Answered: Consider supersonic flow impinging on…

Consider supersonic flow impinging on the rounded nose of an aircraft. Is the oblique shock that forms in front of the nose an attached or a detached shock? Explain.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.68P

See similar textbooks

Related questions

Q: What does the "compressibility effect " mean? What is the influence of air compressibility on the…

A: The study of high-speed aerodynamics is a subset of aeronautics. Because the compressibility effects…

Q: b) Air entering a converging-diverging nozzle at 1 MPa and 527 °C with negligible velocity…

A: To = 527 +273 = 800K Po = 1 MPa Mass flow rate = 2.86 kg/s

Q: Write the components of Sub-Sonic Wind Tunnel?

A: We describe the main components of sub-sonic wind tunnel with small description.

Q: The velocity and temperature behind a normal shock wave are 329 m/s and 1500 K, respectively.…

A: Step-1 The velocity of the normal shock wave is: v2 = 329 m/s The temperature of the normal shock…

Q: Consider an infinitely thin flat plate with a 1 m chord at an angle of attackof 10◦ in a supersonic…

A: Hello. Since your question has multiple sub-parts, we will solve three sub-parts for you. If you…

Q: A gas initially at a subsonic velocity enters an adiabatic diverging duct. Discuss how this affects…

A: (a) When a gas is flowing at the subsonic velocity and passed through a diverging duct, its velocity…

Q: The entropy increase across a normal shock wave is 199.5 J/(kg · K). Whatis the upstream Mach…

Q: O Prove that for isentropic flow of perfect gas the effects of an area change on the flow properties…

A: Given Isentropic flow Subsonic and supersonic flow To find Relationship of isentropic flow of…

Q: Air (y = 1.4 and R = 0.287 kJ/kg K) enters a constant-area insulated duct with a Mach number of…

Q: 1. Air is flowing isentropically through a converging duct which is fed from a large temperature and…

Q: Ahead of the normal shock wave, the upstream pressure , temperature, and Mach number are 0.53 atm,…

Q: For steady isentropic flow of perfect gas in constant area duct, the change of gas velocity to the…

A: This question is based on the concept of Mach numbers from fluid dynamics.

Q: Air is heated as it flows subsonically through a 10 cm × 10 cm square duct. The properties of air at…

A: Write the given data:

Q: Consider a normal shock wave in air where the upstream flow properties are u1 = 690 m/s, T1 = 288 K,…

Q: Consider a normal shockwave in air where the upstream flowproperties are u1 = 680 m/s, T1 = 288 K,…

A: Given data: The upstream velocity is, U1 = 680 m/s. The upstream temperature is, T1 = 288 K. The…

Q: Shock waves are treated as discontinuities here, but theyactually have a very small fi nite…

A: The variation of the velocity, temperature, pressure and entropy of the before and after the shock…

Q: Can a shock wave develop in the converging section of a converging–diverging nozzle? Explain.

A: In order to produce a shock wave, the flow must be a supersonic flow. Supersonic flow: The velocity…

Q: What is the effect of heating the fluid on the flow velocity in subsonic Rayleigh flow? Answer the…

A: Rayleigh flow is defined as a non-adiabatic, frictionless flow which passes through a fixed area…

Q: General Electric J79-GE-15 turbojet engine is one of two propelling a McDonnell F4C airplane is…

Q: Consider a normal shock wave in air where the upstream flow properties are u1 = 660 m/s,…

A: Given data: Upstream flow properties u1 =660m/s T1 =288K P1=1 atm=0.101 mpa…

Q: onsider a converging nozzle, with exit air velocity of Ma=1.

A: We have a converging nozzle, with exit air velocity of Ma=1.

Q: Air discharges isentropically on a supersonic wind tunnel which is designed to achieve supersonic…

Q: Air flowing at 8 psia, 480 R, and Ma1 = 2.0 is forced to undergo a compression turn of 15°.…

A: From Prandtl-Meyer function relation,…

Q: Air is heated as it flows subsonically through a duct. When the amount of heat transfer reaches 67…

A: Given data Amount of heat transfer = 67kJ/kg Velocity of air V2=680 m/sec static pressure P2=270ka…

Q: How do oblique shocks occur? How do oblique shocks differ from normal shocks?

A: When an object moves through a medium, the molecules of the medium get deflected. When the velocity…

Q: b) Define the definition of sonic flow, supersonic flow, and hypersonic flow.

A: Define 1. Sonic Flow 2. Supersonic Flow 3. Hypersonic Flow

Q: Q4: A convergent-divergent nozzle is operating under off-design conditions resulting in the presence…

Q: Explainwhat do you understand by the term “Compressibility Corrections” for thin airfoils in high…

A: given; Explain what do you understand by the term “Compressibility Corrections” for thin airfoils in…

Q: 1 atm = 2116 lb/ft2 = 1.01 × 105 N/m2. Consider the isentropic flow through a supersonic wind-tunnel…

A: Given Data Reservoir Properties T0=500K and P0=10atm Nozzle exit pressure P=1atm Adiabatic…

Q: You have 2 shock waves and one expansion wave above the wing. What waves would you have to change or…

A: To explain: The waves would you have to change or eliminate to increase the lift produces by this…

Q: An air stream with a Mach number of (3.04) a pressure of (302 kPa) and a temperature of (502 K)…

Q: An air nozzle has an exit area 1.6 times the throat area. If a normal shock occurs at a plane where…

A: It will be assumed that the supply tank is large enough to be able to assume that the tank pressure…

Q: Air flows isentropically through a duct. At section 1, thepressure and temperature are 250 kPa and…

A: The pressure of air at section 1 is P1=250 kPa. The temperature of the air at section 1 is…

Q: How does the construction of a low speed and high-speed aircraft differ? What effects can be…

A: The choice of the airfoil for the airplane wing involves the selection of camber, thickness ratio…

Q: is ϕ ′′′ + 2ϕϕ′′ − ϕ ′2 + 1 = 0 what is the thickness of viscous layer near the axisymmetric…

A: given: show that the governing equation for axisymmetric stagnation flow is ϕ ′′′ + 2ϕϕ′′ − ϕ ′2 + 1…

Q: What is the effect of heat gain and heat loss on the entropy of the fluid during Rayleigh flow?

A: Rayleigh flow is basically friction less, non adiabatic flow through a constant area duct.

Q: Q.1. Air flow adiabatically in a constant area duct. At the inlet of the duct, the Mach number,…

A: Given Data : At Inlet Mach Number Mi = 0.6 Pressure Pi = 150 KPa Temperature Ti =300 K Duct Length…

Q: A supersonic fixed-geometry inlet is operating at sea level where the temperature and pressure are…

A: INTRODUCTION: In this task, we will compute the Mach number and the mass flow rate. The Mach number…

Q: Starting with the differential form of the energy equation, show that the flow velocity increases…

A: When fluid in Rayleigh flow with subsonic velocity is heated, the Mach number of the fluid increases…

Q: Is it possible to accelerate a gas to supersonic velocity in a converging nozzle

A: As we know that the value of Mach number can be maximum as unity at the smallest area of the nozzle.

Q: Consider supersonic Fanno flow that is decelerated to sonic velocity (Ma = 1) at the duct exit as a…

A: The flow at the duct exit remains sonic. The mass flow rate must remain constant since upstream…

Q: Air (y = 1.4 and R = 0.287 kJ/kg.K) enters a constant-area insulated duct with a Mach number of…

Q: Consider subsonic Fanno flow of air with an inlet Mach number of 0.70. If the Mach number increases…

A: (a) The stagnation temperature during the Fanno flow process remains constant because the heat and…

Q: a) Can I change the direction of a supersonic flow (of air) through 60° via an oblique shock?…

A: According to our guidelineines I can solve only 1 question at a time, kindly repost your oher…

Q: A long pipe

A: Note: As per Bartleby guidelines only 3 subparts have to be solved at a time. So upload other parts…

Question

Consider supersonic flow impinging on the rounded nose of an aircraft. Is the oblique shock that forms in front of the nose an attached or a detached shock? Explain.

Expert Solution

Step 1

given:

Consider supersonic flow impinging on the rounded nose of an aircraft. Is the oblique shock that forms in front of the nose an attached or a detached shock? Explain.

Step by step

Solved in 2 steps

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Explainwhat do you understand by the term “Compressibility Corrections” for thin airfoils in high subsonic flow and elaboratewhy it is important?
1 atm = 2116 lb/ft2 = 1.01 × 105 N/m2. Consider the isentropic flow through a supersonic wind-tunnel nozzle. Thereservoir properties are T0 = 500 K and p0 = 10 atm. If p = 1 atm at thenozzle exit, calculate the exit temperature and density.
What is the effect of heating the fluid on the flow velocity in subsonic Rayleigh flow? Answer the same questions for supersonic Rayleigh flow.
Hydrogen entering a supersonic nozzle at 450 m/s. The inlet conditions are 10 kPa and 450 °C. The nozzle exit diameter is adjusted such that the exiting velocity is 800 m/s. The exiting temperature is nearest:
The velocity and temperature behind a normal shock wave are 329 m/s and 1500 K, respectively. Calculate the velocity in front of the shock wave.
The pressure ratio across a normal shock wave in air is 4.5. What are the Mach numbers in front of and behind the wave? What are the density and temperature ratios across the wave?
Consider a normal shock wave in a supersonic airstream where the pressure upstream of the shock is 1 atm. Calculate the loss of total pressure across the shock wave when the upstream Mach number is (a) M1 = 2.5, and (b) M1 = 4.5. Compare these two results and comment on their implication
Consider a normal shock wave in air where the upstream flow properties are u1 = 660 m/s, T1 = 288 K, and p1=1 atm. Calculate the velocity, temperature, and pressure downstream of the shock.
Consider the supersonic flow of air over a two-dimensional wedge with a half angle of 10 degrees at 70 kPa, 260 kelvin, and mach number 2.4 after shock. If the axis of the wedge is tilted 25 degrees beforehand, determine the post-shock Mach number, temperature and pressure on the wedge.
‎Consider a low-speed subsonic wind tunnel designed with a reservoir cross-sectional area of 2 m2 and a test-section cross-sectional area of 0.5 m2. The pressure in the test section is 1 atm.
How does the Mach number affect the behavior of compressible flow in a supersonic nozzle?
Can the Mach number of a fluid be greater than 1 after a normal shock wave? Explain.