Find the magnitude (in N/m) and direction (in degrees counterclockwise from the +x-axis) of the force that each wire experiences in the figure by using vector addition. (Assume that the +x-axis is to the right and the +y-axis is up along the page.) 7.50 A Top wire magnitude direction Bottom left wire magnitude direction -20.0 cm 22.5 A20.0 cm- Bottom right wire magnitude direction 20.0 cm- 67.5 A N/m ° counterclockwise from the +x-axis N/m ° counterclockwise from the +x-axis N/m o counterclockwise from the +x-axis

Find the magnitude (in N/m) and direction (in degrees counterclockwise from the +x-axis) of the force that each wire experiences in the figure by using vector addition. (Assume that the +x-axis is to the right and the +y-axis is up along the page.) 7.50 A Top wire magnitude direction Bottom left wire magnitude direction -20.0 cm 22.5 A20.0 cm- Bottom right wire magnitude direction 20.0 cm- 67.5 A N/m ° counterclockwise from the +x-axis N/m ° counterclockwise from the +x-axis N/m o counterclockwise from the +x-axis

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter24: Electromagnetic Waves

Section: Chapter Questions

Problem 1CQ: The direction of the electric field shown in each part of Figure 24.5 is that produced by the charge...

See similar textbooks

Similar questions

An inductor of L = 8.1S H with negligible resistance is placed in series with a 8 = 12.1 V battery, a R = 3.00 2 resistor, and a switch. The switch is closed at time 1 = 0 seconds. Calculate the initial current at i= 0 seconds. I(t = 0s) = A Calculate the current as time approaches infinity. Iman = Calculate the current at a time of 2.17 s. 0000
calculate the self GMD of a wire with radius of 0.001 inch., with the following strands. A) 4 strands B) 5 strands ,,,,,,, please make a clear hand written or readable answer and explanation
A motor run by a 7.0-V battery has a 19-turn square coil with sides of length 3.8 cm and total resistance 27 11. When spinning, the magnetic field felt by the wire in the coll is 0.026 T. Part A What is the maximum torque on the motor? Express your answer to two significant figures and include the appropriate units. μÅ Value Submit Request Answer Units ?
Identify the dimensional formula of electric current. a) [M L T-2] b) [M0 L0 T0 A1] c) [M L3 T0] d) [M L2 T-3]
direction of the magnetic field at A1 lying on plane of conductor
ABCD rectangular wire loop is placed next to long straight current wire as shown in the diagram below.AB =8 cm and BD=6 cm. a) Label the direction of force acting on each segment of ABCD.b) Determine magnitude and direction of net force on ABCD.
ABCD rectangular wire loop is placed next to long straight current wire as shown in the diagram below. AB =10 cm and BD=8 cm. 10 A 8 cm 6 A B D a) Label the direction of force acting on each segment of ABCD. b) Determine magnitude and direction of net force on ABCD.
Electric Magnetism Worksheet 1 -6 5. The value of the line integral of B around the closed path in the figure below is 3.77 x 10° Tm. What is the value of I3? Give proof of your answer. 1 = 6.0 A 1 = 2.0 A CS Scanned with CamScanner
In the figure below, a coil of wire is wound around a segment with magnetic flux directed as shown. The coil of wire is connected to a resistive load (not shown in the figure). If the magnetic flux is constant, what will be the direction of the current i2 on the upper section of the wire (that is, which of the red arrows will be correct, if any)? O a. Insufficient information is given. O b. To the left O c. To the right O d. No current will be induced. core
di. Consider below diagram Ai Az Volt Volf meleu 2 meten 1 Di D In above diagram an electromagnet is placed between R1 and R2, such that when the electromagnet is turned on magnetic field is generated perpendicular to the plane of circuit (pointing out of the circuit). The flux thus produce are changing with respect to time. The direction of current is chosen because the magnetic flux is increasing w.r.t time. The relations given as : E.dl EMF and flur is B.ds dt Values of circuit parameter are :- - R1 = 20 Ohm, R2 = 150 Ohm and instantaneous current i = 10 mA. Find a) The potential difference between point A1 and D1 also find potential difference point A2 and D 2. b) the potential recorded by both voltmeter 1 and 2 c) the potential across the voltmeter will be same? If yes then how and if not then why.
Consta In (Figure 1) the top wire is 2.00-mm-diameter copper wire and is suspended in air due to the two magnetic forces from the bottom two wires. The current flow through the two bottom wires is 84 A in each. Part A Calculate the required current flow in the suspended wire (M). Express your answer to two significant figures and include the appropriate units. Figure 1 of 1 HA X•10" M 2.7 102 A Icu Submit Previous Answers Request Answer X Incorrect; Try Again; 2 attempts remaining -3.8 cm -3.8 cm -3.8 cm
Direction: Solve as directed. Write your answers on the box provided. Find the unknown values of voltage and current in each resistor as shown in the given circuit diagram. Y 1. The magnetic field of a certain region has a magnitude of 1.50 T, and its direction is along the positive x-axis, as shown in the figure below. 30 сm e 40 cm 30 cm What is the flux across the surface abcd? a a. b. What is the flux across the surface befc? What is the flux across the surface 50 cm d С. aefd? d. What is the flux across the surface in the shaded volume?