5.29 What resistance must be connected in parallel with a 20- and a 60- resistor in parallel in order to provide a total resistance of 102? Ans. 30
Q: 5. When should corner pull boxes be used in an installation?A. At all 90 degree bendsB. At all bends…
A: A pull box is indeed a conduit box or a condulet that is used to draw wires through. It can be…
Q: Question 9 50 V 30 www SA Selected Answer: 60 Correct Answer: 60 150 ●0 If R 54 2, then the Thevnin…
A: Given data, R=54 Ω. Circuit diagram is given by,
Q: Using Boolean algebra, simplify the following expressions: (a) (A + B)(A + C) (b) AB + ABC + ABCD +…
A: Given boolean expressions, (a) A+BA+C. (b) A.B+A.B.C+A.B.C.D+A.B.C.D.E.
Q: Find To
A: It is given that:
Q: 17. What is N in 3/6 x 1/4 = N. A. 4/10 B. 4/12 C. 1/8 18. When 2/10 is multiplied by 4/5, what is…
A: We need to solve the given problem
Q: Wa The voltage and current waveform of an electrical element are depicted in the figure below. Find…
A:
Q: photoelectric proximity sensor might have
A: 1. A photoelectric proximity sensor might have trouble detecting d. All of the above photoelectric…
Q: B- Find the Energy and power of the signals f2 and f3 shown below 1₂ (1) (b) 1 2 13 (1) (c) 1
A:
Q: Why the bandwidth of the operational amplifier is equal to the high cutoff frequency (fc)
A:
Q: parallel circuit consisting of two branches
A:
Q: How do you convert a voltage source in series with a short-circuit to a current source? A B Multiply…
A:
Q: 3) For the following matrices A, compute (i.e., derive a formula for) eªt. a) for a given X E R. A =…
A:
Q: Explain and give 0111 2 example for each (1) Phase and spectrum Plot Duality & fourian transform…
A: As per Bartleby rules we have to answer only first 3 sub parts.
Q: For the circuit shown in Fig. 3.174, calculate the potential difference between resistor connected…
A:
Q: Q16. For the applied signal determine: a) ₁ and 1₂. b) Is. + = C₁ i₁ 2 μF C₂ e = √2 120 sin (10ªt +…
A:
Q: An FM transmission has a frequency deviation of 20 kHz. (i) determine the per cent modulation of…
A: The percentage modulation is the ratio of maximum frequency deviation to the actual frequency…
Q: Draw the rectified sinusoidal output waveforms for the full-wave rectifier with a smoothing…
A: Full wave rectifiers:- Although the full wave rectifier is more complicated than the half wave…
Q: Four resistors are connected to a battery, as shown below. The battery voltage is V, and the…
A: Given data, Resistance is R, The potential difference is V,
Q: a. Find VA, VB, IA, IB, Ic, ID, and IE. b. Find the power for each of the sources, using the passive…
A: The required parameters can be calculated by using kirchhoff's voltage law, kirchhoff's current law,…
Q: 2. W 3:] show that V₂ (t) = [ R²2 vi(+) + [CR₂ + £ ] dvi(t) d+ for the circuit shown below? RI…
A:
Q: Q) A 25 hp, 250 V dc series motor has armature resistance of 0.19 and field resistance of 0.05 Q and…
A: Given - V = 250 V , Armature resistance, Ra= 0.1 Ω , Field resistance, Rse=0.05 , line current I1…
Q: Q2. In a common base connection, IE = 1mA, IC = 0.95mA. Calculate the value of IB.
A: Given: In a BJT, Emitter current, IE=1 mA. Collector current, Ic=0.95 mA.
Q: 5. Use Routh Hurwitz criterion for following system, is the system stable o Unstable? Why? SA+ 2S³+…
A: Given the characteristics equation, s4+2s3+6s2+8s+5=0.
Q: A particular pn junction at T = 300 K is doped with impurity concentrations of N₁ = 1.2 x 10¹4 cm³…
A: Given,T=300 KNd=1.2×1014 cm-3Na=2×1014 cm-3po=1.1×1014 cm-3Vt=25 mV∈s=13.1 ∈0
Q: What distinguishes an integrated circuit from a transistor
A:
Q: Q2) For the given circuit i and v a) Find
A:
Q: In a series circuit, you measure 9 volts across a 300 ohm resistor. How much current is flowing…
A: Given: A series circuit with, Measured voltage, V=9 volts. Resistance, R=300 Ω.
Q: V1 + ING 1 ΚΩ Μ 9V 1 ΚΩ Μ 2 ΚΩ Μ 5 ΚΩ V2 Μ V5 1 ΚΩ Μ V3 1 ΚΩ 1 ΚΩ Μ V4
A: Given is a circuit
Q: Q5/To Design the following functions must using F1=(0,1,4,5) F4=[(0,4,12,14,16,20,32) F2=(0,1,3,5,6)…
A: The given functions are as follows,F1=∑0,1,4,5F2=∑0,1,3,5,6F3=∑1,3,5,7,9,12F4=∑0,4,12,14,16,20,32
Q: A system has a damping ratio of 0.5, a settling time of 2 seconds, and a DC gain of 0.125. Find the…
A: Given a system with, Damping ratio, ζ=0.5. Settling time, ts=2 sec. DC gain = 0.125.
Q: An iron cored coil with 1000 turns generates a magnetic flux of 500 µwb in the core while carrying…
A: Given an iron-cored coil with, Total number of turns, N=1000 turns. Magnetic flux, φ=500 μWb.…
Q: 2-13 In Figure P2-13 i₂ = -5 A and i3 = 2 A. Find i₁ and i4. A B i iz C
A: Given circuit: Here, i2=-5 A and i3=2 A.
Q: Define armature winding and what is its connection with interpoles? Who discovered it and what is…
A: It is asked to define armature winding and also it is asked to mention its connection with…
Q: Can a semiconductor be used to describe the distinction between a conductor and an insulator? Why…
A: This is basic problem of electronic devices and circuits. The solution is given in the next step.
Q: A 2 kHz audio signal modulates a 50 MHz carrier causing a frequency deviation of 2.5 kHz. Determine…
A: Given Frequency of audio signal ∆f = 2 kHz Frequency of carrier fc = 50 MHz Frequency deviation = ∆f…
Q: The flow of current 0.6 A is flowing through the resistance of 112. find the potential difference…
A:
Q: Question 2.5: A multimode step-index fiber has a refractive index difference of 1% and core…
A: Given data: Relative refractive index (Δ)=1% of core refractive index=0.01 Core refractive…
Q: Q4/ The magnitude of the line voltage at the terminals of a balanced Y-connected load is 6600 V The…
A: Given: Balanced Y-connected Load VL=6600VLoad Impedance = (240-j70)Ω/φload is fed from a line has…
Q: What is the use of capacitors in defibrillator?
A: Defibrillator: It is the device used for the treatment of abnormal or uneven heartbeat and used for…
Q: The voltage on a 75 ohm transmission line decreases by 0.10% per meter. What length of this…
A:
Q: 128. A sine wave has a frequency of 50 Hz. Its angular frequency will be A. 50 radians/sec B. 50 n…
A: We need to select correct option for angular frequency
Q: Q4: a) A nonlinear system has a function of y(t) = x²(t). If the signal x (t) = cos (100nt) + 2 sin…
A:
Q: 1. Determine the equivalent Resistance of Terminals a and d. a b Μ Μ 12 Ω 4 Ω 10 Ω Μ C 33 Ω d m 36 Ω…
A: In this question, We need to determine the equivalent resistance across the terminal a and d. We…
Q: 10 V O (d) The loop equation for the circuit is O (a) 492 www (b) E (a) − 10 + 4i + 6 + 2i = 0 (b)…
A: In this question we need to choose a correct option.
Q: Q.2. In order to find the meanings of the following words, which entries should you look for in the…
A: Given words: Visited Children Stood Buying Phenomenon Physiological Bookstore Pressman
Q: gain H. W₁: For the circuit shown below, total (G₁) = 60 dB; A = 105, BW= 5KHZ; f₁ = 1MHZ ; Ri= 1 Mr…
A:
Q: Consider Vdd = 1.8v, Vthn = 0.39v, and Vthp = -0.4 v for the problem. Assume i=g=0. Sketch Vout as a…
A:
Q: HW: The voltage and current waveform of an electrical element are depicted in the figure below. Find…
A:
Q: Q1/ Explain: 1- phase and spectrum plot. 2- Duality of fourier transform 3- Bandwidth.
A: Note: We are authorized to answer first 3 sub-parts at a time, so we are answering first three…
Q: PUTS A с OUTPUT X
A: Here the properties of these gates are analysed to solve it.
Need a handwritten solution on this, the answer is already attached in the image.
Step by step
Solved in 2 steps with 1 images
- If you wanted to measure the voltage of a resistor with a voltmeter, would you introduce the voltmeter to be in series or in parallel to that resistor? Explain. What about for an ammeter?Coverage: Series and Parallel Combinations, and Ohm's Law Question: If simplified, the next figure shall be: - (a) A and the series of three resistors. - (b) A and the parallel of three resistorswhat is the equivalent resistance Rab
- A ammeter has a resistance of 0.1 ohm and full range is 100 A. To incraese range to 1000 A find value of shunt resistance. Please solve it.dhjdhjhdjdhjfhfjdbfejfheidadadisfdfodf,fdhjfhdfj The equivalent resistance of three resistors A, B and C connected in parallel is 1.5 ohms. If A is thrice of B and C is 1/4 of B. Find the equivalent resistance when the three of them are connected in series? dhsfhfeirwdiwudwiwuiWith 100-V applied across each ten 50-ohm resistances in parallel, the current though each resistance equals
- A resistance arrangement of 50 ohm is desired. Two resistors of 100.0 ± 0.1 ohm and two resistors of 25.0 ± 0.02 ohm are available. Which should be used to results in the lowest uncertainty, a series arrangement with the 25-ohm resistors or a parallel arrangement with the 100-ohm resistors? Calculate the uncertainty for each arrangement1a. Calculate the equivalent resistance of R4 and R5 1b. Adding the values of resistor R1 and R2 to R equivalent. Calculate the circuit resistance seen by the power source. 2a. Measure the total resistance across terminals A and D, using ohmmeter function of the electronic VOM. Make sure that switch S1 is in the open position. Measured Total Resistance in Multisim= 4.15kohms 2b. Does the measured total resistance agree exactly with your calculated resistance? ExplainFor the circuit below, determine the resistor voltage. The source is 5 volts, the Zener potential is 5.2 volts and the resistor is 1k ohms.
- Help with proper measurement of current through all resistors in the parrallel cirucit below, in multisim.A 0 – 150 voltmeter has a resistance of 2000-ohms per volt. It is desired to change this voltmeter to a 0 – 600 volt instrument by the edition of an external multiplier. What is the resistance, in ohms, of this external multiplier?Determine total resistance. Show circuit transformation and step by step solution thank you.