7. Using a silica gel and nitrogen as adsopbent, the following adsorption isotherm data were obtained. p/po 0.055 0.061 0.077 0.094 0.120 0.158 0.177 0.209 0.240 0.270 0.300 0.330 0.352 nm(cm'/g) 131.3 134.3 139.9 148.9 153.5 164.0 169.3 176.9 184.5 192.3 200 207.7 212.7 Using BET analysis, obtain the surface area and parameter c.

7. Using a silica gel and nitrogen as adsopbent, the following adsorption isotherm data were obtained. p/po 0.055 0.061 0.077 0.094 0.120 0.158 0.177 0.209 0.240 0.270 0.300 0.330 0.352 nm(cm'/g) 131.3 134.3 139.9 148.9 153.5 164.0 169.3 176.9 184.5 192.3 200 207.7 212.7 Using BET analysis, obtain the surface area and parameter c.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Describe how does the extent of adsorption varies with pressure by freundlich adsorption isotherm?
Y. Temperature, K 303 K Time, min 44. Identify the region/s where solid NOOK can be observed. W/
A student conducted an experiment to determine the concentration of benzene in an ethanol solution. Use the UV spectrum of the solution in a 2.0 cm cell. Within the spectrum, there was a peak attributed to benzene at 260 nm, with an absorption of 0.69. In a reference source, the student found that the adsorption of the benzene strip with ethanol was 2.95 x 10-3 ppm cm-. What is the molar concentration of benzene in the sample (mm of benzene = 78.11 g/mol)
Given the BET isotherm plot is y = 123.961 x — 1.181. The surface area of the activated carbon was determined as 85±7 m2 /g. What was the mass of their sample of activated carbon for the adsorption of N2 gas?
An adsorbent surface has N no.of adsorption sites out of which 'n' fraction of sites are occupied . Draw a plot showing relation between 'n' and pressure
a. Sketch and explain the differences between adsorption isotherms of nanoporous adsorbent and porous adsorbent.
what is solution homogenous catalysis?
.A plot of a Langmuir adsorption isotherm (C/q vs 1/Q) for an adsorption process, gives a slope of 0.208 and intercept of 250. Calculate the adsorption capacity at equilibrium corresponding to monolayer coverage (0) A) 0.002 B) 4.8 C) 52 D) 1.2 x 10¹
A certain solid sample adsorbs 0.63 mg of CO when the pressure of the gas is 36.0 kPa and the temperature is 300 K. The mass of gas adsorbed when the pressure is 4.0 kPa and the temperature is 300 K is 0.21 mg. The Langmuir isotherm is known to describe the adsorption. Estimate the fractional coverage of the surface at the two pressures.
6. A dilute silver nitrate solution is added to a slight excess iodide solution. A solution of AgI is face adsorbs.chemohollic.com formed whose surface adsorbs. (a) I (b) NO3 + (c) Nat (d) Ag*
What is an adsorption isotherm? Describe Freundlich adsorption isotherm.
The adsorption equilibrium isotherm for aqueous phenol solution and activated carbon can be determined from the following data: c kg phenol/m3 solution q kg phenol/kg carbon 0.3220 0.150 0.1170 0.122 0.0390 0.094 0.0061 0.059 0.0011 0.045 Determine the appropriate isotherm for this experimental run