A telephone cable has the following primary constants per loop -KMR=30 22,L-20 mH,C=0.06 F andG=0.If the applied signal has an angular frequency of 5000 rad/sec,determine a fo(i) the characteristic impedance,(ii) the attenuation constant in decibels and(iii) the velocity of wave propagation in the cable.

Characteristic impedance- ZC=R+jωLG+jωC Ω where , ZC=Characteristic impedance R…

A telephone cable has the following primary constants per loop -KM R=30 0, L-20 mH, C 0.06 F and G=0. TIX. If the applied signal has an angular frequency of 5000 rad/sec, determine a po (i) the characteristic impedance, (ii) the attenuation constant in decibels and (iii) the velocity of wave propagation in the cable.

A telephone cable has the following primary constants per loop -KM R=30 0, L-20 mH, C 0.06 F and G=0. TIX. If the applied signal has an angular frequency of 5000 rad/sec, determine a po (i) the characteristic impedance, (ii) the attenuation constant in decibels and (iii) the velocity of wave propagation in the cable.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Can you please determine the cut off frequency value from the graph provided
4) A 1200 kHz carrier is amplitude-modulated by two tones of 500 Hz and 700 Hz. Which one is a frequency component of the modulated wave? a) 1195 kHz b) 1199.3 kHz c) 1199.7 kHz d) 1205 kHz
1.1 0.9 0.8 0.7 J, 0.6 0.5 0.4 Js J, 0.3 0.2 0.1 10 12 -0.1 -0.2 -0.3 -0.4 -0.5 A carrier (fc = 100MHZ, A. = 25V) is frequency modulated by the sine wave (fm = 8kHz, Am = 3V) using a frequency modulator with frequency deviation of 58kHz. Determine: %3D (a) Carrier swing frequency of the output FM signal. (b) Highest and lowest sidebands’ frequencies generated by the modulated signal. (c) The bandwidth of the FM signal. (d) The transmitted power through a 502 load. Ignore Jn(B)| < 0.1
2-A resultant current is made of two components: a 10 A D.C. component and a sinusoidal component of maximum value 14.14. The average value of the resultant current is amperes (a) 0 (b) 24.14 (c) 10 (d) 4.14 and r.m.s. value is - amperes (e) 10 (f) 14.14 (g) 24.14 (h) 100
Determine the z-tranform and ROC. Show full solution.
Considering an entire period of Signal 1 equivalent to 2n radians, estimate the phase difference between Signal 1 and Signal 2, expressed in radians. 500m signal 2 signal 1 -500m -1 100u 200u 300u 400p 500u 600u 700u 800u Time (s) 900u 1m 1.1m Signal 2 is lagging Signal 1 by n/6 radians Signal 2 is advancing Signal 1 by 1/6 radians Signal 2 is lagging Signal 1 by n/4 radians Signel 2 i adiene W abejon
The dimensional formula for frequency is: (a) MOLOT-1 (c) MºLºT-² (b) MºL¹T-1 (d) M°L°T-3
The envelope of a sinusoidally amplitude modulated carrier wave varies from a maximum value of 4V to a minimum value of 1 V. Determine the amplitude of the carrier frequency component. a 1.5 V b 2.5 V c 0.6 V d 0.75 V
what's the value of magnitude? i can't see it
, For the trapezoidal pattern shown below, determine a. Modulation coefficient. b. Percent modulation. c. Carrier amplitude. d. Upper and lower side frequency amplitudes. 28 V 12 V -12 V -28 V
An inductor is attached to an AC voltage source. Which change will result in a halving of the current?A. Halving the voltage and doubling the frequencyB. Doubling the frequencyC. Halving the frequencyD. Doubling the voltage and halving the frequency
Given: A = 8a,+la, +4a, and B= a,+3a,- 4ay. Determine A \B. O a. -5.00 O b. 27.00 O C. 24.00 O d. 32.00