Boiler Pump m5 Feedwater heater Turbine A steam power plant operates with a boiler output of 20 kg/s steam at 2 MPa and 600°C. The condenser operates at 50°C, dumping energy into a river that has an average temperature of 20°C. There is one open feedwater heater with extraction from the turbine at 600 kPa, and its exit is saturated liquid. 6 y m5 Pump p1 W, (1-y) ms Condenser (1-y) ms a) Draw and label the Ts Diagram. b) Tabulate values for: h, to h c) Find the mass flow rate of the extraction flow from the turbine to the feedwater heater (kg/s). RIVER WATER IN LIQUID (1) STEAM (7) RIVER WATER OUT

Boiler Pump m5 Feedwater heater Turbine A steam power plant operates with a boiler output of 20 kg/s steam at 2 MPa and 600°C. The condenser operates at 50°C, dumping energy into a river that has an average temperature of 20°C. There is one open feedwater heater with extraction from the turbine at 600 kPa, and its exit is saturated liquid. 6 y m5 Pump p1 W, (1-y) ms Condenser (1-y) ms a) Draw and label the Ts Diagram. b) Tabulate values for: h, to h c) Find the mass flow rate of the extraction flow from the turbine to the feedwater heater (kg/s). RIVER WATER IN LIQUID (1) STEAM (7) RIVER WATER OUT

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

rankine cycle, the pressure and temperature entering the turbine is 1800 kpa and 380 degrees celsius and the pressure leaving the turbine is 20 kpa, the quality of steam entering the condenser is 90%. what is the turbine work in kj/kg at 1.8 mpa and 380 degrees celsius
Steam at 20 MPa and 620°C enters a steam turbine and expands to a condenser pressure of 100 kPa. An open feedwater heater is added operating at 2 MPa. Calculate the cycle thermal efficiency in %. Use the unrounded values of the work of the turbine, work of the pump, and heat added when needed. Please use the green book entitled "Thermodynamics Properties of Water Including Vapor, Liquid, and Solid Phases by Keenan, Keyes, Hill, and Moore for the steam table.
A flashed steam geothermal power plant is located where underground hot water is available as a saturated liquid at 700 kPa. The well head pressure is 600 kPa. The flashed steam enters the steam turbine at 500 kPa and expands to 15 kPa when it is condensed. The flow rate from the well is 29.6 kg/s. Determine the cycle thermal efficiency of the plant in %.
A flashed steam geothermal power plant is located where underground hot water is available as a saturated liquid at 700 kPa. The well-head pressure is 600 kPa. The flashed steam enters the steam turbine at 500 kPa and expands to 15 kPa when it is condensed. The flow rate from the well is 29.6 kg/s. Determine the cycle thermal efficiency of the plant in %. If the steam table is needed, please use the green book entitled "Thermodynamics Properties of Water Including Vapor, Liquid, and Solid Phases" by Keenan, Keyes, Hill, and Moore.
Condenser a steam power plant that operates on a simple ideal ranking cycle and has a net power output of 22MW. Steam enters the turbine at 7Mpa and 450.05°C and is cooled in the condenser at a pressure of 10kpa by running cooling water from a lake through the tubes of the condenser at rate of 1750 kg/s. Determine the mess flow rates of steam through the steam turbine assuming that the cp of superheated steam is 2.9593kJ/kg.K.
A dry and saturated steam supplied in a power plant is at 1500 kPa. Determine theefficiencies of Carnot and Rankine cycle if the pressure at the condenser is at 40 kPa,neglecting pump work.
An r-134a refrigerator operates a simple vapor compression cycle (SVCC). The evaporatoroperates at -10 °C, while the condenser operates at 1 MPa. R-134a flows around the system at 10 g/s.a. Graph the cycle in a P-h diagram and calculate the temperature at the exit of the compressor, assuming it is 100% isentropicallyefficient.b. Calculate the power required by the compressor (in W) and the cooling effect of the refrigerator (in kW) c. Compute for the COP of the system. What is its percent difference from the reversible efficiency?
ercise 5.1 1500 5.1.1 A boiler with super (heater generates 6000kg/hr of steam at a pressure of 1.5MPA, 0.98 dry at exit from the boiler and at a temperature of 300°C on leaving the super heater. If the feed water temperature is 80°C and the overall efficiency of the combined boiler and super heater is 85%, determine: the amount of coal of calorific value 30MJ/kg used per hour ( 5.1.1.1
2.) An actual Rankine Engine is used to power a generator. The steam enters its turbine at 4 MPa and 300C then expands in an irreversible adiabatic process where it becomes saturated vapor. It enters the condenser with a pressure of 5 kPa. Find Ec, W(W₁, W₁, Wk) the remaining engine efficiencies(n,, na, nx), thermal efficiencies (e₁, 3, ek), SR(SR₁, SR₂, SR), HR(HR, HR, HR) obtained if the turbogenerator has 85% mechanical efficiency and 90% generator efficiency. 2822.88 kg W 27 e SR HR I 399.2 39.08% 14.14% 25456.73 B 339.32 33.22% 12.02% 29949.35 305.39 29.89% 10.82% 33276.96 k kg kj kg kg kWh kg kWh kg kWh 9.02- 10.61 11.79 kWh kj kWh
Consider a steam plant operating on the ideal Rankine cycle. Steam enters the turbine at 3 MPa and 350°C and is condensed in the condenser at a pressure of 10 kPa. Determine The thermal efficiency if steam is superheated to 600°C instead of 350°C in %. Include your T - S diagram on your solution SI unit plsss thankyou
he system presented here is a vapour power cycle with reheat and regeneration with both a closed and open feedwater heaters. The steam generator produces vapour at 12.5 MPa, 480°C. Some of the steam expands through the first stage turbine to 2000 kPa. Some steam is extracted at 2000 kPa and fed to the closed feedwater heater, while the remainder passes (at point 3) to be reheated at 2000 kPa to 440°C and expanded in the second stage turbine to 300 kPa where an amount is extracted to the open feedwater heater at 300 kPa. The remainder of the steam is expanded through the third stage turbine and exits at the pressure of the condenser at 7.5 kPa. Feedwater leaves the closed feedwater heater at 205°C and 12.5 MPa while condensates exits as saturated liquid at 2 MPa before being trapped into the open feedwater heater. Saturated liquid water at 0.3 MPa leaves the open feedwater heater. Assume that all pumps and turbines are operating isentropically. Determine (a) rate of heat transfer to the…
Problem (5.5) Superheated water vapor enters the turbine at 5Mpa and 400 °C. The water leaves the condenser as saturated liquid at a pressure of 30kPa, and the turbine efficiency is 91%. The net power output of the cycle is 100MW. Determine: a- The thermal efficiency, b- Mass flow rate of steam in the cycle