Based on that experimental titration curve of the IU unknown sample, can you sketch out the titration curve if both the starting weak acid solution and the NaOH solution are diluted 10 times? What about diluting another 10 times on top of that? Particularly, you should pay attention to the size of the pH jumps around each equivalence point, as well as the relative positions of the flat regions before or after the pH jumps. For the sake of simplicity, no need to consider activity in this exercise.

Based on that experimental titration curve of the IU unknown sample, can you sketch out the titration curve if both the starting weak acid solution and the NaOH solution are diluted 10 times? What about diluting another 10 times on top of that? Particularly, you should pay attention to the size of the pH jumps around each equivalence point, as well as the relative positions of the flat regions before or after the pH jumps. For the sake of simplicity, no need to consider activity in this exercise.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter15: Additional Aqueous Equilibria

Section: Chapter Questions

Problem 34QRT

See similar textbooks

Similar questions

The toughest part about titration is adding just enough of the titrant (NaOH, in this case). If you add the NaOH too quickly, you will likely end up adding too much ("overshooting the endpoint"). Alternatively, you could add it very slowly, drop-by-drop, but with this approach, you'll probably run out of time in the lab! The best option is to know in advance a rough idea of how much you'll need to add. Get close to this amount, then slow down and start adding NaOH in drop-fashion. Considering that the NaOH should be within a few percent of 0.30 M, what volume (in mL) would you expect to use for your third trial with 0.7943 g of KHP? Round your answer to 2 sig figs. Record this volume on your Cover Page and refer to it when performing your titration in Part 1. N
Draw the titration curve for a strong acid (titrant) and a strong base (analyte) titration. Kindly show and label the x- and y- axes, and the equivalence point.
When doing a titration too quickly, you are more likely to overshoot the endpoint, to add more than the minimum amount of titrant needed. When the solution is very pink, you have overshoot the endpoint. Will this tend to make your calculated concentration of the acid too high, too low, or will it now make a difference? Explain clearly. NaOh+HCl
1. A student titrates 25.0 mL of an unknown base with 0.10 M HCI. During the titration the pH is monitored and the collected data is recorded. These data are shown in the table at the right. a. Use the information provided to draw a titration curve showing the pH as a function of the volume of added HCI. Be certain to label your axes. b. Identify the equivalence point on your graph and justify your selection of this particular point. c. Use the data to determine the Kö value for the weak base. Be certain to show the mathematical steps you take to arrive at the answer. Report your final answer to the correct number of significant digits. d. The student has three indicators that she could use for this experiment. The indicators (with their endpoints) are: Bromophenol Blue (3.0 - 4.6), Methyl Red (4.2 – 6.3), and phenolphthalein (8.3 – 10.0). Which indicator would be appropriate for this titration? Justify your selection. e. Determine the (i) molarity and the (ii) % ionization of the…
Table 1 Titration Data. Trial #1 Trial #1 (continued) Trial #2 Trial #2 (continued) Volume of Volume of NAOH added (mL) Volume of Volume of NAOH added (mL) pH NAOH added pH pH NaOH added pH (mL) (mL) 4.30 Iml 4.51 4.44 4,95 4..30 4.52 4.98 4.95 S.15 5.30 0.00 0.00 2. 2. 3. 5.28 S.S2 $,505.50 5.90 S.80 S, 8 6.04 6.20 16.50 T.16 10.10 7.6 10.20 8.32 1U.308.78 0.40 9.28 10.509.57 A0.21 1.08 So64 S,g6 6.07 6.64 4.5 8.0 8.3 16 12 a.s 10 12 14 169 4.62
How did diluting the buffer affect the pH of the buffer solution itself? ( pls explain it asap!) Thank you
Construct a titration curve from the data below. Determine the volume of titrant at equivalence point.
Sketch a titration curve of a triprotic weak acid (Ka’s are 5.5x10-3, 1.7x10-7, and 5.1x10-12) with a strong base. Label: The x- and y-axis. The half-equivalence points The equivalence points Make sure your points are at the correct pH values where possible and label them on the correct axis. Please give explanation and/or steps.
Why the shapes of strong acid–strong base, weak acid–strong base, and weak base–strong acid titration curves differ
For a weak acid/strong base titration, if the titration mixture is a dark pink, which of the following is correct? 1. The calculated concentration of weak acid is underestimated because the amount of strong base required to reach and endpoint is underestimated. 2. The calculated concentration of weak acid is overestimated because the amount of strong base required to reach the endpoint is overestimated 3. the calculated concentration of weak acid is underestimated because the amount of strong base required to reach the endpoint is overestimated
2- The point in which the colour changes from one colour to another in acid base titration is called... .? * Calculation point Equivalence point Colour Change point End point
The next 9 questions are related to the titration of 20.00 mL of a 0.0750 M acetic acid solution with 0.0700 M KOH. 1) What is the initial pH of the analyte solution? 2) What volume of KOH is required to reach the equivalence point of the titration (in mL)? 3) How many mmol of the salt are present at the equivalence point? (ANALYTICAL AMOUNT, NOT EQUILIBRIUM AMOUNT) 4) What is the volume of the solution at the equivalence point (in mL)? 5) What is the molar concentration of the salt at the equivalence point? (ANALYTICAL CONCENTRATION, NOT EQUILIBRIUM CONCENTRATION) 6) What is the pOH at the equivalence point? 7) What is the pH at the equivalence point? 8) How many mL of KOH have been added at the half-equivalence 9) What is the pH at the half-equivalence point?