A 120.0-V motor draws a current of 6.54 A when running at normal speed. The resistance of the armature wire is 0.584 (a) Determine the back emf generated by the motor. (b) What is the current at the instant when the motor is just turned on and has not begun to rotate? (c) What series resistance must be added to limit the starting current to 15.0 A? (a) Number i Units (b) Number i Units (c) Number i Units

A 120.0-V motor draws a current of 6.54 A when running at normal speed. The resistance of the armature wire is 0.584 (a) Determine the back emf generated by the motor. (b) What is the current at the instant when the motor is just turned on and has not begun to rotate? (c) What series resistance must be added to limit the starting current to 15.0 A? (a) Number i Units (b) Number i Units (c) Number i Units

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Faraday’s Law

Section: Chapter Questions

Problem 31.48P: A motor in normal operation carries a direct current of 0.850 A when connected to a 120-V power...

See similar textbooks

Similar questions

A small series-wound dc motor is operated from a 12-V car battery. Under a normal load, the motor draws 4.0 A, and when the armature is clamped so that it cannot turn, the motor draws 24 A. What is the back emf when tire motor is operating normally?
The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
. The generator at a large power plant has an output of 1,000,000 kW at 24,000 V. (a) If it were a DC generator, what would he the current in it? (b) What is its energy output each day—in joules and in kilowatt—hours? (c) If this energy is sold at a price of 10 cents per kilowatt-hour, how much revenue does the power plant generate each day?
Check Your Understanding For the circuit of in Figure 14.12(b), show that when steady state is reached, the difference in the total energies produced by the battery and dissipated in the resistor is equal to the energy stored in the magnetic field of the coil.
A motor in normal operation carries a direct current of 0.850 A when connected to a 120-V power supply. The resistance of the motor windings is 11.8 . While in normal operation, (a) what is the back emf generated by the motor? (b) At what rate is internal energy produced in the windings? (c) What If? Suppose a malfunction slops the motor shaft from rotating. At what rate will internal energy be produced in the windings in this case? (Most motors have a thermal switch that will turn off the motor to prevent overheating when this stalling occurs.)
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
Check Your Understanding. A changing current induces an emf of 10 V across a 0.25-H inductor. What is the rate at which the current is changing?
Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?
Does the induced emf always act to decrease the magnetic flux through a circuit?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
A DC servo motor produces 10 milli N-m torque (Tm) with current (im) of 0.25 A with a DC supply (vm) of 20 V. The terminal resistance of the motor (Rm) is 8 Q. What is the torque constant k, of the motor? If the back-emf constant km is the same as the torque constant, what is the back-emf at this condition? What is the speed of the motor in rotations per minute? Assume that the motor operates at steady-state: im(t) = im and wm (t) = Wm.