A Hittorf cell fitted with silver-silver chloride electrodes is filled with HCl solution that contains 0.3856 x 10-3 g HCL per g of water a current of 2 mA is passed for exactly three hours. The solutions are withdrawn, weighed and analysed. Total weight of the anode solution weighs 52.0461 g and contains 0.0133 g of HCl. Calculate the transference number of the H+

Q: The electrolysis cell shown here was run at a constant current of 0.021 96 A. On one side, 49.22 mL…

A: (a) The volume of H2 gas produced at STP is calculated using the combined gas law as shown below,…

Q: A bare silver wire electrode is dipped into a solution 0.05M in KNO3 (supporting electrolyte) and…

A: Given information: Concentration of potassium nitrate = 0.05 M Solubility product of AgBr =…

Q: Pt | H2 (g, 1.00 bar) | HCI (5.00E-4 M) || KCI(0.100 M) | Hg) | Hg2Cl2¢s) (s)| The anode in the…

A: In an electrochemical cell, the reaction that takes place is a redox reaction. In one of the…

Q: Black-and-white photographic film is coated with silver halides. Because silver is expensive, the…

A: Note - Since you have posted a question with multiple sub-parts, we are bound to solve only the…

Q: A pH meter is calibrated using a pH 4.00 buffer with 174.48 mV, pH 7.00 with 0 mV and pH 10.0 buffer…

A: Given data: pH  E (mV) 4 174.48 7 0 10 -174.48 To determine: The Molar concentration of…

Q: Ti³+ is to be generated in 0.10 M HCIO for coulometric reduction of azobenzene. TiO²+ + 2H+ + e Ti³+…

A:

Q: The concentration of Ca²+ in a sample of sea water is determined using a Ca ion-selective electrode…

A:

Q: Calculate the elecytomotive force (in volts) registered by an electrode immersed in a solution…

A: Given that

Q: Telephone Number: 7738-17 Email: tpchrdnova@gmail.com NAME: GRADE & SECTION: SUBJECT TEACHER:…

A:

Q: Calculate the elecytomotive force (in volts) registered by an electrode immersed in a solution…

A:

Q: Calculate the elecytomotive force (in volts) registered by an electrode immersed in a solution…

A: To calculate the electromotive force registered by an electrode we must use the nernst equation.

Q: A domestic water pipe is suspected to be contaminating drinking water with lead. In order to test…

A: Answer is in next part

Q: Calculate the maximum amount of work (per mole reaction) that can be obtained from the following…

A: a. Given, a galvanic cell is constructed between Au3+ and Cu2+. Au3++3e-→Au     E°=1.50VCu2++e-→Cu+…

Q: At 25C, you conduct a titration of 20.00 mL of a 0.0400 M AgNO3 solution with a 0.050 M NaI solution…

A:

Q: 159. A ga Cu(s) E° = 0.34 V Cu*(aq) + 2e¯ v²*(aq) + 2e¯ –→ V(s) - E° = -1.20 V - In this cell, the…

A: According to the electrochemical series, Cu (copper) lies below the V (Vanadium). elements which…

Q: impure

A: According to this law,  mass diposite on cathode is direactly proportion to the current.  So,…

Q: The purity of a sample of K3Fe(CN)6 is determined using hydrodynamic voltammetry at a glassy carbon…

A: a)   Here, the similar chemical is used for calibration, but is not added to the sample to be…

Q: During an electrolysis process a current of 3.20 amperes was used for a period of 2 hours and 49…

A: The charge deposited is given by, Q=It where I is the current and t is the time.

Q: A galvanic cell was constructed with a nickel electrode that was dipped into 1.5 M NISO4 solution…

A:

Q: A dilute NaNO; solution is to be electrolyzed with a pair of Pt electrode at a current density of…

A: Principle:A spectrophotometric determination using a reaction between nitrite,suphanilamide and…

Q: The following electrochemical cell was constructed at 298 K. C. Co(s)CoSO4j|NISO4NI(s) E° Co2*Co =…

A:

Q: How much time would it take for 325 mg of copper solid (atomic molar mass = 63.546 g/mol) to be…

A: Two moles of electrons give one mole of copper atom. Number of electrons required is determined as…

Q: Purification of chromium can be achieved by electrorefining chromium from an impure chromium anode…

A: In the process, the Cr3+ is converting to Cr. Hence the reaction taking place can be written as Cr3+…

Q: How long does it take to deposit a coating of gold 1.00 μm thick on a disk-shaped medallion 4.00 cm…

A:

Q: The apparatus shown in the picture was used to measure the cell potential during the titration of…

A: The following reaction occurs during the mentioned titration.…

Q: Purification of chromium can be achieved by electrorefining chromium from an impure chromium anode…

A: It will take approximately 737.43 hours

Q: Calculate the potential of a platinum electrode (! inert) immersed in a solution prepared by…

A: Given- Platinum electrode. Concentration of KBr = 0.0100 M  To find- Potential of platinum…

Q: The conductivity of a 0.1 M [Co(NH3)6]Cl3 solution in an electrolytic cell containing an electrode…

A: Given conductance = 1.5×10-³ S  electrode with a length of 0.15 cm and a cross-sectional area of 2…

Q: 1. Predict the products at anode and cathode and write half-cell reactions of the following…

A: i) CaS (l) :  Ca+2 , S-2 ions When inert electrode like Pt are used , in the case of molten CaS is…

Q: The initial potential you measure is 219.3 mV and the temperature of the solution is 23.8 Celsius.…

A:

Q: The concentration of H2S in wastewater samples was determined by coulometric titration using Kl as…

A: The explanation is given below-

Q: In a galvanic cell the cathode is an Ag+11.00 M2>Ag1s2 half-cell. The anode is a standard…

A:

Q: How long does it take to deposit a coating of gold 1.00 μm thick on a disk-shaped medallion 4.00 cm…

A: Introduction :  According to the Faraday first law of electrolysis, the amount of chemical reaction…

Q: How long would it take to deposit 50.0 mg Cu at the cathode of an electrolysis cell containing 6.0 M…

A: Weight of Cu = 50.0 mg = 50.0 × 10-3 gm = 0.050 gm (1gm = 1000 mg) Current (i) = 150 mA = 0.150 A…

Q: H2S content can be determined quantitatively via coulometric titration. In this case, I3 was used as…

A: By using Faraday's law of electricity one can determine the equivalent of weight of electrolyte…

Q: On the basis of electrode potentials from standard emf series, analyze corrosion behavior of…

A:

Q: (i) Combustion of Benzene produces carbon rich sooty flame. Standard Hydrogen Electrode (SHE) is…

A: Aromatic compounds are those compounds which have a cyclic conjugation, are planar and obey Huckel's…

Q: applied potential difference of 0.275 V

A:

Q: The concentration of H2S in wastewater samples was determined by coulometric titration using Kl as…

A: The absolute amount of analyte in a coulometric analysis is determined by applying Faraday’s law :…

Q: A. What is the cell notation of the set-up? B. What is the standard cell potential (Eºcell)? C. If…

A:

Q: [K;Fe(CN)s] (mM) limiting current (µA) 2.0 127 4.0 252 6.0 376 8.0 500 10.0 624

A: The two major types of calibration are- 1. One point calibration which involves the use of standard…

Q: why the reference electrode can serve as a probe to measure relative reduction potentials or even…

A: In any electrochemical experiment, in order to measure the electrode potential you need to introduce…

Q: Calculate the volume of hydrogen produced at r.t.p. when a concentrated aqueous solution of sulfuric…

A:

Q: A container made of steel, having base dimensions of 100 x 150 mm and a wall thickness of 10 mm is…

A: Solution Corrosion is one in every of the foremost common phenomena that we have a tendency to…

Q: A current is passed through 500.0 mL of a solution of Cal2. The following electrode reactions осcur:…

A: Given data, Volume of solution = 500mL Moles of I2 = 35.7mmol The overall reaction for the given two…

Q: How long does it take to deposit a coating of gold 1.00 µm thick on a disk-shaped medallion 4.00 cm…

A:

Q: An unstirred solution of 2.00 M NaCl was electrolyzed for a period of 28.9 min and then titrated…

A: Concentration of NaCl = 2M Time duration of electrolysis = 28.9min Concentration of HCl = 0.314M…