39 ΚΩ 0 uF 3.9 ΚΩ +22 V Ici '10 ΚΩ 10 με tf Vc β=100 1.5 ΚΩ 50 µF Vo

Q: A unity feedback system has a plant transfer function described by G(2) as follows: 1 G(z) = 22-72…

A: Given transfer function is :G(z)=1z2−7z+11

Q: Rin 2.5Ω 1Ω 3Ω ΖΩ 6Ω 5Ω ΙΩ 4Ω

A:

Q: 3. Using JK Flip Flops, draw an asynchronous 3-bit ripple counter to produce the following counting…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: P3. For what values of "K" is the time constant of the closed-loop system has open-loop T.F.…

A:

Q: 2 For the op-amp circuit, the known values are listed as follows: R₁ = 3kn, R₂ = 12kf, vin = 0.1V,…

A:

Q: For the power system of Figure Q4.1, all per unit quantities have been calculated using a common…

A: The power system is given as Before the fault system will look like Now, the system parameter is…

Q: Consider the following electrical system: R₁ L The equations describing the system dynamics are the…

A:

Q: C. ) A message signal will be sampled. a. Determine the minimum required sampling frequency…

A:

Q: for the mechanical system shown below, find the transfer function t(s)= V2 (s)/R(s)

A: Given: A mechanical system as, To find: The transfer function T(s)= V2(s)R(s).

Q: a) The Laplace Transform of a signal a(t) can be written as: s+1 s² + 4s +3 Obtain the Laplace…

A:

Q: Q4) Implement the combinational circuit to realization the functions: F1 = ABC + ABCD F2 = Em (2,11)…

A: We need to implement the given function by using of PROM .

Q: 4. The DT signal y[n] can be obtained from the DT signal x[n] shown below as: ALQUI 2 A[n]-3-[2] B.…

A: It is given that:

Q: Determine the following for the network of Fig. a. V GSg b. Ipg c. VDS. d. Vp. e. VG. f. Vs.

A: The required parameters can be calculated by using the DC analysis of the amplifier circuit.

Q: given IDSS=9mA and Vp=-4, determine ID when: a)VGS=0V b)VGS=-2 V c)VGS=-4 V  d)VGS=-6 V

A:

Q: This design project involves the use of layers of dielectrics in a high voltage cable. These layers…

A:

Q: 1- Determine YT and ZT 2- Sketch the admittance diagram. 3- Find E and IL.

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: 30 mA. Determine VGSs at this current level if k = 0.06 × 10-3 A/V² and V The maximum drain current…

A: Given , Drain current, ID = 30 mA. Gate to source voltage, Vgs = 30 mA. Constant, k = 0.06*10-3 A/V2…

Q: 208 Volt, 10 HP, single pole number 4, 60 Hz, star- connected asynchronous motor, full load slip…

A: Given data, Supply voltage V = 208 V. Number of poles P = 4. Frequency f = 60 Hz. Output power…

Q: Assume there are 10 light bulbs that can be connected in series and 10 light bulbs that can be…

A: We need to find out the current for given circuit for two different connection .

Q: 2. Using Kirchhoff's Rules/Laws, determine the current II, III and I shown in the diagram below. Use…

A:

Q: Resistive Voltage The supply across the terminals of this circuit is 170 V, 50 Hz. An ammeter is…

A: Given: A circuit,  Supply voltage across the terminals is 170 V, 50 Hz. An ammeter is connected to…

Q: Q3/ derive the c(t) for response of first order system for figure below:- (with the finest details)…

A:

Q: Someone help me please. I am in a lot of trouble with this question. Someone give me correct the…

A: Q.11  Given information :-  When we apply voltage with the positive polarity on the _________, a pn…

Q: When causing the average power delivered to a load by an AC elgred, it is not as straight forward as…

A: Given data, From the given waveform maximum voltage Vm=96 V. Resistance R=6.8 Ω.

Q: W ki t $2 S 5(5+2) Find K1 and K2 such that the close loop dominant poles damping ratio (d) 0.5 and…

A:

Q: The frequency of rotor current in an induction motor is       slip times the frequency of stator…

A: The frequency of the rotor is based on the value of slip and input frequency. The slip value can be…

Q: Which of the following is an open loop control system? a) Ward Leonard control o) Metadyne c)…

A: Open Loop Control System: In Open loop control system their is no feedback in system. Input can be…

Q: Determine the output y(t) of the continuous-time (CT) linear time-invariant (LTI) system described…

A: We need to find out output for given system .

Q: In the part d), how do you get (s+1)(s+3)=0 and s^2 + 4s + 3 = 0 (How do you get that 3 )? Could you…

A:

Q: Q1 A control system is described by the block diagram in Figure 1 where R(s) is reference input and…

A: Given a control block diagramAsked to find transfer function and steady state output when input is…

Q: 13 for a certain load the power is -735 VAR, 1040 VA, the values of of the power factor and the…

A: Given data, Reactive power Q = - 735 VAR. ( Here negative sign shows that reactive power will be…

Q: Find the Thevenin equivalent circuit for the portion of the network external to the elements between…

A:

Q: Q2) The characteristic function of X can be found as 1 b² (1+/0²) C) 1+ jbw) a) 1 (1+ b²w²) b) d) 1…

A:

Q: P4. The overall transfer function of a control system has G(S) == B If the response curve required 1…

A:

Q: 3. How much does it cost to operate a 90W lamp continuously for 1 week if the power utility rate is…

A: Given data, Power P=90 W Time used t=1 week Cost per kWh =12 cents/kWh

Q: Three sides of an infinitely long rectangular metallic pipe are grounded at x=0, x=a and y=0. The…

A: Given data, Three sides of an infinitely long rectangular metallic pipe are grounded at, x=0 x=a and…

Q: Discuss the examples of ARM addressing modes? Also define which is pre and post indexed address of…

A: Discuss the examples of ARM addressing modes? Also define which is pre and post indexed address of…

Q: Which of the following statements is correct for any closed loop system? a) Only one of the static…

A: Type of control system Closed-loop control system  The more accurate response even in the case on…

Q: Exercise 3 a) Design a full-adder logic circuit using an active-low 2-to-4 decoder(s) and suitable…

A:

Q: Using Nodal Analysis, find Vo. 1460'A 1.82 عان 122 1220°V (-+) + =jle 1260° A Vo 20

A:

Q: A sinusoidal electric wave with maximum amplitude of 10 V/m is polarized in ŷ and travelling in…

A:

Q: Exercise 2 Given the function F = A.((B.C). (A + B + C + D)) a) Implement the function F using 4 to…

A:

Q: Note: E=Volume, P=Power and W-Energy E = 20 v.; I= 4 a.; t = 3 seconds. P = W E = 15 v.; 1= 6 a.; t…

A: In this question We need to determine the power and energy of the given system.  We know Power P=…

Q: P16. Consider unity feedback has an open loop transfer function below. Find: 1-The static error…

A:

Q: 6 For the op-amp circuit, the known values are listed as follows: R₁ = R₂ = 2k, R₂ = R₁ = 8kn, U₁1 =…

A:

Q: For the following z function G(z)= 18z³ 18z³+3z²-4z-1 1-Obtain factored form and partial fraction…

A: ROC (Region of convergence) is defined as the region on z plane where the output of the discrete…

Q: 16) A 75 2 resistive load is preceded by a 2/4 section of a 50 2 lossless line, which itself is…

A:

Q: A 7.5-hp 120-V series de motor has an armature resistance of 0.2 $2 and a series field resistance of…

A: DC Motor: Direct current is used to create a magnetic field in a DC motor, also known as a direct…

Q: Example 1. The switch in Figure 2 has been closed for a long time. It is open at t=0. Find: a.…

A: The required parameters can be obtained by analysing the circuit at time t less than 0 and greater…

Q: The maximum current in this circuit passes through R2 because it is the smallest of the currents.…

A: We need to find out current through each resistor for given circuit.

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.