Compute the impedance of a parallel RL circuit with the following values: R = 91 Ω L = 221 mH f = 60hz

Q: 3. Use nodal analysis to solve the circuits below. 10 21, A,079( 10 I -jia jia 10 Vx I: le

A: In this question,  We need to determine the all unknown current using the nodal analysis.   

Q: 24k2 10k2 N 40kO Vout +, 10kΩξ Ž12k2 + Vs

A:

Q: In the network, find the value of ZL for maximum power transfer. The load impedance has both variabl...

A:

Q: 45. Start So S1 S2

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Q: 7. A 250 V DC long-shunt, compound motor takes a current of 82 A at full load. Calculate the motor e...

A:

Q: A 480-V rms, 60 Hz source supplies a load having a total impedance of 50 angle 60° ohms. Find the ca...

A: .

Q: Given that voltage is 90cos(wt -35) V and current is 16cos(wt + 19) A (phase angles in degrees). (A)...

A:

Q: 3. The applications of FPGA 4. Discuss briefly is a FPGA microprocessor. 5. What are FPGA basics?

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: 6. A 10 kW, 250 V Shunt motor has an armature resistance of O.5 ohm and a field resistance of 200 oh...

A: The solution is given below 

Q: What is the clipped value?

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...

Q: 11. Telephone companies digitize voice by assuming a maximum frequency of 4000 Hz. The sampling rate...

A: A message signal is transferred from the sender to the receiver end. The signal is transmitted throu...

Q: 2. Sketch a simplified equivalent circuit of a transformer

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: 1K2 ww 10.21: For the following electric circuit, find Z and Y parameters? Also, compute input and r...

A:

Q: Why are these versions of diode circuits called clamping circuits? What is the meaning of clamp?

A:

Q: xn] is shown in the figure below. Sketch the sequences x1[n] and x2[n] specified x1[n] = x((n – 2)),...

A:

Q: E, = 120/-30° and E, 120/30°, and 6. The following particulars are given for the T-network of Fig. 1...

A:

Q: Find the cross correlation of the sequences x(n) = {1, 2, 3, 4 } and h(n) = {2, 4, 6}

A:

Q: 1.What is the overall frequency division factor when obtaining 1 Hz from 60 Hz for a digital clock a...

A: The solution is given below 

Q: . A4-pole, 50-Hz, 3-phase induction motor has a slip-ring rotor with a resistance and standstill rea...

A:

Q: When the current of the zener diode is doubled, its voltac a. Almost kept constant O b. none of the ...

A: Almost kept constant (B).   Zener diode works as voltage regulator. So when the current across Diode...

Q: Determine the upper cut-off frequency of a series resonant circuit consisting of a 45 microH inducto...

A:

Q: Directions. Solve the following problems. Show your complete solution. 1. +16 V Vo -16 V V= 4 V

A:

Q: For a specific application, the circuit shown in Fig. 2.140 was designed so that I, = 90 mA and that...

A:

Q: How many bits are needed to quantize an analog signal into at least 250 levels?

A: In analog to digital converter, the given analog signal is sampled at regular intervals and quantize...

Q: Under balanced operating conditions, consider the 3-phase complex power delivered by the 3-phase sou...

A: 1Real power P3ϕ is a cosine function of the total power and is given by,3 VLLILcosϕSo, it matches wi...

Q: 1. Explain how transmission and distribution lines, sustation equipment, and generators are protecte...

A: Protective devices and techniques- In field of electrical, Protecting devices and techniques must be...

Q: A series RLC Circuit, shown in the Figure, is energized by a 100 V/4 kHz AC supply. The capacitance ...

A: The solution is given below

Q: DETERMINE THE PROPER SIZE CONDUCTORS for a 500 watt load that is located 100 ft from a 250 volt pane...

A: Given,THe output power is,Pout=500 WAt panel board the voltage is,V=250 VThe distance between load n...

Q: 2. What best describes the circuit below? Explain youranswer. Vi R

A:

Q: (s+1) Given G(s) = %3! in unity feedback (s+4)(s+15)2 Select all of the asymptotes that are in the r...

A: In this question,  Open loop transfer function is given with unity feedback.    Find the all asympto...

Q: Item 1 of 3 In the circuit in Fig. 2.76, obtain vị, v2, and v3. +20 V - - G0 V + 40 メ V - + v2- + + ...

A:

Q: Use Kirchhoff’s Laws to find the branch currents indicated in the following network

A: In this question,  Depended and independent energy sources are given in the circuit.  We need to fin...

Q: 10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 - j6.5)A and (1.8 – j3....

A: Since you have asked for question 10 . So we are providing solution for question 10 . This question ...

Q: Factors Influencing Capacitance are (select all that apply) Select 3 correct answer(s) | Dielectric ...

A: Consider the formula for the capacitance as, C=εAd Here, d is the distance between the plates A is t...

Q: A balanced delta load with impedance of 15 - j9 ohms is connected to a three-phase source by three w...

A: In this question,  A balance Delta connected load is supplied by the balance supply source.  Find th...

Q: Сарacitors

A: Capacitor is a device which store energy by creating potential difference through its plates. Capaci...

Q: In Non-Inverting Amplifier, Voltage input is.18 40mV, Rf =20Kiloohms, Rin=10Kiloohms, what ?is the V...

A: There are two types of operational amplifier. In Non inverting amplifier, input given at positive te...

Q: List the difference between open loop and closed loop control system with suitable example.

A: Difference between open loop and closed loop control system :  

Q: 2. Adding Extra Dc Voltage Source (+SV) Vo D1 Vi D RL 100k 3. Changing The Direction of Diode Vo Vi ...

A: Two circuit configuration is given. We need to explain the logic behind the two circuits.

Q: Resonance occurs when the inductive reactance is equal to capacitive reactance. Select one: True

A: In this question we will write about resonance.....

Q: (a) Express the transmit power in units of dBW (decibel-watt) and dBm (decibel- milliwatt). (b) If t...

A:

Q: H.W. Find V, in Fig. below using (a) nodal analysis and (b) mesh analysis. 24/0 v j42 j2N 4Ω. -j2 0

A: In this question,  We need to calculate the voltage Vx using the nodal analysis and mesh analysis.  ...

Q: Eddy currents can be induced only in metals that are not ferromagnetic, for example, copper and alum...

A: In this question,  We need to choose the given Statment is true or false?  Eddy currents can be indu...

Q: For an unmodulated carrier amplitude of 16Vp and a modulation coefficient of m 0.4, determine the am...

A: The modulation index is the ratio of amplitude of message signal to amplitude of carrier signal.

Q: Use Kirchhoff's Laws to find the branch currents indicated in the following networks

A: In this question We need to determine the branch currents indicated in the following networks using ...

Q: The admittance of a 0.5F capacitor in the S-domain is: O a. 2/s ohm O b. 1/(2s) ohm O C. None of the...

A: To select correct answer

Q: 6. Find the current lo in the network below using Thevenin's Theorem 10 420°A 1220' v jia ll j12 le ...

A:

Q: Briefly describe and compare the different types of Digital to Analog (D / A ) Converters. For this ...

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Q: Define FPGA, Why do we use FPGA? COC.

A:

Q: 3. Define Fuel cell? Explain with neat diagram its working principle?

A: Different energy sources are required in day to day life. These energy sources can be renewable or n...