response for this system when the input to…

Q: 13. Find the Inverse Laplace transform of- Re(s) >0. X(s) = 5s +13 s(s²+45+13)

Q: 1. A full-wave bridge rectifier isolated from the 220 V rms power line by a transformer. Assuming…

A: Given:A full-wave bridge rectifier circuit is given in the problem with the following data,The…

Q: B: Sketch the complete root locus plot of the system having G(s)H(s) K/(S(S+1)(S+2)(S+3)), Find the…

A: In this question, we need to sketch the root locus and range of k for given system is stable. We…

Q: An analog signal with a bandwidth of 10 kHz is to be sampled and digitally stored on a storage tape…

Q: 1. Draw the schematics for the following functions using NOR gates and inverters only X+Y+Z)

A: We need to draw the schematics for the above logic function with the help of NOR gates and inverters…

Q: In the circuit shown in the given figure, determine the frequency response function in the form: H…

A: We need to determine the frequency response function.

Q: For the circuit shown below, determine the values of the Norton equivalent circuit RN and IN…

A: In this question, we need to choose the correct option. What is Norton current and Norton resistance…

Q: Find vo and in in the circuit, 2 Ω Τ ΤΩ Μ 3Ω Μ ΖΩ 21 27 V

Q: Find the stability of the system by using Bode plot whose open loop transfer is given as G(s)H(s)=…

Q: For the circuit shown in the figure, the switch changes from position 1 to position 2 at t=0 s for a…

A: The given circuit isThe switch has been changed from position '1' to '2' at t = 0 s.We need to find…

Q: 50Ω W b 3.0 d 25.02 3.02 402 W M 60 W 5.02 5.0 C 202 e 75.0 100Ω W

Q: Why are optoisolators normally used between the microcontrollers and the ULN2803? a) to reduce the…

A: We need to select correct option for given statement.

Q: 5. An infinite uniform line charge p, = 4 mC/m is located at x = 1 m, y = 2 m and aligned parallel…

Q: Find the transfer function for the control system shown below G₁ as G2

Q: ₁ = 2A 12 = 9A 13 = ? i4 = 4A

Q: What is the percentage accuracy at Vout?

A: For the given potential divider circuit the percentage of accuracy for the output voltage needs to…

Q: Calculate the frequency of a Wien bridge oscillator circuit when R=10 kN and C= 2400 pF, then find…

A: SOLUTIONGIVEN--> R =10K ohm C =…

Q: 1. Input-output relationship of two systems are given: (i) y(t) = x(t-a), (ii) y(t)=Bx(21-1). Here,…

A: Given:Two systems, To find:Are the given systems linear?Note: are the constants.

Q: 5 mW signal is supplied to an amplifier with a gain of 16dB. What is the output power of the signal?

A: In this question, we need to determine the output power in Watt and decimal. If gain is 16 dB and…

Question

3. A power station has a quarterly energy output of 11,100,000 kWh. Its utilization factor is 80% and the reserve over the peak load is
4000 kW. The rated capacity of the plant is.
kW.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction about the given question

VIEW

Step 2: Calculation for Rated plant capacity

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
Question A power plant has a maximum demand of 15 MW. The annual load factor is 50% and annual plant capacity factor is 40%. The operating reserve capacity is
A power station has a maximum demand of 13590 kW. The annual load factor is 60% and plant capacity factor is 50%. Determine the reserve capacity of the plant.
step down chopper has Vs = 230 V and R = 10 0. For a duty cycle of 0.4, the power taken by the chopper is 2097 Watts. Find the chopper efficiency. Take the voltage drop across the chopper switch as 2 V. a) 98 % b) 89.96 % c) 99.14 % d) 96.54 %
A base load station having a capacity of 18 MW and a standby station having a capacity of 22 MW share a common load. Find the annual load factors and plant capacity factors of two power stations from the following data :Annual standby station output = 740OMWH Annual base load station output = 100000 M kWh Peak load on standby station = 12 MW Hours of use by standby station/year = 2200 hours
A generating station has a maximum capacity of 100 kW and costs $300,000. The annual fixed charges are 12% of the cost of the generating station consisting of 5% interest, 5% depreciation and 2% taxes. Find the fixed charges per kWh generated if load factor is (a) 100% and (b) 25%.
Q2/ Find Yous for the power system all reactance on a common base. Bus 3 j0.25 j0.10 j0.25 Bus 2 j0.125 Bus 1 j0.40 j0.20 j0.10 Bus 4
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
A power generating station has a maximum demand of 1000 MW. The annual load demand of 1000 MW. The annual load factor is 75% and plant capacity factor is 60%. Calculate the reserve capacity.
Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125 kVA, 3-f, 240 V, 60 Hz, 1800 rpm). The load of alternator A is 70 kW at 85% pf leading and the load of alternator B is 85 kW at 75% pf leading. Determine the pf of load.
The voltage regulation of an alternator having 0.75 leading p.f. load, no-load induced e.m.f. of 2400V and rated terminal voltage of 3000V is............... percent. *
a) Explain briefly how electricity can be sold to a grid by use solar energy. b) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20 MW for farm as a whole, in year 2020, the farm produced a total energy 43416MWH, find a capacity factor.