A uniform horizontal beam with a length of 1.7 m and a weight of 200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 35.0° with the horizontal. If a crate of mass (M) 87 kg hanged 1.7 m from the wall, find the tension in the cable, as well as the magnitude and direction of the resultant force exerted by the wall on the beam.

A uniform horizontal beam with a length of 1.7 m and a weight of 200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 35.0° with the horizontal. If a crate of mass (M) 87 kg hanged 1.7 m from the wall, find the tension in the cable, as well as the magnitude and direction of the resultant force exerted by the wall on the beam.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.76P: The 50-ft measuring tape weighs 2.4 lb. Compute the span L of the tape to four significant figures.

See similar textbooks

Similar questions

Determine the force in cored AB 30° B 800 lb/ft -15 ft -15 ft- Your answer
1.8 Locate the center of mass z of the assembly. The material has a density of p-3 Mg/m³. There is a 30-mm diameter hole bored through the center. Z (a) z = 78.1 mm (b) z = 98.1 mm (c) z = 58.1 mm (d) z = 38.1 mm (e) None of the above 30 mm 100 mm 40 mm 20 mm
ider Replace the three forces acting on the shaft by a single resultant force. Specify where the force acts, measured from end A.
P1-3. Determine the required length of cord AC in Fig. 1-8a so that the 8-kg lamp can be suspended in the position shown. The undeformed length of spring AB is l'AB = 0.4 m, and the spring has a stiffness of kAB = 300 N/m. 2 m kAR = 300 N/m 30 Fig. 1.8
(b) Figure Q2(b) shows two masses mi and m: hanged together at the link AB. If the mass m, = 20 kg, and the magnitude of the total moment about point B due to forces exerted on link AB by the weights of two masses is 170 Nm, determine the total magnitude of the total moment about point A.
600 -400- 600 800 G| P2 P3 E F Tha at y pnywty i A - 100 mm E - 200 GPa A- 150 mm E- 200 GPa A130 mm E- 70 GPa 700 A- 50 mm E- 83 GPa P1 d. 30° o B 500 All dimensions are in millimeters.
If P is to be 400 N. What is the value of the weight W? 目

Determine the angles 32 and 33 and the force in each cable segment if ß1 = 50%.
3.6 m R 1m 1.2 m 2.5 m Oa 3m The banner has a density of 670 kg/m and is 6mm-thick. The pipe has the linear weight of 9N/m. Which of the following completes the force diagram? A. Foy, Foz, Moy, Moz B. Fox. Foy, F oz, Mox, Moy, Moz C. Fox, Foy, Foz, Moy, Moz D. Foy, Foz, Mox, Moy, Moz Р 1.25 m 1.5 m WOR 1.25m Wanner Fo WpQ 3.6 m Oo 2.5 m R 1 m
The 50-ft measuring tape weighs 2.4 lb. Compute the span L of the tape to four significant figures.
A weighing machine consists of a 2 kg pan resting on a spring. In this condition, the pan resting on the spring, the length of the spring is 200 mm. When a mass of 20 kg is placed on the pan, the length of the spring becomes 100 mm. For the spring, the un-deformed length 10 and the spring constant k (stiffness)
5. The machine part of negligible weight is supported by a pin at A and a roller at C. Determine the magnitudes of the forces acting on the part at A and C. Ne 50° 400 2.4 kN-m 40°f B 2.4 kN-m 40°/ -200-- -250- 300- 3 kN -200- -250 300- 3 kN Dimensions in mm FBD