6Z60°S I2 16245°A 4Z30°S Figure 6

Q: NOTE: Average of periodic signal f (x) of period T is given by: t0+T 1 f(x)(ave) = 7 f(x) dx T to D1…

A: The solution is given below

Q: DD Rp C, RL Vn Given: VDD = 26 V R1 =17 kohms

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Question 1 Suppose one ammeter probe is placed on the low side of a component and the other probe is…

A: Solve the first question, unless the student has asked for a specific question to be solved,…

Q: (b) Two three-phase, 6.6-kV, Y-connected synchronous generators, operating in parallel, supply a…

A:

Q: (b) Determine the Z-transform and Region of Convergence (ROC) of: x[n] = {2,0, 2, 2,3, 0,0, 4}, n =…

A:

Q: Y2 a) ( 40L50 + 20 L-30)

A: Given, Y=40∠50°+20∠-30°12

Q: What is a Operational Amplifier and what it’s used  for?

A:

Q: Discuss the advantages of flux weakening operating regime in a DC motor.

A:

Q: Problem 2 Design the circuit shown so that vo(t) =;+Aje- +Aze- V for t> 0 Determine the values of…

A: Damping is a process occurring due to the resistance in the system, by which we can say whether the…

Q: For the given network, determine the signal voltage at the base ofthe transistor with I = 3.58 mA.…

A:

Q: 42. Find the average value of the periodic wavefom of Fig. 95 over one full cycle. i (mA) +30 oI 2 3…

A: We need to find out the average value of given waveform

Q: A 4-pole, 3-phase, 50 Hz induction motor has a voltage between slip-rings on open-circuit of 520 V.…

A:

Q: three transformers, connectd delta on the primary side and wye delta on the secondary side, step the…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: Three loads are connected in parallel to a 120 V source. Load 1 absorbs 60 kvar at pf = 0.85…

A:

Q: Calculate the closed-loop voltage gain, ACL, of an inverting op-amp circuit having an input…

A:

Q: find the sinusoid represented by the polar.

A: In this question,   We need to find the sinusoid represented by the polar

Q: Discuss the V/F=constant control method of electric motors.

A: V/f control: This is a method for controlling the speed of the motor in a specific range by making…

Q: hree 37.5kVa, single-phase transformers are connected in delta to suply 85kVa load at 85% lagging…

A: Given data, Three 37.5kVa, single-phase transformers are connected in delta. Load kVA is 85 kVA and…

Q: ° Can transistor can be used as a switch? ° What happens when the switch is off in a transistor

A: In this question,   We need to explain that Can transistor  be used as a switch?

Q: a) i = Gcos (50t - 40) AV = -4 sin Coot + 50)

A: We need to find out the phasor of current and voltage

Q: The figure below shows an electronic PID controller constructed using OP-AMPS. Determine the values…

A: We need to find out resistance value and resistance ratio for given circuit

Q: For the network function T(s) =7+2s +100° ,the resonant frequency and bandwidth are respectively.

A:

Q: 5+2)とけ)-C5L00) 10 +j 5+ 3L40 + 10 L30+ j5 - 3 + j4

A:

Q: , calculate the resonance frequency of the following circuit,

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+...........   Resistance in series-…

Q: An n -channel JFET has the following specifications: I Dss = 15 mA and V GS(off) =-4 V. Calculate…

A: In this question,   We need to choose the correct options  What is drain current ID  ?

Q: An industrial load consumes 94 kW at a power factor (pf) of 0.83 lagging from 490 Vrms line. The…

A: The solution is given below

Q: -j 202 j 50N +, 200230° 402 202 Figure 9.

A:

Q: The system function of a causal LTI system is 1+z¬! H(2) = (1 – 0.5z-1)(1+ 0.25z-1)' a) What is the…

A: The system function of a causal LTI system is: H(z)=1+z-1(1-0.5z-1)(1+0.25z-1) a) We need to find…

Q: Draw block diagram /circuit diagram of the ff. FM circuits and discuss the operation.   c. RATIO…

A: According to the question, we need to Ratio detector

Q: Write a boundary condition  equation  1. Dielectric to dielectric 2. Magneto dielectric to Magneto…

A:

Q: z, four-pole, induction motor connected in star

A: Three Phase Induction machine-This Induction machine comprises of rotor and stator as it basic parts…

Q: What are oscilloscope used for?

A: We need to state the use of an oscilloscope.

Q: Explain how an RC time constant may be measured experimentally

A: Time constant is defined as Time Required to reach 53% of the voltage from 0 in charging condition…

Q: (b) The parameters of the equivalent circuit for a three-phase. Y- connected. 22ov, 60HZ. six-pole…

A: In this question,   We need to determine the stator input current, power factor, air gap power and…

Q: 5445 A 20 I2 j20 -j20 1230v 212 j20 ll ll

A:

Q: Find V1 in the circuit shown if figure 2.

A: This question belongs to electrical circuit theory . It is based on the concept of kirchhoff's…

Q: The output voltage vo(t) across the parallel connection of the capacitor and a 20 resistor, the…

A:

Q: Design a broadband microstrip transformer operating at the center frequency fo=1 GHz to match a load…

A: It is a special transformer which is fabricated for the micro-strip. The strip is consider as the…

Q: If the signal has a spectrum (Fourier transform) given in Figure Q3, draw the spectrum of the…

A: We need to draw spectrum of sampled signal .

Q: 15. Find the Line and Phase Currents of the Circuit R1 L4 0.5mH R5 50 R6 V4 L1 L2 R2 L5 R4 30μH L3…

A: Given: Consider the following circuit: To find: The line and phase currents of the circuit.

Q: Determine the inductor current i(t) shown in the circuit below. t= 0 4Ω. i(t) 16 2 20 V 0.4 H v(1)…

A:

Q: (c) A 5O0KVA. 1100v. SOHZ. star connected. three- phase synchronous generator has per phase values…

A:

Q: 2. Express the value of H in rectangular components at P(2, 0, 0) in the field of: a. A current…

A: It is given that: P2,0,0

Q: Let Q, = 8 µC be located at P,(2, 5, -8) while Q, = -5 µC is at P2(6, -15, 8). Find F2, the force on…

A:

Q: 2 / 4 | 90% Problem 1 The circuits are excited by an ac voltage source of 120 V at a frequency of 60…

A:

Q: Suppose if the signal is about 0 - 12v and we have to used 16-bit ADC. What will be the output…

A: Given, Signal is about 0-12V 16 bit ADC is used.

Q: Q4. Determine the value of collector current and collector-to- emitter voltage for the voltage…

A:

Q: Q4/ Find the efficiency and the input resistance (Rin) of the amplifier in Figure 4. Assuming all…

A: For given Amplifier  Beta = 85 re = 15 ohms R1 = R2 = 750 ohms C1 = C2 = 22 micro Farad C3 = 150…

Q: 5. A 1.5 m length of wire moves perpendicular to a magnetic flux field of 0.75 T. Determine the…

A:

Q: sine wave resulting in an FM signal having a maximum frequency of 107.218 MHz and a minimum…

A: