en For uncontrolled full wave rectifier, R=80ohm, L=0.05H, f=50Hz and Vm=288V. Calculate the amplitude of the 2nd ac voltage (V) term of the output voltage. In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the desired unit only as a number. Yanıt:

en For uncontrolled full wave rectifier, R=80ohm, L=0.05H, f=50Hz and Vm=288V. Calculate the amplitude of the 2nd ac voltage (V) term of the output voltage. In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the desired unit only as a number. Yanıt:

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 3RQ: Diodes and rectifiers allow current to _________. flow in one direction only flow in both...

See similar textbooks

Similar questions

Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Thyristor Crout Probe Pulse Generator VC, pulses Probe Scope Thy Orso v Joad O R: 1 The output voltage across R is depicted in 0.5 0.0- b) 0.2 0.0 d)
A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The load is purely resistive of value 52. The DC and RMS output voltages are respectively equal to: Secondary 太D太D,太D, 太D。太De太D, b. Select one: O a. 180V, 240.2V O b. 514.6V, 515.04V O c. 180V, 197.2V O d. 220V, 249.2V
When a 97.36 Hz sinusoidal voltage is applied to the input of a half-wave rectifier, the output frequency (in Hz) is Round your answer to 2 decimal places. Add your answer
When a sinusoidal voltage at 60 Hz is applied to the input of a half-wave rectifier, the output frequency is: (a) 120Hz (b) 30Hz (c) 60Hz (d) 0Hz
When a 60 Hz sinusoidal voltage is applied to the input of a half-wave * rectifier, the output frequency is 60 Hz 0 Hz O 240 Hz 120 Hz If the input voltage to a voltage doubler has an rms value of 12 V, the dc
A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The load is purely resistive of value 50. The DC and RMS output voltages are respectively equal to: Secondary 本D 太D太D 本D。太De 太D, Select one: O a. 180V, 240.2V O b. 514.6V, 515.04V O C. 180V, 197.2V O d. 220V, 249.2V
A forward voltage of 1.75V shifts to the right at a rate 2.65mV per degree centigrade in temperature from 25°C to 85°C. What is the new forward voltage of the diode? Round your answer to 3 decimal places * Your answer
The power output of the half-wave rectifier is rated at 102.4 W with a load resistor of 40 ohms. The RMS voltage at the output is: O A. None of the other choices are correct O B. 12.5 V O C. 102 V O D. 25.5 V O E. 51 V
LIVE In the single-phase rectifier shown in figure Vs is sinusoidal with rms value of 120 V at 60 Hz, Ls = 1 mH and E = 150 V. Fromio waveform io peak value in ampere is io Ls 0000 A E is T4
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to c 20:5A L VI-DC20V 220V omsh T 0.01 F 0.02 F 0.0167 F None of the above euer
A single phase full wave rectifier supplies a 20 Ohm load at an average voltage of 15 V. Determine the source rms voltage. O 23.6 V 16.7 V 9.5 V O 33.3 V