An R = 78.32 resistor is connected to a C = 41.7 μF capacitor and to a AVRMS = 110 V, and f = 111 Hz voltage source. Calculate the power factor of the circuit. Submit Answer Tries 0/12 Calculate the average power delivered to the circuit. Submit Answer Tries 0/12 Calculate the power factor when the capacitor is replaced with an L = 0.377 H inductor. Submit Answer Tries 0/12 Calculate the average power delivered to the circuit now. Submit Answer Tries 0/12

An R = 78.32 resistor is connected to a C = 41.7 μF capacitor and to a AVRMS = 110 V, and f = 111 Hz voltage source. Calculate the power factor of the circuit. Submit Answer Tries 0/12 Calculate the average power delivered to the circuit. Submit Answer Tries 0/12 Calculate the power factor when the capacitor is replaced with an L = 0.377 H inductor. Submit Answer Tries 0/12 Calculate the average power delivered to the circuit now. Submit Answer Tries 0/12

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter33: Alternating Current Circuits

Section: Chapter Questions

Problem 33.1OQ: An inductor and a resistor are connected in series across an AC source as in Figure OQ33.1....

See similar textbooks

Similar questions

In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
A step-up transformer is designed so that the output of its secondary winding is 2000 V(rms) when the primary winding is connected to a 110-V (rms) line voltage, (a) If there are 100 turns in the primary winding, how many turns are there in the secondary winding? (b) If a resistor connected across the secondary winding draws an rms current of 0.75 A. what is the current in die primary winding?
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
For the cucu3t shown below, what are (a) the total impedance and (b) the phase angle between the current and the emf? (C) Write, an expression for i(t).
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?
At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor. What is the capacitance of the capacitor?
The emf of an ac source is given by v(t)=V0sint, where V0=100V and =200 . Find an expression that represents the output current of the source if it is connected across (a) a 20-pF capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
An inductor and a resistor are connected in series across an AC source as in Figure OQ33.1. Immediately after the switch is closed, which of the following statements is true? (a) The current in the circuit is V/R. (b) The voltage across the inductor is zero, (c) The current in the circuit is zero, (d) The voltage across the resistor is V (e) The voltage across the inductor is half its maximum value.