3. Referring to the circuit shown below. If v(t) is 120 cos (1000t-30°) V, determine the following: (a) Inductor current (b) The voltage between terminals a and b, Vab a v(t) 30 -ww- ww ell 6Ω 8mH Note: Express your final answer in polar form. 402 b 125µF

3. Referring to the circuit shown below. If v(t) is 120 cos (1000t-30°) V, determine the following: (a) Inductor current (b) The voltage between terminals a and b, Vab a v(t) 30 -ww- ww ell 6Ω 8mH Note: Express your final answer in polar form. 402 b 125µF

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: Why shouldn't rated voltage be applied to the transformer in the inductive strike method?

A: We need to answer why shouldn't rated voltage be applied to the transformer in the inductive stroke…

Q: Hint: You can determine h(n) up to a constant. We want to design a causal discrete-time LTI system…

Q: Suppose we know the system function H(z) of a discrete-time LTI system has a pair , double poles at…

A: For causal system, ROC must be outermost side of the outer most pole. For, anti causal system, ROC…

Q: Given the circuit below with the switch closed for a long time, then opening at t=0, and with the…

A: The question is based on transient analysis of an RC circuit. The concept used is that under steady…

Q: Construct an exact linear discrete state-space model for the system, 0 ---O x + 1 -1 = = The…

A: The state space matrix in the continuous time domain is given as x˙1x˙2=0-11-1x1x2+10uty=01x1x2From…

Q: I Consider an analog signal xa(t) = sin(250πt) + sin(400πt) + sin(750πt). (a) What is the Nyquist…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: A transformer has a primary voltage of 62V and a secondary voltage of 34V. If the transformer is…

A: Given: Primary voltage, VP=62 V Secondary voltage, Vs=34 V Primary current, IP=2 A

Q: Consider an infinite surface current J, Joax defined over the plane of z=0. Find the magnetic flux…

A: We need to find out the magnetic field for given current density .

Q: 24. Let D = (10r2 + 5e )a, C/m²: (a) Find p, as a function of r. (b) Find the total charge lying…

Q: QUESTION 4 If the maximum energy stored in the coil is 3mJ, what is the value of the resitance in…

Q: The circuit in Figure 18-2 is modified by changing R2 to 560 ohms. Both switches are closed. 1.…

A: The voltage across the parallel circuit remains the same and the current will be different. current…

Q: 5. At w = 10³ rad/s, find the input admittance of each of the circuits. www 2002 Yin www 2002 60 mH…

A: We need to find out the admittance for given circuit .

Q: A line charge, P-50 nC/m, is located along the line x2, y = 5, in free space. (a) Find E at…

Q: 12 12 JAV التاريخ 7 Ji ukn Allee いま 2V Ah

Q: Please describe what SR, JK, D,T flip-flops are.

A: To describe: SR, JK, D and T flip-flops.

Q: tion: Suppose a discrete-time LTI system is characterized by the following system func- 2-212-1 ibl.…

Q: Find V. in the circuit +9v lov 10кл 20k 7 M 30k 12V Yoka 6V look M -va 20kn t Vo

A: Given,

Q: an LTI system with impulse response

Q: When the line is terminated by a resistance, the quarter wave transformer is connected directly to…

A: We know that quarter impedance transformer is used to match the load and transmission at designed…

Q: 4b) If the resistance in this circuit is 2.7 k calculate the peak voltage across each of the…

A: In this question, We need to determine the peak voltage value across the each element. We are…

Q: Consider the causal discrete-time LTI system described by the following constant coefficient…

Q: Please show calculations of operating currents and voltages. Values are located in table. Please…

A: The given circuit is as below,

Q: The figure is shows the first stage of a superheterodyne receiver. The desired input signal is at a…

A: Given: Incoming signal frequency, fc=700 MHz, Local oscillator frequency, fc=1 GHz = 1000 MHz,…

Q: draw the simplified circuit of impluse voltage generator ?

A: Impulse Voltage Generator:- Surges are a nightmare for any circuit designer and a very important…

Q: Problem 2 For the periodic signal given below, calculate the following by using Fourier series…

Q: the cct shown below. Find Vo? R+ R₁ ани R₂ R3 me -т _Vo = kst, 1ks, R₂ =2 k-2, R³=3Kv f=9k₁

Q: EX) is I f(t) = 2rect (£) find ~= f(t) graphically

Q: Determine the current lett for ty 22 جدعانا 6 ↑ 4.5 22 2 F + ✓ LEE) tiss 22

Q: 1. A voltage transformer has 1500 turns of wire on its primary coil and 500 turns of wire for its…

A: Let V1 and V2 be the primary and secondary turns of voltage transformer . and N1 and N2 be the…

Q: A Wye-Delta transformer is connected t0 66 kV input three-phase transmission line. Each transformer…

A: Given: The star to delta transformer: The rating of the transformer is 1000 kVA The ratio is 8:1

Q: QUESTION -7 In the following figure a power line to drive a Load is represented. The wires are made…

A: Electricity is transported by electrical power lines at very high voltage and current levels from…

Q: Use the Laplace Domain approach to find the system response u(t) = 3e^-t and x(0) [1 -2].

A: Q

Q: What is the lighting and receptacle demand load for an 1000 sq. m office space with one hundred ten,…

Q: Vi R₁ MM MM RF .Vo

Q: . What is the demand load for a 10-unit multifamily dwelling if each unit contains a 1,000 VA waste…

A: Given data Number of units =10 For each unit Waste disposal Power Pw = 1000 VA dishwasher power Pd=…

Q: What are two methods that are used to estimate the energy/power requirements for a for a particle…

A: It is asked to mentioned the two methods which are required for estimating the energy or power…

Q: A transformer is rated at 3kVA. It has a primary voltage of 184V and a secondary voltage of 600V. If…

Q: Given the truth table in Table 1, answer the following questions: a. Find the minimum SOP…

Q: Given the minterm expansion F(A, B,C,D) = Σ( 1, 3, 5, 7, 8, 9, 11, 12,13,15 ). d. Create a logic…

Q: R₁ = 56kN, R₂ = 12.2k, Rc = 2k, R= = 0.4k, Rg = 300k, Vcc = 10V. (1) For each circuit (a) and (b),…

A: The required parameters can be calculated by using the DC analysis to both the circuits.

Q: What are the electrical systems used in banks for lighting purposes?

A: Types of lighting Intra-cloud lightning cloud-ground lightning Lightning leads to Very high…

Q: Q Find the output y(t) of the (LPF) show belwo if X(t) 0.05 X(t) 2 0.05 ideal LPF YOH yet)

Q: b- Use the Smith chart to find the following quantities for the transmission line circuit below…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Based on the figure below, what is the direction of the magnetic force? B O left up down O right

Q: Q1: The total harmonic distortion of a closed loop system is 5%. Distortion without feedback is 10%.…

A: Distortion of a closed loop system DHF = 5% Distortion without feedback = 10%

Q: Vs 700 pF L m 0.10 mH 100 nF 560 pF

Q: The intrinsic impedance of a medium is given by "1 impedance in free space is: -12 Hint: -8.854x10…

A: Intrinsic impedance of a medium is given by, η=με Ω Given parameters : μ0=4π×10-7 H/mεo=8.854×10-12…

Q: As discussed in class, when a rectangular window is used on a signal observed for 7 seconds, the…

A: Given,Main lobe width = 4πT rad/secandHalf-width of main lobe = 2πT rad/sec

Q: A coil with impedance 8+j6 Ω is connected in series with a capacitive reactance X. The series…

A: We need to find out the unknown resistor and reactance for given equivalent impedance.

Q: R₁=5km Vi_mm_ RE=IMA www 10 кл Vo

A: Given data, Feedback resistor Rf=1 MΩ Input resistance R1=5 kΩ Input offset voltage VIO=6 mV Input…

Question

3. Referring to the circuit shown below. If v(t) is 120 cos (1000t-30°) V,
determine the following:
(a) Inductor current
(b) The voltage between terminals a and b, Vab
a
v(t)
302
-WW-
6Ω
8mH
Note: Express your final answer in polar form.
www
4Ω
b
125μF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
k A capacitor circuit carrying 12 mA is placed across a 9 V sine wave ac source. A resistor carrying 20 mA is connected in parallel with the capacitor. The total circuit magnitude of current is esc 233 mA 32 mA O 12 MA ! 1 20 mA Q A e N 2 W S X #3 3 E D $ 4 C R F % 5 V T G ^ 6 MacBook Pro B Y H & 7 U N * 00 8 J I M ( 9 K ( O I ) -O L P : ; A + 11 { [ = 11 I delete return
An R−L−C series circuit has a current which lags the applied voltage by 45°. The voltageacross the inductance has a maximum value equal to twice the maximum value of voltageacross the capacitor. Voltage across the inductance is 300 sin(1000?) and R = 20 ohms. Computethe following: Value of total Impedance (Z) Value of Inductance (L) Value of Capacitance (C)
Find the equivalent Inductance for the following circuit shown below. L 0000 2.5 H OH 2 H 6 H 0.5 H elle 2 2 H oooo elle 2 H