A resistor is connected in series with a resistor to an A/C power supply. If Xc = 15 and the resistance is 10 №, draw the power triangle and calculate the power factor.

Q: Square wave: even or odd function? -5 1 0 -1 5

A: asked to find the given waveform is odd or even.

Q: Fixed electrical equipment which may produce arcs or sparks shall be totally enclosed if located…

A: answer: given that to find minimum feet should be maintained to prevent arcs above the floor in…

Q: For the following circuit, the time-constant for t> 0 is most nearly: 2r MM a) 0.2 ms b) 0.2 s c)…

A: Time constant :- It is the time taken by the response to reach 63.2 % of it’s steady state value…

Q: 2. Compute carry and overflow flags in the following table. Carry Overflow Operation 0100 0110 0101…

A:

Q: Solve c) and d) only showing all the steps and K-map

A: It is given that: c) fr,s,t=rt'+r's'+r'sd) fx,y,z=M0M5

Q: Draw the wiring diagram of DELTA DVP-SS2 | plc

A: We have to Describe and Draw the diagram of DELTA DVP-SS2

Q: Consider GaAs at room temperature having the electron concentration of 5 × 10¹6 /cm³. The mobility…

A:

Q: 4) Draw a circuit diagram of a Static Synchronous Series Compensator (SSSC) and gives his…

A: It is asked to solve subpart 4,5 and 6.   There are different types of FACTS controller which are…

Q: Find V2 in order to make Vo=-7.5V

A:

Q: The emf induced in a conductor of machine driven at 600 rpm, the peak value of flux density is 1…

A:

Q: Right choice for the blank: In a. polar b. bipolar encoding, we use three levels: positive, zero,…

A:

Q: PART I. Given the electrical system below: v(t) (+ 2 H 0000 2592 ww 292 2 H MW-0000 VL(1) (:,…

A:

Q: C1 R1 VI(0) H W V2() VI(0) Ds².Es. F As².Bs.C F: 502 C2 R2 ww V2(0) VI(s) Ds². Es FV2() 2 As Bs C

A:

Q: From the figure, the voltage Vc t>0 is equal to what?

A: We need to find the voltage Vc(t) for t>0.

Q: In the figure shown, if t = 0.3 mS, v1 is equivalent to * 0.707 V OV 0.5 V O 1 V H = 200µs/div and…

A: In this question We need to determine the value of voltage V1 (t) at time t= 0.3ms Assume sinusoidal…

Q: Write a conclusion about : MODELLING OF 3 PHASE POWER SYSTEM USING MATLAB SIMULINK SOFTWARE .

A: Given: Write a conclusion about: MODELLING OF 3 PHASE POWER SYSTEM USING MATLAB SIMULINK SOFTWARE.

Q: 9. Label all connections required for the Function F(A,B,C) = m (0,3,4,5,6,7) to be implemented with…

A: It is given that: FA,B,C=∑m0,3,4,5,6,7

Q: Related Problem What type of gate should be used to detect if all three landing gears are retracted…

A: Given:

Q: The diagram below depicts an RC circuit where C= 1.55μ F, R₁ = 200, R₁ = 14, R₂ = 14.50, and V = 3.5…

A:

Q: A narrow band frequency modulated (NBFM) signal is given by s(t) = 2cos (2nfet) + 0.2 sin(2πfmt…

A: Given data st=2cos2πfct+0.2sin2πfmt+0.2πsin2πfct Carrier frequency, fc=140 kHz Message frequency,…

Q: Q1 f(x) = {x . Calculate the Fourier Transform of - 1<x< 1 otherwise

A: In this question We need to determine the Fourier transform of the signal f(x).  We know Formula of…

Q: 10.44 Find all currents and voltages in the network in Fig. P10. 12/0° V +1 ww I 1Ω + V₁ - 1:2 Ideal…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: The Thevenin voltage for the circuit is A) 5.0 V B) 10 V C) 6.67 V D) 8.33 V

A: Given data, Circuit diagram is given as,

Q: Determine V2 applying nodes analysis and if the voltage and current source increase the triple, how…

A: The given circuit diagram is shown below,

Q: Consider a series RLC circuit with L = 0.5H, C = 3.0 μF, R = 10.02 is connected to an AC voltage…

A: Given: L = 0.5H, C = 3μF, R=10Ω and V = 10V. Need to calculate the quality factor of series and…

Q: In the figure shown, v1 lags v2 by * 90° 60° -90° -60° 13 1/1 12 H = 200µs/div and V₂ = 0.5V/div

A:

Q: Q5 (answer on the lab worksheet): Imagine that you are using the circuit in Figure 3 to convert a…

A: Types of Operational amplifier  Inverting amplifier  Non inverting amplifier

Q: 1. Referring to the signals shown in Fig. 1: a) Find the signal energy of x(). b) Find the signal…

A: Given: Signals x(t) and y(t) as,  To find: a) Signal energy of x(t). b) Signal energy of y(t). c)…

Q: v(t) (+ 2Η oooo 2Ω Μ 2Ω + 2Η VL(t) |

A:

Q: Ex. 110. Refer to Figure 110. Assume MKS units. Given: R1= 7, R2= 5, R3= 3, V4=16, and I5=12.…

A: As per Bartley guideline we have to solve only one question at a time. Thank you

Q: Problem 4.6: Determine and sketch the magnitude and phase spectra for the following signals π (a)…

A: Given data (a) x(n)=4sin π(n-2)3 (b) xn=cos2π3n sin2π5n To find out We have to find out the…

Q: Considering terminals a and b: a) Use any method to solve for the Thevenin equivalent voltage. b)…

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: Standard power rating of a 3.9 k resistor that can handle up to 100 volt drop. ㅇ 하 watt 10 watts 5…

A:

Q: PROBLEM NUMBER 1 For the network below: a. Determine re b. Calculate Z; and Z. c. Find A.

A:

Q: Explain with diagram the Strip line and also draw its Electric field and magnetic field…

A: Strip line It is the type of transmission line. It consists of a strip of thick conductors at the…

Q: 2. Prove that capacitance in parallel circuits are added, or C = C₁ + C2 + C3 + . Cn

A: The solution is given below.  The problem is basic of capacitor. The capacitors ate added in…

Q: A Class II hazardous location is where_ Select one: Oa. gasses are present Ob. combustible dust is…

A: We need to select correct option for given statement.

Q: An AC circuit with a power source has two resistor and a capacitor connected in parallel. The values…

A:

Q: 13. (1e:1.7) Consider the circuit shown in Figure 1.39 which is built using six identical resistors.…

A:

Q: In the following circuit, V1= 1 V, L1= 1 H, R1= 102, C1=1 F and R2= 1 Q. At t=0, initial current of…

A:

Q: 1. Realize the given admittance function Y(s) in the circuit form given in Figure 1. Y(s) s² + 4s +3…

A:

Q: - Problem 1 For the circuit shown, the 5V DC source has been connected a long time: a) Find the…

A: In this question we need to find the energy stored in inductor, capacitor and power dissipation in..…

Q: QUESTION 1 The charge taken by a capacitor is 0.4 HC when terminal voltage is 32 V. The plate area…

A:

Q: Example 1: A low-pass signal has its frequency content around the origin. What is the BW of the…

A: Given, Frequency spectrum of low pass signal is We need to determine the Bandwidth and BBW.

Q: 3) In the circuit shown in Figure 2, assuming ideal op amp properties and no loading effects, answer…

A:

Q: 1. For the circuit pictured, determine the currents in the four resistors. 12.0 V R₁ =402 R₂- 12.092…

A: Given that electrical circuit follows.

Q: The zenor current has to be at least lk value in order for the zenor diode to used as a voltage…

A:

Q: An AM-SC transmitter is modulating a message signal to transmit through a channel. The channel is…

A: Given: Noise power= 1/2 Watts. The given signal is Amplitude Modulated with Suppressed Carrier i.e.,…

Q: List at least 3 applications of waveshaping circuits? (provide each one with explination)

A: It is asked to list at least 3 applications of wave shaping circuits. Also it is asked to explain…

Q: 1- Indicate, on the circuit, the reference direction of the current flowing in the circuit. 2-…

A: The current flows from higher potential to lower potential and based on that the current direction…