Analysis of data on maximum one day rainfall depth at Chile indicated that a depth 360 mm had a return period of 24 years. Determine the probability of a one day rainfall depth =, or, greater than 360 mm at Chile occurring Once in 10 successive years Twice in 8 successive years At least once in 7 successive years

Analysis of data on maximum one day rainfall depth at Chile indicated that a depth 360 mm had a return period of 24 years. Determine the probability of a one day rainfall depth =, or, greater than 360 mm at Chile occurring Once in 10 successive years Twice in 8 successive years At least once in 7 successive years

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.22P: Refer to Figure 7.24. The following data were collected during the field permeability measurement of...

See similar textbooks

Similar questions

Analysis of odata on maximum one day rainfall depth at Madra indicated that a depth 280 mm had a return period of 40 years. Determine the probability of a one day rainfall depth =, or, greater than 280 mm at Madra occurring 1.Once in 20 successive years 2. At least twice in 20 years
Analysis of data on maximum one-day rainfall depth at Madras indicated that a depth of 280mm had a return period of 50 years. a).Determine the probability of a one-day rainfall depth equal to or greater than 280mm at Madras occurring once in 10 successive years b).two times in 15 successive years c).at least once in 20 successive years. d). What is the probability of non-occurrence?
The following table is the recorded maximum depths (inches) of precipitation for a 30-minute duration. Determine the return period (years) for a depth of 3.0 inches using the Weibull method with an annual series. Year Date Depth, in Year Date Depth, in. 1978 Aug 8 4.7 1979 May 6 6.0 1973 May 3 2.5 June 3 1.0 1967 June 7 1.0 June 8 5.0 1975 July 2 1.0 1976 June 1 1.5 Sept 4 3.0 1980 May 4 1.0 Aug 3 3.0 1977 July 4 1.5 1981 Sept 8 5.0 1982 May 9 2.0
The sequent depth ratio of a hydraulic jump in a rectangular horizontal channel is 10.30. The Froude Number at the beginning of the jump is
The Froude number of a subcritical stream at the end of a hydraulic jump in a horizontal rectangular channel is 0.22 The sequent-depth ratio of this jump is. （a）11.25 (b）15.25 (c）8.35 (d) 6.50
A 1-hour UH (1 unit=1 cm) can be represented by an isosceles triangle with peak at 4 hours and peak flow of 15 m³/s. The peak of the resulting streamflow from a 1-hour rainfall of depth 2 cm will be: O 30 m3/s at 8 hours; O 30 m3/s at 4 hours 15 m3/s at 4 hours; 15 m3/s at 1 hour;
QUESTION 1 Use the kinematic wave formula to determine the time of concentration for a small drainage area that has a length of overland flow of 45.72 m and an average overland slope of 0.02 m/m for a rainfall rate of 0.091 m/hr. The drainage area is a turf (n = 0.4). O 21 minutes. O 17 minutes O 22 minutes. 31 minutes.
(b) In a hydraulic jump taking place in a rectangular channel the discharge intensity and head loss are found to be 4.7 m/s/m and 6.0 m respectively. Determine the sequent depths of the jump. 8
Problem H: For Problem 28 to 29. In a constant head permeability test the following are given L= 250 mm and A=105 cm?. If the value of k = 0.014 cm/secand flow rate of 120 cm³/min which isto be maintained. %3D 28) What is the head difference, hin the specimen? a) 44 cm b) 24 cm c) 33.75 cm d) 34.0 cm 29) Determine the dischargevelocity in cm/sec? a) 0.017 b) 0.009 c) 1.019 d) 0.019
Nf : 5 Nd=16 25 m Question 4 Seepage take place beneath a concrete dam as shown in Figure 2. The soil beneath the dam is a fine silty sand with hydraulic conductivity of 4.2 x 10“cm/s and saturated unit weight of 19.5 kN/m³. 6 m 1.75 m: 1) Find the rate of seepage beneath the dam in m³/day/m 2) If a standpipe piezometer is installed at the tip of the sheet pile, how high will the water rise? Impervious stratum
Refer to Figure 7.24. The following data were collected during the field permeability measurement of a confined aquifer using a pumping test. Determine the hydraulic conductivity of the permeable layer. Use Eq. (7.49). Thickness of the aquifer, H = 4.5 m Piezometric level and radial distance of the first observation well: h1 = 2.9 m; r1 = 17.8 m Piezometric level and radial distance of the second observation well: h2 = 1.8 m; r2 = 8.1 m Rate of discharge from pumping, q = 0.5 m3/min
(b) Seepage takes place beneath a concrete dam as shown in Figure Q3. The soil beneath the dam is fine silty sand with hydraulic conductivity (permeability) of 4.2 x 10- cm/sec and saturated unit weight of 19.5 kN/m³. i. Calculate the rate of seepage beneath the dam in m/day/m. ii. If a standpipe (piezometer) is installed at point A, how high will the water rise? i. Calculate the pore water pressure at point A. R1.75m Impervious stratum Figure Q3