For your final exam in electronics, you're asked to build an LC circuit that oscillates at 13 kHz. In addition, the maximum current must be 0.15 A and the maximum energy stored in the capacitor must be 1.2x10-5 J. ▼ Part A What value of inductance must you use? Express your answer to two significant figures and include the appropriate uni L = Submit Part B ON μA Value Request Answer Units ?

For your final exam in electronics, you're asked to build an LC circuit that oscillates at 13 kHz. In addition, the maximum current must be 0.15 A and the maximum energy stored in the capacitor must be 1.2x10-5 J. ▼ Part A What value of inductance must you use? Express your answer to two significant figures and include the appropriate uni L = Submit Part B ON μA Value Request Answer Units ?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 75PQ

See similar textbooks

Similar questions

Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
What is the self-inductance of an LC circuit that oscillates at 60 Hz 1ien the capacitance is 10 F ?
At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor. What is the capacitance of the capacitor?
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
The emf of an ac source is given by v(t)=V0sint, where V0=100V and =200 . Find an expression that represents the output current of the source if it is connected across (a) a 20-pF capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
An RLC series circuit consists of a 50 resistor, a 200F capacitor, and a 120-mN inductor whose coil has a resistance of 20. The source for the circuit has an tins emf of 240 V at a frequency of 60 Hz. Calculate the tins voltages across the (a) resistor, (b) capacitor, and (c) inductor.
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
For the cucu3t shown below, what are (a) the total impedance and (b) the phase angle between the current and the emf? (C) Write, an expression for i(t).
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?