Plz plz solve all four parts b)and protecting valve.There is a large river of fresh water (having the density of 1000 kgm) in the northernarea of England available for storage where the water level changes by 3.8 m an exithaving a potential of installing a small size hydroelectric power station. If the river has atypical flow of 0.1 cumecs (cubic metre per second).LM.Iv.Determine the maximum installed capacity for continuous electrical powergeneration?If the turbine/generator efficiency is 70% then calculate the amount of poweravailable?How much energy, in kWh, this hydroelectric power station can generate if it isoperated for 15 hours if the plant efficiency is 70%?What will be the annual energy capture, in kWh, for the case if the load factor is40%7

Given: In this question, the given details are, There is a large river of fresh water (having the…

b) and protecting valve. There is a large river of fresh water (having the density of 1000 kgm) in the northern area of England available for storage where the water level changes by 3.8 m an exit having a potential of installing a small size hydroelectric power station. If the river has a typical flow of 0.1 cumecs (cubic metre per second). L i. If the turbine/generator efficiency is 70% then calculate the amount of power available? W. Determine the maximum installed capacity for continuous electrical power generation? iv. How much energy, in kWh, this hydroelectric power station can generate if it is operated for 15 hours if the plant efficiency is 70% ? What will be the annual energy capture, in kWh, for the case if the load factor is 40%7

b) and protecting valve. There is a large river of fresh water (having the density of 1000 kgm) in the northern area of England available for storage where the water level changes by 3.8 m an exit having a potential of installing a small size hydroelectric power station. If the river has a typical flow of 0.1 cumecs (cubic metre per second). L i. If the turbine/generator efficiency is 70% then calculate the amount of power available? W. Determine the maximum installed capacity for continuous electrical power generation? iv. How much energy, in kWh, this hydroelectric power station can generate if it is operated for 15 hours if the plant efficiency is 70% ? What will be the annual energy capture, in kWh, for the case if the load factor is 40%7

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

Q20. The section bus-bars A and B as shown in Figure B5 are linked by a bus-bar reactors each rated at 5000 kVA with 10% reactance. On bus-bar A, there are two generators each of 10,000 kVA with 10% reactance and on B two generators each of 8000 kVA with 12 % reactance. Find the Current and MVA that fed into a dead short circuit between all phases on B with bus-bar reactor in the circuit. Page 4 of 5 جامعة التقنية والعلومر التطبيقية بإبراء University of Technology and Applied Sciences - Ibra Student ID: Section: Student Name: 8,000 kVA 12% 10,000 kVA 10,000 kVA 10% 8,000 kVA 12% 10% 2 3 5,000 kVA 10% lell 8,000 kVA 10% Figure B5 "End of Question Paper"
Explain the concept of FACTS (Flexible Alternating Current Transmission Systems) devices. How do they enhance the control and stability of power systems? Provide examples of FACTS devices and their applications.
7. TY Hat CHICL Ans. 1. Iron los.........varies approximately as V². 2. Cu loss..........it also varies as ² but decreases with an increase in voltage if constant kVA output is assumed. 3. Efficiency...........for distribution transformers, efficiency at fractional loads decreases with in- crease in voltage while at full load or overload it increases with increase in voltage and vice- versa. 4. Regulation..........it varies as but decreases with increase in voltage if constant kVA output is assumed. 5. Heating.........for constant kVA output, iron temperatures increase whereas Cu temperatures decrease with increase in voltages and vice-versa. quems
5. Draw the daily load curve and load duration curve for a power station with any arbitrary loads you like. From the load curve, determine the following. i. Maximum demand ii. Average demand ii. Daily energy consumption
The section bus-bars A and B are linked by a bus-bar reactor rated at 6000 kVA with 12% reactance. On bus-bar-A, there are two generators each of 10 MVA with 8% reactance and on bus-bar-B, two generators each of 6000 kVA with 10% reactance. Find the steady MVA fed into a dead short circuit all phases on B with bus-bar reactor in the circuit.
OR e) What is BILS? Explain their significance in power system studies.
In a given system of base power of 250 MW, and bus 3 is taken as reference. The per-unit reactances are X12 = 0.2 p.u., X13 = X23 = 0. 1 p.u. The power flow in the system is given as: PF12 = 50 MW, PF13 = 150 MW, PF23 = 50 MW. Based on readings from 2 meters (not including M12 meter), M13 = 145 MW (not calibrated), and M23 = 50 MW (well calibrated), deduce the flow on line 1-2. Select one: O a. PF12 = - 47.5 MW. O b. None of these O c. PF12 = 67.5 MW. O d. PF12 = 47.5 MW. O e. PF12 =- 57.5 MW. O f. PF12 = 57 MW.
Q4: A power distribution station consisting of 100OKVA, 4500V/225V, and 50 cycles per second single-phase core type mutual inductance equipment is to have an approximate electromotive force per turn of 15V and operates witha maximum flux of1.4T. Based on the above scenario justify what will be the values of turns, currents, and cross-sectional area of the core? Analyze the range of load resistance of this equipment. If the load resistances are very high discuss the various methods on its heat reduction process.
2. a) Explain the terms load factor and diversity factor. b) Discuss the advantages of interconnected grid system. c) A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Calculate: (i) the maximum demand on the station, (ii) annual energy supplied by the station and (iii) suggest the installed capacity and the number of units.
Give the analogous quantities for electrical current in pneumatic, hydraulic and thermal systems. b. Give example for isomorphic electric, pneumatic, hydraulic and thermal systems.
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
Discuss the principle of operation of pumped storage type hydroelectric power plant and discuss their advantages and disadvantages? Can the 'pumped storage type hydroelectric power plant’ replace the large energy storage batteries in the future power system, justify your answer with solid reasons.