7.35 Arc-bot Technologies, manufacturers of six-axis, electric servo-driven robots, has experienced the cash flows shown in a shipping department. (a) Determine the number of possible rate of return values. (b) Find all i* values between 0 and 100%. Year Expense, $ Savings, $ 0 -33,000 0 1 -15,000 18,000 2 -40,000 38,000 3 -20,000 55,000 4 -13,000 12,000
Q: A blacksmith immersed a piece of steel at 600°F into a large bucket of water with a temperature of…
A: (1) Initial temperature of steel(2) Water temperature(3) After temperature of steel
Q: 1. A 1800 ft² sedimentation tank with a water depth of 12 feet is used to remove sand particies from…
A: V = 1800 ft3 H = 12 ft Gs = 2.65d = 0.001 cm or 10-5 m T = 15.6oC
Q: Find the centroid of the following cross-sections and planes.
A: Centroid is = (0, 9.427 in)Explanation:Step 1: Calculation for centroid of given section.Thanks.
Q: Discuss the concept of elasticity and plasticity in materials?
A: The ability of a material to respond to external loads through elasticity and plasticity is one of…
Q: 3(b) Another section of the highway has the Following Flow density relationship: q = 50k - 0.156 k²;…
A: 1) 4006.41 2) 25 3) 21.47Explanation:Step 1:Step 2:
Q: (1.181 x 10-5 in.) and a crack length of 4 x 102 mm (1.575 × 103 in.) when a tensile stress of 160…
A:
Q: Determine the forces in all bars. Indicate tension or compression
A:
Q: pump is to deliver water from an underground tank against a static head of 40m. The suction pipe 50m…
A:
Q: Traveling with an initial speed of 70 km/h, a car accelerates at 6000 km/h 2 alonga straight road.…
A: The detailed solution and explanation are attached belowExplanation:
Q: Find the centroid of the following cross-sections and planes.
A: X = 7.4194Y = 5.1452Explanation:Step 1:Step 2:Step 3:
Q: Service Engineering
A: a) The cost of pumping water continuously for one fortnight, with a mandatory cool down of four…
Q: Tests reveal that average drivers take about 0.75 s before they can react to asituation to avoid a…
A: Average driver takes 517 ft to stop the car after seeing the pedestrians Alcoholic driver takes 616…
Q: of A1 = 1.95 in.2. and yield stress of σy = 150 ksi; member (2) has a cross-section area of A1 = 9.2…
A:
Q: A pressure increase of 250 kPa is imposed across a wide region above the depicted soil profile. The…
A: The objective of this question is to determine the settlement of the clay layer 40 days after the…
Q: Determine the factor of safety with an applied load of 500 kN. The six bolts are in single shear…
A: d = 32 mmPa = 500 kN
Q: Solve for the global equilibrium equations and find the internal force of the beam
A:
Q: please expain the bearing calculation to feet
A: Solutions and final answer abd sketch of curve are provided in the image thank you.Explanation:
Q: 2(a) c) The average length of each vehicle in a traffic stream is 7.0M, and the average distance…
A: Jam density = 111.11 vehicles/kmSpeed at Max flow = 43.24 km/hrExplanation:
Q: What types of French construction methods were commonly used and how did they differ from each one ?…
A: French construction has long employed a number of traditional techniques, each with specific traits…
Q: How is a total station used in modern surveying?
A: A total station is a sophisticated surveying instrument that integrates the capabilities of an…
Q: Determine the forces in all bars of the trusses indicate tension or compression
A: MemberForceNatureAB180 kNTensionAG225 kNTensionGH315 kNCompressionBG180 kNCompressionBC67.5…
Q: Explain the concept of drought and its impacts on hydrology.
A: Drought is a naturally occurring phenomenon where unusually low precipitation is experienced for a…
Q: A four-lane basic freeway segment on level terrain is being redesigned. The current roadway has 12…
A: Given:- Current roadway: 4 lanes, each 12 ft wide, with 4 ft shoulders- Proposed roadway: 6 lanes,…
Q: A liquid compressed in a container has a volume of 1 liter at a pressure of 1 MPa and a volume of…
A: The objective of the question is to verify if the given bulk modulus of elasticity of the liquid is…
Q: Evaporation and Transpiration
A: To compute the consumptive use for each month and determine the necessary irrigation amount for both…
Q: 15. Traffic volume during a stable free-flowing condition is 600 veh/h with an average speed of 75…
A: The average speed of traffic under congested situation is 15 km/hr Note: Please refer to the…
Q: A soil sample with a layered soil is placed in a tube 3m long. water is allowed to flow in the one…
A: The detailed solution and explanation are attached below.Explanation:Step 1: Step 2:
Q: A state government is planning to construct a new highway to connect two cities. The proposed…
A: Given information:Length of the highway: 50 miles (we need to convert this to feet, knowing that 1…
Q: Traveling with an initial speed of 70 km/h, a car accelerates at 6000 km/h 2 alonga straight road.…
A: Answer - 1) Time required to reach 120km/h is 30.244 sec 2) The distance travelled by car is 799.654…
Q: What are the fundamental requirements for creating a good presentation?
A: The fundamental requirements for creating a good presentation are discussed in detail…
Q: Show Transcribed Text 3 S + 1.5 m 1 m The boom supports the two verical loads. Neglect the size of…
A: F1 = 800 NF2 = 350 N
Q: step by step solution
A: The solution is given below.Explanation:Approach to solving the question: Detailed explanation:…
Q: Show step by step solution
A: The solution is given below.Explanation:Approach to solving the question: Detailed explanation:…
Q: H 5 m 2 m
A:
Q: The steel member shown below has a diameter of 69 mm, modulus of elasticity of E=200 GPa, and is…
A: (1) The diameter of steel member(2) Modulas of elasticity(3) The lengths,…
Q: Calculate the distribution storage needed for equalization storage based on the following peak…
A: Let's go through the peak hourly data and find the maximum demand:12. Peak hourly demand at 6 pm:…
Q: Discuss the role of traffic calming measures in reducing vehicle speeds?
A: Traffic calming measures encompass the various approaches and activities employed during road…
Q: Question: Given: a = 0.4 m b=0.1 m A B F₁ = 800 Kn 0.7 m F₂ = 912 kN 1 m M₁ = 400 kNm 1) Find the…
A:
Q: Show step by step solution
A: FINAL ANSWER:- Therefore,the minimum coefficient of friction is 0.2167.Explanation:
Q: Determine the vertical deflection at D (DDY) by used virtual work 500kg/m B 티 5,000kg/m 2EI 0 T E…
A:
Q: Show step by step solution
A: The velocity of the jet is 12.1 bt/s, and the diameter of the jet is 4.28 inches. Therefore, there…
Q: The yield strength for an alloy that has an average grain diameter of 4.6x102 mm is 112 MPa. At a…
A:
Q: Estimate the height which water will rise in a capillary tube 12mm diameter. Use surface tension =…
A: The objective of the question is to calculate the height to which water will rise in a capillary…
Q: 22, A folding chair diagram is shown in the following. Determine the pin reactions at each joint,…
A: Note : Dear sudent as per our Bartleby guidelines i am solving first problem only (i.e. problem 2.2…
Q: Refrigerant-134a at 300 psia has a specific volume of 0.2235 ft³/lbm. Determine the temperature of…
A: Answer Explanation:Step 1: Step 2: Step 3: Step 4:
Q: Discuss the factors influencing the economic feasibility of pressurized flow projects?
A: Pressurised flow projects use pressurised tubes to effectively transport water to different…
Q: Describe the process of environmental impact assessment (EIA) in transportation projects.
A: Environmental Impact Assessment (EIA) is a process of evaluating the impacts on environmental and…
Q: 不 1 m 1.5 m 3 m E Air, p = 32 kPa Oil, s = 0.80 Water Glycerin, s = 1.26 LL F cg 60° D
A:
Q: The assembly shown consists of a flywheel, a counterweight, and a bolt that attaches the…
A: (1) Mass per area of flywheel and hole diameter(2) Mass of the bolt and hole diameter
Q: 20) Suppose Vishal goes for a long jog. During his journey: He travels 25 m east, Then 50 m at…
A: Magnitude: 16.61 mAngle: 46.95° North of EastReference: starting from where vishal's start.…
Without using excel. (A) Determine the number of possible rate of return value. (B) Find all i* values between 0 and 100%
Trending now
This is a popular solution!
Step by step
Solved in 1 steps
- Suppose your firm is considering investing in a project with the cash flows shown below, that the required rate of return on projects of this risk class is 12 percent, and that the maximum allowable payback and discounted payback statistics for your company are 2.5 and 3.0 years, respectively. Time: Cash flow: 0 1 2 3 -$227,000 $65,000 $83,200 $140,200 4 $121,200 5 $80,400 Use the payback decision rule to evaluate this project. Note: Round your answer to 2 decimal places. Payback yearsA cutting-edge product of Continental Fan had the following net cash flow series during its first 5-year period on the market. Find all rate of return values between 0% and 100%. Year Net Cash Flow, $ -56,000 38,000 2 30,000 3. 11,000 -1,000 14,000 The rate of return is %.The cash flows and initial investment for two different projects are given below. Calculate the internal rate of return for the projects. Based on IRR identify which project should be accepted. (Higher rate take value between 18% & 20%. Years Project X Project Y 130,000 85,000 1 25,000 40,000 2 35,000 35,000 3 45,000 30,000 4 50,000 10,000 5 55,000 5,000 Cost of capital 12% 12%
- 2. Attach a complete solution. Draw the cash flow diagram. Suppose that P 4500 is deposited each year into a bank account that pays 8% interest compounded quarterly. How much would be accumulated in his fund by the end of the 4th year? The first payment occurs at time zero (now).Q3:How much money must you deposit in year 6 if you deposit $5000 now and you want to have $12,000 at the end of year 11? Assume your deposits earn interest at 6% per year. [40 marks]Calculate the equivalent present worth (PW) of the following cash flows. Use an interest rate of 8% per year. Year Cash flow, $ 0 -43200 1 5000 2 5000 3 10000 4 15000 5 20000 6 25000 30000 (O 7 Select one: O a. 44747.7 O b. 42247.4 O c. 31547.7 O d. 36747.7 O e. 41047.7
- 4- The cash flows have a present value of 0. Compute the value of J, assuming a 6% interest rate. 15 1000 1000 1000 0-1 —3—Compute the initial value of the money if the barrower needs deposit the accumulated amount of P59,137 to the bank after 8 months and 24 days if the money has the interest rate of 19% per annum.2. If the price/demand function is p-50-1.25x and the total cost function is 160+10x, where x is the number of units (D) in thousands and cost is in dollars, determine the following; a. General Equation of the Total Profit (profit function) b. General Equation of the Total Revenue (revenue function) Breakeven points Note: Put Final Answer in the yellow box C.
- 8- Consider four mutually exclusive and a do-nothing 15 alternatives, each having an 10-year useful life: A В C D First cost $1000 $800 $600|$500 Uniform annual |125 |120 |100 | 125 benefit Salvage value 750 500 250 0 (a) Construct a choice table for interest rates from 0% to 100%. (b) If the minimum attractive rate of return is 8%, which alternative should be selected?Quèstion 38 Find the amount at the end of 4 years and 9 months if P3,000 is invested at 979% compounded qualterly, using simple interest for anytime less than a year interest period Express your answer in 2 decimal places. Question 38 of 50 A Moving to another question will save this response acer F7 F8 F9 F10 F11 F12 PrtSc Pause Del Home Scr Lk SysRa Break Ins & * Bac 8 P G KFind the equivalent annual payment of the following obligations at 20% interest rate. End of Year Payment 1 P 8,000 2 P 7,000 3 P 6,000 4 P 5,000