A black oil reservoir has been just discovered. The reservoir pressure is above the bubble point pressure. A flow rate of 88.4 bbl/d entering the well from the reservoir at the bottomhole was measured. The oil is processed through a two stage separation system that is a separator and a stock tank system. A 56.2 STB/D of 44.5 API oil is produced at the stock tank. The gas production rate of the separator is 45000 SCFD of 0.74 specific gravity gas and the stock tank produces 7400 SCF/D of 1.2 specific gravity gas. Using the above data, you are asked to calculate a. formation volume factor of the oil b. the solution gas oil ratio c. which one of the previous answer applies at the bubble point. d. the density of the stock tank oil

A black oil reservoir has been just discovered. The reservoir pressure is above the bubble point pressure. A flow rate of 88.4 bbl/d entering the well from the reservoir at the bottomhole was measured. The oil is processed through a two stage separation system that is a separator and a stock tank system. A 56.2 STB/D of 44.5 API oil is produced at the stock tank. The gas production rate of the separator is 45000 SCFD of 0.74 specific gravity gas and the stock tank produces 7400 SCF/D of 1.2 specific gravity gas. Using the above data, you are asked to calculate a. formation volume factor of the oil b. the solution gas oil ratio c. which one of the previous answer applies at the bubble point. d. the density of the stock tank oil

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. A wastewater is treated in an aerobic CSTR with no cell recycle. The following hold: Ks= 50mg/l; q^=5mg/mg VSSa-d; Kd= .06d-1; Y= 0.6; S°=220mg/l; fd= 1
2. Given: Process tank shown below Find: (1) total surface area and (2) volume -3 m +3 m- 6m 4 m
Suppose that 1-L graduated cylinder in the figure as shown below contains a sludge of 1 percent solids. Now suppose that all of the solids are allowed to settle and that the liquid is decanted until the total volume is 500 ml. The new solid fraction is 1000 mL 750 mL 500 mL 250 mL (a) (b) (c)
9. A core sample is saturated with Oil, Gas and Water , the initial weight of the saturated sample is 220 gm . After the gas is displaced by water , the weight is increased to 222gm. the sample is then placed in soxhlet distillation apparatus , only 5cc of water was extracted .After cleaning and drying the core , the weight was 210 gm .the sample bulk volume is 100 cc , Pw = 1 gm /cc . Po =0.85 gm/cc .Calculate the effective porosity , Absolute porosity, the saturation of Oil, water and gas .
1. An oil of sp. gr. 0.9 is contained in a vessel. At a point the height of the oil is 50 m. Find the corresponding height of water at the point.
A separator accepts waste oil at 70% oil and 30% water by weight. The top product stream is pure oil while the bottom underflow contains 10% oil. If a flow of 20 gal/min is fed to the tank, how much oil is recovered? Two methanol-water mixtures are contained in a separate flask. The first mixture contains 40% w methanol and the second contains 70% w. If 200 g of the first mixture is combined with 150 g of the second, what are the mass and composition of the product?
A certain liquid flows in a 10 mm diameter smooth pipe that is 20 m long. The total head lost in the pipe is 30 m and the Reynolds number is 1,800. What is the value of the discharge?
A storage tank of a treatment water has a holding capacity of 750 m' up to an overflow point. The treatment water having silica content of 0.003 mg /L is flowing in to a tank at a rate of 30 L/sec. the out flow from the tank to the high pressure boilers is 30 L/sec. With time the quality of treatment water increased to 0.025 mg/L. Assuming that the inflow in to and out flow from the tank remains constant at 30 L/sec, calculate the time required for the silica content in the storage tank to increase to 0.01 mg/L.
Glycerin (specific gravity 1.26) in a processing plant flows in a pipe at a rate of 805 L/s. At a point where the pipe diameter is 765 mm, the pressure is 300 kPa. Find the pressure at a second point where the pipe diameter is 300 mm if the second point is 1.0 m lower than the first point, neglect the head loss
Home Work 3.A core sample is saturated with an oil (po = 35°API), gas and water. The initial weight of the sample is 224.14 g. After the gas is displaced by water (pw = 1 g/cm'), the weight is increased to 225.90 g. The sample is the placed in a Soxhlet distillation apparatus, and 4.4cm water is extracted. After drying the core sample, the weight is now 209.75 g. The sample bulk volume, 95 cm3 is measured in a mercury pycnometer. Find the porosity, water saturation, oil saturation, gas saturation and lithology of the core sample.
When the accumulated liquid along the bottom of the pipe or in a well reaches a certain level and "plugs" the pipe, the higher velocity gas gets blocked. Select one: O True O False
1. A wastewater is treated in an aerobic CSTR with no cell recycle. The following hold: Ks= 50mg/l; q^=5mg/mg VSSa-d; Kd= .06d-1; Y= 0.6; S°=220mg/l; fd= 1 a. Determine Ɵcmin, Ɵclim, Smin