A solution of oxalic acid is used to titrate 17.11 mL of a 0.5003 molar: sodium hydroxide. If the titration requires 19.13 mL of the oxalic acid, determine its concentration.

Q: 2 (All questions are part of the same problem): In a mixture of the two gases CH4 and O2, they have ...

A: Answer: This question is based on the ideal gas law which is shown below: PV=nRThere:P=pressure of t...

Q: Given: 10 g of o-hydroxybenzoic acid (density: 1.44 g/mL, MW: 138.2) 20 mL wood alcohol (density = 0...

A: Here 10 gram of o-hydroxybenzoic acid react with 20ml wood alcohol (CH3OH) of density 0.792 g/ml . T...

Q: A 33.8 mL sample of a 0.400 M solution of NaCN is titrated by 0.160 M HCI. Kb for CN is 2.0 x 10-. C...

A:

Q: Leaking was observed from the separatory funnel used during extraction. Statement 1: The analyst rem...

A: A question based on analytical separations that is to be accomplished.

Q: Consider the reaction. 2 Pb(s) + 0,(g) 2 PbO(s) An excess of oxygen reacts with 451.4 g of lead, for...

A: %yield = ( Actual yield÷ Theortical yield)×100%

Q: A sample of gas (1.9 mol) is in a flask at 21 °C and 597 mmHg. The flask is opened, and more gas is ...

A:

Q: 1. Predict the effect of each of the following conditions on the calculated concentration of NaOH. E...

A: A question based on analytical process that is to be accomplished.

Q: ST12A.1- Determine the temperature [in K] at which the relative proportion of molecules in axial and...

A: Given: Relative proportion of molecules in Axial and equatorial conformation (A/E)  = 0.207 Energy d...

Q: First, find the solubility (i. e. equilibrium concentrations) of a Ca2+ and F ions in a solution of ...

A: Solubility is the measure of capability of dissolving in water. After dissolving the product of ions...

Q: Part E `CH2CH2CH3 Spell out the full name of the compound. Submit Request Answer Part F

A:

Q: If a buffer solution is 0.410 M in a weak acid (K, = 5.9 x 10-6) and 0.210 M in its conjugate base, ...

A: Note : Since you have posted multiple questions, we are entitled to answer the first only. Please re...

Q: A student weighs out a 5.01 g sample of FeCl2, transfers it to a 250. mL volumetric flask, adds enou...

A: Given :-  Mass of FeCl2 = 5.01 g  Volume of solution = 250. mL  To calculate :-  Molarity of solutio...

Q: Select the three methods typically used to determine an experimental rate law: Reversible Reactions ...

A: The rate law can be determined experimentally using the method of initial rates, isolation method an...

Q: A solution contains 0.266 M sodium hypochlorite and 0.133 M hypochlorous acid. The pH of this soluti...

A:

Q: Question How much heat is required to melt 200 grams of ice? The heat of fusion is 333 J/g. O 6.66kJ...

A: Given-> Weight. = 200 gm Heat of fusion = 333 J/g  

Q: I Review | Constants | Periodic Table A decomposition reaction, with a rate that is observed to slow...

A: Given : Half life depends on initial concentration of reactant.

Q: . 190 g of CuSO4 are placed in 3500 g of water. Determine the molality.

A: Given Data :  1. Mass of CuSO4 ( Solute) = 190 g  2. Mass of Water ( solvent) = 3500 g              ...

Q: Monochromatic light is light of one color, one frequency. If a monochromatic light beam is increased...

A: Answer: This question is based on the basic understanding of wave nature of matter where we have to ...

Q: The activation energy, Ea, for a particular reaction is 19.4 kJ/mol. If the rate constant at 80 °C i...

A:

Q: An analysis was done on 3 unknown samples (NaOH, Na2CO3 and NäHCU3) USIng each analysis and a single...

A: Neutralization reactions of all three possible compounds are: NaOH + HCl ------> NaCl + H2O Na2CO...

Q: In the following chemical reaction which element is the oxidizing agent? 3sn(no3)2(awesome)+2Fe(s) 2...

A:

Q: Predict the products for each of the following reactions and determine which product will predominat...

A: At low temperature kinetic product is obtained when electrophilic addition reaction takes place in c...

Q: Match all the described steps of a typical bimolecular reaction sequence to the location on the ener...

A:

Q: The molecular weight of a gas that has a density of 6.75 g/L at STP is __________ g/mol.

A: At stp pressure is one atm

Q: What is the rate at which Br(aq) disappears in the reaction below if the rate of disappearance of Br...

A: Rate of disappearance of BrO3^- = 0.047 M/s = -∆[BrO3^-]/∆t     

Q: Identify all possible chemical, oxidative and reductive reactions that may occur when Fe(OH)3 is dis...

A: Solution: This is a pourbaix diagram based on concentration of 1mol dm-3 of the active species The s...

Q: The rock that consist of one mineral called mineraloids. * True O False The earth's crust divided in...

A: Mineraloids are naturally occurring solids that are not crystalline in nature. They may look like a ...

Q: A set of samples from an abandoned industrial site detected a suspected groundwater contaminant at a...

A:

Q: Arrange the following steps according to the order of process in Mass spectrometry lon Separation lo...

A:

Q: In a mass spectrometer with an electron ionization source (EI) does the mass of an ion affect its ve...

A: Electron ionization (EI) is known as electron bombardment ionization in which energetic electrons in...

Q: 1. Quantum leap is the phase where electrons tend to jump from one orbit to another. 2. Ther...

A: * Electron is considered as quantum in quantum chemistry.

Q: The bombarded fragments forms a radical is represented by a mass charge ion ratio  known as (_)?   ...

A: In mass spectrometry,  a molecule is ionised and fragments are created on the basis of m/z. 

Q: 18-29. The measured pH of a 0.100 M solution of NHs(aq) at 25°C is 11.12. Calculate K, for NH3(aq) a...

A: Since you have posted multiple questions, we will solve the first one for you. Kindly post the other...

Q: I. Carbon dioxide at 60°C and 34 atm is a real gas. Determine your specific volume using: a. Beattie...

A: Ideal gas regulation: As indicated by Ideal gas regulation, explicit volume, v = RT/PM where, R = ga...

Q: Ethylene glycol (C₂H₆O₂) is used as an additive to the water in your automobile to lower its freezin...

A:

Q: MASS SPECTRUM 100 80 60 40 20 0.0- 8 12 16 20 24 28 32 m/z Rel. Intensity

A:

Q: B. Calcium carbonate (limestone) is a very insoluble ionic salt! Answer the following if you add a f...

A: If we add calcium carbonate  in well it doesn't react with water as it is insoluble  but if well has...

Q: Part A A gas nample has a volume of 4210 mL at 18 "C and 735 mmHg What is the final temperature, in ...

A:

Q: Designate the relative positioning of the functional groups in your assigned molecule. Based on the ...

A: This molecule is synthesised from the cyclohexanone by nucleophilic addition of the cyanide which de...

Q: Experimental value: 0.010 mol/L Literature value: 0.00798 mol/L What might cause the solubility to d...

A: Two major factors affecting solubility are- 1. Temperature 2. Pressure

Q: Consider the schematic reaction    K A --> P a) If the reaction is one-half order with respect to ...

A:

Q: Question 16 of 20 How long will it take for the concentration of A to decrease from 1.400 M to 0.729...

A: For zero order reaction,   [A] (final)= - Kt + [A] (initial) [A](initial) = initial concentration of...

Q: (a) Use the standard reduction potentials at 25° C in Table 18.1 in Tro, Fridgen and Shaw, and calcu...

A:

Q: Predict the products for each of the following reactions and provide an explanation for the stereoch...

A: Diels alder reaction is [4+2] cycloaddition reaction . In which one reactant is diene and other is d...

Q: 1. When a 1.010-g sample of sucrose (C12H22011) is burned in a bomb calorimeter, the temperature ris...

A:

Q: For this molecule complete the following: a. Use Valence Bond theory to write the atomic energy leve...

A: To draw the before hybridization and after hybridization orbital diagram for the Nitrogen atom and f...

Q: 2 Volume HCI Added (mL) Strong Base//Weak Acid Strong Acid/Strong Base Strong Acid/Weak Base Weak Ac...

A:

Q: the 'salting-out" process in an extraction procedure, the replaces the in the water.

A: In Salting out process of extraction when salt such as magnisium chloride or calcium chloride is add...

Q: What is the pH of a 1.86M solution of the strong base barium hydroxide (BaOH)2?

A:

Q: Predict the product and balance redox reaction Solid cuprous sulfide is oxidized by hot conentrate...

A: In this question, we have to Predict the product and balance the redox reaction.

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.