Problem: A parallel circuit comprises of a resistor of 2002 in series with an inductive reactance 150 in one branch and a resistor of 3002 in series with a capacitive reactance of 2002 in the other branch. Determine the current and power dissipated in each branch if the total current drawn by the parallel circuit is 102-30°A

Problem: A parallel circuit comprises of a resistor of 2002 in series with an inductive reactance 150 in one branch and a resistor of 3002 in series with a capacitive reactance of 2002 in the other branch. Determine the current and power dissipated in each branch if the total current drawn by the parallel circuit is 102-30°A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.6MCQ

See similar textbooks

Similar questions

The inductive circuit has ___________________ value of reactive power. a-Both positive and negative b-Zero c-Negative d-Positive
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
question will save this response. UP O1 Question 2 All of the following are correct definitions except The voltage lags the current in a capacitive circuit by 90 degrees O. The current and voltage are in phase a purely resistive circuit The current lags the voltage in an inductive circuit by 90 degrees The current and voltage are in phase a capacitive circuit AMoving to another auection vdl cave this response
Value of series impedance if inductance is 4mH , resistance is 40 ohm and frequency is 50 Hz.
In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance 5H. The circuit breaker interrupts a magnetizing current of 5 A (peak value). Arrangement shown in figure V-79 kV L-5 H 0000 R-790 www CB CH0.32PPC Fault (F)
Determine the symmetrical components of the three currents Ia = 10cis0, Ib = 10cis230, Ic = 10cis130 A.
An inductive circuit is parallel with a resistive circuit of 20ohms is connected across a 50Hz supply. The inductive current is 4.3A and the resistive current is 2.7A. The total current is 5.8A, find the power factor of combined circuit.
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
Add the following two impedances (a) in series and (b) in parallel. Z1 = 4 + 3i and Z2 = 12 + 5i
Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms
Use the information below to answer questions 24 und 25. The voltage across and the current through a load are (10+ j5Y and (2-jiArespecively. 24. What is the reactive power in VArconsumed? D. 0 A. 15 C. 20 D. 25 25. What is the pawer factor of the load? A. 0.8 leading B. 0.8 Jagging. -D. 0.6 ligging C 0.6 leading
4. A 10A current is lagging the voltage by 47° and a 12A current is lagging the voltage by 58°. What is the total current in this situation?