For diffusivity range of 0.05x10^(-4)

Q: A simple Rankine cycle works betw een pressures 46 bar and 10 Kpa, the initial condition of steam be...

A: given p2=46 bar,p2=0.21 barfrom steam tablesat p=46 barh1=2797.0S1=6.010at p=0.1 barh2=29.4Kj/kghf2=...

Q: Tortuosity is always O A. Equal to 1 B. equal to zero C. greater than unity O D. less than unity

A:

Q: 4.4 Calculate the difference in slope of the chemical potential against temperature on either side o...

A: The difference in slope of the chemical potential against temperature on either side of (a) the norm...

Q: 1) Consider the following set of data and answer the following questions: V (umolimin) ISIM 6 x 10 1...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: NUCLEAR CHEMISTRY: Consider the nuclei 117 1.0073 and 1.0087 amu, respectively. 50Sn. Determine its ...

A:

Q: THERMODYNAMICS: Calculate the value of AH (in kJ) for the reaction, 2AR3 (g) + Q (s) → A2R4 (g) + QR...

A:

Q: 1.) The green curve corresponds to (solid, liquid, vapor, sublimate) composition. 2.) The red curve ...

A: (1) The green line correspond to dew point line of Water and acetic acid mixture. Dew point is the t...

Q: 1. In a boiler trial, the percentage composition of coal on mass basis was reported as: C, 88; H2, 3...

A: Coal composition by mass C=88% H2=3.6% O2=4.8% Ash=3.6% Dry flue gas by volume CO2=10.9% CO=1% O2...

Q: The irreversible, first-order, liquid phase reactions AR S are currently carried out in two CSTRS in...

A:

Q: Define the crystal defects types with plotting ( drawing ) each type .

A:

Q: 3. H.W Date Dec. 2021 A petroleum cut has the specific gravity (SG = 0.825 at 60 °F) and the mean av...

A: Specific gravity is the ratio of the gravity of the substance to the gravity of the reference materi...

Q: Calculate the volume of an FCC unit cell in terms of the atomic radius R

A: Atomic radius = R FCC unit cell  We have to find out Volume (v)

Q: Regarding the Fe-C diagram above, enter the % Fe in the phases of the following points:   a) Phase...

A:      

Q: acid in solid state has a viscosity

A: Yes ,  The viscosity of a fat in solid state  is due to the internal friction between the lipids th...

Q: A sample of helium gas was placed inside a cylinder enclosed with a moving piston. The gas expanded ...

A: Given: Constant temperature process  Initial volume V1 is 10.9 Final volume V2 is 15.3  Work done in...

Q: A petroleum cut has the following TBP Distillation data: Volume % distillate 10 30 50 70 90 95 Tempe...

A:

Q: C2 Hbo Oy (hugur) → 2G45 0H Cethan o1) + 2 CH 36H (methunol) Given 70 wt% Sugur in aqueous Jolution ...

A: Write the reaction as follows: C6H20O4   → 2C2H5OH + 2CH3OH   Given, the wt% of sugar is 70%. Conver...

Q: A continuous single-effect evaporator is to be fed with 5000 kg/hr of solution containing 1 wt% solu...

A:

Q: 1) An Zn-Cu alloy contains 15 wt % Zn, the solute in this system is 2) Hydrogen bonding is a form of...

A: Given that  Zn - cu alloy  15 wt % Zn       According to bartleby rule ,I can solved only 1st questi...

Q: In Deacon process, gas phase reaction was carried out in isothermal batch reactor to form chlorine (...

A: Given data: The experimental data for a reaction is given.

Q: Q.5 Consider one such alloy that initially has a uniform carbon concentration of 1. 22 wt% and is to...

A: In this system the surface composition is constant. The diffusion in this system is non steady state...

Q: Q.2. Air flows steadily adiabatically through a pipe with a cross-sectional area of 0.002 m?. At the...

A:

Q: 5. Effect of the strain rate and temperature on the shape and magnitude of the stress- strain curve....

A: Stress is the force applied on objects cross sectional area. This force deforms the object. The amou...

Q: Fxample: Detormine the kinematie vircosities and refractive indare and para ins inaphthenes and arom...

A: Given MeABp=320 0c oAPI=34 kinematic viscosity is calculated for 100 and 210 Fahrenheit      

Q: A petroleum cut has the following TBP Distillation data: Volume % distillate 0 10 30 Temperature °c ...

A: Given data for petroleium distillation cut is- Temperature conversion from ⁰C to K (Kelvin): K= ⁰C +...

Q: Homework Submit to Ziqi Li before Nov 23, 2021 •In a study of sorption of arsenate and sulfate onto ...

A:

Q: Case Study: Two AES exchangers in series have difficulty heating a process stream from 50°C to 90°C ...

A: A adiabatic system which transfers heat from hot fluids to cold fluids is called heat exchanger. Thi...

Q: A petroleum cut has the specific gravity (SG = 0.825 at 60 °F) and the mean average boiling point is...

A: Specific gravity is the ratio of the density of the substance to the density of the reference materi...

Q: 1 a) Find L s(s+1)*

A: By using the Partial Fraction  we get,  1s(s+1)4 = As + B(s+1)4  +C(s+1)3  +D(s+1)2  +E(s+1)        ...

Q: A rubberized, cubic chamber was filled with butane gas and was expanded from 3.0L to 4.5L at a press...

A:

Q: 2. A car travelling at 16 km/h produces 150 g CO per kilometer. How many moles of CO are produce per...

A: Given that, Speed of the car = 16 km/hr The mass of CO produced m = 150 gkm It is required to calcul...

Q: Explain the step by step calculations and assumptions for this problem: Two AES exchangers in series...

A:

Q: A simple Rankine cycle works betw een pressures 43 bar and 10 Kpa, the initial condition of steam be...

A:

Q: An ethanol-water mixture containing 35% mol% ethanol will be refluxed in a distillation tower. The t...

A: Feed F=1000 kgmole/hr xF=0.35 feed is saturated liquid q=1 Reflux ratio R=1 xD=0.7 xB=0.02  

Q: We wish to produce B in the reaction A Bin a continuous reactor at a volumetric flow rate of 4 L/min...

A: Given data: Volumetric flow rate = 4 L/min Initial concentration = 2 mol/L k1 = 0.8 min–1 k2 = 0.05 ...

Q: Stoichiometric 1200 air-fuel ratio 2000 - 1000 Carbon 1600 - E 800 - ,monoxide 1200 600 5 Nitrogen o...

A: Here , we have to find out why level of co is inversly proportional to air fuel rtio.

Q: Alcohol making process can be divided into five distinct steps: harvesting and crushing grapes. ferm...

A: Reaction is C6H12O4→ 2C2H5OH+2CH3OH 70% of sugar T=40℃ Time=500days Conversion=45% Methanol concent...

Q: A Simple Rankine cyele works hetweenpressure 3400 kpaand beahpa. the intial condition of Steam being...

A:

Q: A flue gas analyzed to contain 80.0% nitrogen, 7.00% oxygen, and 13.0% carbon dioxide is sent to a d...

A: Given, Initial pressure, P1 = 95 kPa Initial temperature, T1 = 500 K Initial volume, V1 = 100 m3   F...

Q: 1. Calculate the 200 workers' average daily products and standard deviation of daily products. Daily...

A: First, form a table as shown below: Here, xi is the average of daily products produced,  

Q: 9. How many moles of gas is present if at 400K, its pressure is 1Mpa(1000kpa), and its volume is 5m3...

A: The general gas equation involves pressure, temperature, moles and volume. This is called as ideal g...

Q: What is the “glass transition temperature” of a polymer? (a) How can it be measured? (b) What molecu...

A: a) The glass transition temperature of polymers is the range of temperature where the substrate of t...

Q: QUESTION 10 A dilute solution of acetic acid produced by fermentatioň and oxidation of natural carbo...

A: Given Mass of acetic acid =44.1 g Mass of water=68.8 g   Now molar mass of acetic acid=60 g Molar ma...

Q: QUESTION 10 A dilute solution of acetic acid produced by fermentation and oxidation of natural carbo...

A:

Q: gas mixture stored at 5500 kPa and 320 K contains 80% nitrogen and 20% ethane.  Calculate and compar...

A: given: P=5500 kPa T=320 K basis:1 mole of gas mixture moles of nitrogen=0.8 moles of ethane=0.2 for ...

Q: Solve for the Laplace transform of the function below: , 0<t< T f(t) lo, [0, Select the correct resp...

A: Given Function is Find The Laplace transform of given function

Q: Figure 1 shows the crystal structure of sodium chloride salt (NacI). Let the effective radius of Na ...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: isothermal pulse ‘test on a piece of reaction equipment gave the following result: The output concen...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: Mention at least three main differences between TBP distillation and ASTM distillation method?

A: Distillation is a separation process in which the light hydrocarbons are separated from heavy hydroc...

Q: B- In the Venturi scale, kerosene flows at a density of 0.82 kg/ m3. If the choke diameter is 10 cm ...

A: Given: Kerosene flow in a venturi scale having a choke diameter of D2 = 10 cm and input diameter of ...