A 50 ml sample taken from a vinegar sample was diluted to 500 ml with distilled water. The 25.0 mL aliquot from this solution is titrated with a 25.1 ml of 0.1065 M NaOH by adding 3 drops of phenolphthalein. What is the mass/vol. percentage of acetic acid? If the density of the vinegar solution is 1.02 g / mL? Compare the m/m and m/V percentages?

A 50 ml sample taken from a vinegar sample was diluted to 500 ml with distilled water. The 25.0 mL aliquot from this solution is titrated with a 25.1 ml of 0.1065 M NaOH by adding 3 drops of phenolphthalein. What is the mass/vol. percentage of acetic acid? If the density of the vinegar solution is 1.02 g / mL? Compare the m/m and m/V percentages?

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter9: Acids, Bases, And Salts

Section: Chapter Questions

Problem 9.99E

See similar textbooks

Similar questions

95. Many metal ions form insoluble sulfide compounds when a solution of the metal ion is treated with hydrogen sulfide gas. For example, nickel(II) precipitates nearly quantitatively as NiS when H2S gas is bubbled through a nickel ion solution. How many milliliters of gaseous H2S at STP are needed to precipitate all (he nickel ion present in 10. mL of 0.050 M NiCl2 solution?
An acid is titrated with NaOH. The following beakers are illustrations of the contents of the beaker at various times during the titration. These are presented out of order. Note: Counter-ions and water molecules have been omitted from the illustrations for clarity. (a) (b) (c) (d) (e) a. Is the acid a weak or strong acid? How can you tell? b. Arrange the beakers in order of what the contents would look like as the titration progresses. c. For which beaker would pH = pKa? Explain your answer. d. Which beaker represents the equivalence point of the titration? Explain your answer. e. For which beaker would the Ka value for the acid not be necessary to determine the pH? Explain your answer.
A sample of solid calcium hydroxide, Ca(OH)2, is allowed to stand in water until a saturated solution is formed. A titration of 75.00 mL of this solution with 5.00102M HCl requires 36.6 mL of the acid to reach the end point. Ca(OH)2(aq)+2HCl(aq)CaCl2(aq)+2H2O(l) What is the molarity?
An artificial fruit beverage contains 12.0 g of tartaric acid, H2C4H4O6, to achieve tartness. It is titrated with a basic solution that has a density of 1.045 g/cm3 and contains 5.00 mass percent KOH. What volume of the basic solution is required? (One mole of tartaric acid reacts with two moles of hydroxide ion.)
Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
Describe how the amount of sodium hydroxide in a mixture can be determined by titration with hydrochloric acid of known molarity.
Nickel(II) formate [Ni(HCO2)2] is widely used as a catalyst precursor and to make metallic nickel. It can be prepared in the general chemistry laboratory by treating nickel(II) acetate with formic acid (HCO2H). Ni(CH3CO2)2(aq) + 2 HCO2H(aq) Ni(HCO2)2(aq) + 2 CH3CO2H(aq) Green crystalline Ni(HCO2)2 is precipitated after adding ethanol to the solution. (a) What is the theoretical yield of nickel(II) formate from 0.500 g of nickel(II) acetate and excess formic acid? (b) Is nickel(II) formate paramagnetic or diamagnetic? If it is paramagnetic, how many unpaired electrons would you expect? (c) If nickel(II) formate is heated to 300 C in the absence of air for 30 minutes, the salt decomposes to form pure nickel powder. What mass of nickel powder should be produced by heating 253 mg of nickel(II) formate? Are nickel atoms paramagnetic?
Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the formula KHC8H4O4. This is often written in the short-hand notation as KHP. If 25.0mL of a potassium hydroxide solution are needed to neutralize 2.26g of KHP, what is the molarity of the potassium hydroxide solution? Potassium hydrogen phthalate sometimes called potassium biphthalate, as shown on this bottle is an acid that is convenient to store and use because it is a solid.
What mass of solid aluminum hydroxide can be produced when 50.0 mL of 0.200 M Al(NO3)3 is added to 200.0 mL of 0.100 M KOH?
A 0.500-L sample of H2SO4 solution was analyzed by taking a 100.0-mL aliquot and adding 50.0 mL of 0.213 M NaOH. After the reaction occurred, an excess of OH ions remained in the solution. The excess base required 13.21 mL of 0.103 M HCl for neutralization. Calculate the molarity of the original sample of H2SO4. Sulfuric acid has two acidic hydrogens.