Consider this figure and answer the following questions. V₁ = V2 = is+ V3 = 3A (†) Us VI V2 www + V3 20 21 1Ω 112 Use Ohm's Law for each resistor to calculate the values of V₁, V₂ and v3 in volts (V): 3Ω iz

Q: 2. For a given transfer function G(s) = a) Find the natural frequency b) Find the damping ratio. c)…

A: Given,                    Transfer function G(s) = 25s2+12s+25 ωn=?ξ =? ωd=?

Q: is a typical configuration of an exothermic chemical reaction occurring in a Continuous Stirred Tank…

A: Introduction: The jacketed stirred reactor is a self regulating processes. That is, the measured…

Q: Drill 7,3 Repeat Example 7.2 if the 20-cm line is terminated in a 50-22 load instead of a short.…

A:

Q: c) Figure 3 depicts a lengthwise cross-section of a coaxial transmission line, indicating the…

A:

Q: A 3-phase induction motor draws 50 kW from a 220 V, 50 Hz mains. The rotor emf makes 100…

A: Given, A 3-phase induction motor draws, Electrical input = 50 kW Stator losses = 2 kW Supplied…

Q: 2. A second-order system is Y(s)/R(s) = T(s) = (10/z) (s+ z) / ((s + 1)(s + 8)) Consider the case…

A: Given:- transfer function of second order system, YsRs=Ts=10zs+zs+1s+8 Where condition for z,…

Q: What is the frequency for a wavelength of 2 meters? Show detailed calculation.

A: Given data: The wavelength λ=2 m We know that speed of light v=3×108 m/s

Q: How much power will an antenna having a radiation resistance of 5002 radiate when it is fed with 20…

A: Given information: The radiation resistance of an antenna is Rr=50 Ω and the antenna is fed with a…

Q: For the given circuit below calculate i) the total capacitance of circuit ii) the total charge in…

A: The given circuit is,

Q: What is the mass of an assembly of 1000 electrons?

A: In this case, the mass of an assembly of 1000 electrons is to be determined.

Q: Find the F.T of rectangular pulse f(t) = A rec t - T To 2

A: Given expression, ft=Arect-T02T

Q: 12. The speed of the rotating flux in Fig. 20-16 will be (i) 1500 r.p.m. (iii) 750 r.p.m. (ii) 1000…

A: The term "induction motor" refers to a motor that operates on the electromagnetic induction…

Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…

A: A network consisting ac source with resistances, inductance and capacitance as well. We have to find…

Q: A load of 1700W and COS = 0.85 is to be taken from an ideal single-phase transformer. Determine how…

A:

Q: Problem: A coil having a resistance of 7 and an inductance of 31.8mH is connected to 230V, 50Hz…

A:

Q: Use superposition theorem to find the value of VÀ in the following circuit due 3A

A: Given circuit diagram,

Q: For a 8051 system of 11.0592 MHz, Find how long it takes to execute following instructions : DEC R3,…

A: We have an 8051 system with 11.0592 MHz crystal frequency. Crystal Frequency = 11.0592 MHz = 11.0592…

Q: (b) KVL equation for below circuit. V₂

A: Given circuit,

Q: What is the free space path loss in dB over 80 meters at the 2.4 GHz band?

A: Given: The distance between the antennas, d = 80 meters Frequency of a radio wave, f = 2.4 GHz Speed…

Q: 20 V. ΦΩ ΦΩ ΤΩ wwwa Μ ΦΩ -0 b Laing Tharanin's Theorem the equivalent voltage at terminals (ab)…

A: Given circuit:

Q: 1. Determine lx in the circuit below. 600 V ΣΩ /100 5 Ω /30 22 ΠΩΣ 18 Ω 20 Ω

A:

Q: 2. For the manometer setup shown, determine the difference in pressure between A and B. 40,s=0.85…

A:

Q: the attached

A: Given: a) Write down the equation of 1st order Transfer Function in standerd form and the unit step…

Q: Q1. Find the Laplace transform of the following time functions: (a) f(t) = 1 + 2t (b) f(t) = 3 + 7t…

A: We are authorized for answering only three subparts at a time since you have not mentioned which…

Q: 0 B XOR A AND A' A What logic function does the circuit shown implement? XNOR OR NAND NOR F

A: Given diagram,

Q: Que 3.9. In the Fig. 3.9.1 shown, the ideal switch has been open or a long time. If it is closed at…

A: Solution !!

Q: 13 = a vx .This is called I₁ = aVx O a. Voltage controlled dependent current source O b. Voltage…

A: Given circuit symbol:

Q: Den Ston FIGURE 2 X C. For the logic network shown in FIGURE Q2(c): BIED B CD BIOZ NVD i. POZNAT NV…

A:

Q: 2. A coil, having a resistance of 100 2 and an inductance of 0.2 H, is connected in series with a 20…

A:

Q: 2. One of the devices used for the house is a laptop, which power rating is 24W. The usage of the…

A: Given Laptop power rating: 24W Energy cost is RM 0.18/kWh Calculate energy usage for given day:?…

Q: The minimal product of sums function described by the following K-map is- AB с 00 01 11 10 0 1 1 d 0…

A: Given K-map

Q: b. An AM transmitter is modulated by five different tones at 1.5 kHz, 3 kHz, 4.5 kHz, 6 kHz and 7.5…

A: Given: The different tones of an AM transmitter are, f1=1.5 kHzf2=3 kHzf3=4.5 kHzf4=6 kHzf5=7.5 kHz…

Q: D7.35 The bias arrangement of Fig. 7.53 is to be used for a common-base amplifier. Design the…

A: The required circuit parameters can be calculated by using the DC analysis of the common base…

Q: Q/By using Karnough Map BY F=(X₁ X₁ Z₁ W₁u) = 2 (2, 3, 6, 7, 8, 9, 18, 19, 22, 23,27)

A: Given,Fx,y,z,w,u = ∑2,3,6,7,8,9,18,19,22,23,27Here,To determine the simplified expression, we have…

Q: A conducting bar of length L-80 cm is rotated on a conducting circular platform as shown in the…

A: Given data, Magnetic field B=12×10-3 T Angular speed ω=5 rad/s Length L=0.80 m Capacitance C=40×10-6…

Q: A linear resistance potentiometer is 50 mm long and is uniformly wound with wire having a resistance…

A: We have an potentiometer with, Length (l) = 50 mm Resistance of potentiometer = 10000 Ω and we have…

Q: 12. The speed of the rotating flux in Fig. 20-16 will be ........... (i) 1500 r.p.m. (iii) 750…

A: Given figure of 3-phase induction motor, Total number of pole, P = 4 Frequency, f = 50 Hz

Q: 70. ★★ The RL circuit in Figure 25-73 consists of an ideal battery; a resistor, R; an inductor, L;…

A:

Q: R R Vin M +V +V -V +V -V + D m +V +V Q Output In this Delta - Sigma circuit diagram, the power…

A: Given :- Power supplies of a delta sigma circuit +V,-V. Reference voltage Vref=0 V. Find :- Check if…

Q: 4. A balanced 3-6 abc (positive) sequence Y-connected source with 120 Vrms/ has a Y-connected load.…

A:

Q: Q2. Solve, using Laplace, for y(t) in 5 + 3y = 4; y(0 = 0) First solve for Y(s) Q3 d²y dy(0) Solve,…

A: The formula used for solving above 0roblem is given as

Q: Consider the following block diagram: R(s) K Determine the characteristics of this system: 1. The…

A: Given:

Q: Assume that a separately excited shunt de machine has a rated terminal voltage of 230 V and a rated…

A: We got an a separately excited shunt dc machine with, Terminal Voltage (Vt) = 230 V Armature current…

Q: Design a unity gain inverting summing amplifier that will output the sum of two input  voltages. Use…

A:

Q: P3-3 Consider the signal ont At x(t) = T₁ 0, a 2.4 kbps moduration technique. sin(2n fet), 0≤t≤ Ts…

A:

Q: What is the radiation resistance of an antenna which radiates 5 kW when it draw 15 A current?iky

A: Given information: The power radiated by an antenna is given as P=5 kW. The current drawn by the…

Q: An npn transistor

A:

Q: ) The output of a system, y(t), is related to the input of the system, x(t), through the…

A:

Q: 2. Relation between currents according to KCL is 12 i1 i5

A: .

Q: Determine I for the circuit given below. Also,find the voltage gain. 3 ΚΩ SV 3VI 10 ΚΩ Μ 10 ΚΩ Μ Μ 3…

A:

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).