From the given circuit, find: the upper cutoff frequency of the system. a) 8.6 MHz, b) 10.77 MHz, c) 690.15 kHz, d) 801 kHz  the cutoff frequency due to CE a) 222 Hz, b) 327 Hz, c) 489 Hz, d) 577 Hz  Input Impedance Zi a) 2 kohms, b) 1.32 kohms, c) 3.45 kohms, d) 2.22 kohms

Q: Salve thed the following equations using biseetion me

A: It is given that: fX=X sinX+cosX                 And,Xo=πInterval=0, 3

Q: computed Vce of the transistor is negative, what is its region of operation?cut off, active, or satu...

A: We need to find out region of operation for bjt .

Q: R. V. In the circuit above inductance L =1 mH, capacitance C= 2.2 nF and resistance = R0.32 kohm Wha...

A:

Q: Obtain the transfer function of the electrical system. E¡ (s) R R

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: What is a branch circuit? What is a small appliance branch circuit? What is a general purpose circ...

A: To distribute the electricity while wiring ,we connect the supply through main panel. The distribute...

Q: What is the La Place transform of 0.5di/dt?

A:

Q: The highest address decoded by the cicuitry below is В. A14 A0 A19 32K×4 A15 CS 1010 0000 0000 0000 ...

A: It is 20 bit address memory circuit Which can give 1MB memory  To identify highest address Give 1 to...

Q: transfer function of another system is given as:

A: Delta Function- It is also known as the unit impulse function. It's value is equal to zero everywher...

Q: inductive reactance of 8 ohms is connected in parallel with a capacitive reactance of 18 ohms; this ...

A: We need to find out value of resistance for given power factor and we need to find out current and p...

Q: Determine the inverse Laplace transform of the followings 2s²+5s+8 s[[s+3)²+4²] 4s³+5s²+10 s³(s+1) (...

A:

Q: Problem 1: Question 1. Consider the circuit below: 2 kn ww 1:10 10 :1 V1 120 V R2 1 kN ww 2 kl What ...

A: The solution is given below 

Q: An AWG #10 copper conductor has an 80.8-mil diameter. A 50-foot long conductor of this type carries ...

A:

Q: Write the Boolean Expression of the truth Table of 2-1 Multiplexer 2. Write the Boolean Expression ...

A:

Q: IT 32 VR j92 100/0 V -j6 2 Vc

A: The solution is given below 

Q: 4. In the circuit below, calculate the load current, load voltage, load power, diode power, and tota...

A:

Q: Solve for Ct, Qt, Ut,

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Vpp Voo 2) NMOS CL R2 VTN = 5V Vout Rsig un Cc SooMm MI RL SOum ki = 100 MA/v> Usig RI Cs a = 0,00| ...

A: Answer -    

Q: A resistor in series with an 8 ohm resistor absorbs 100 watts when the two are connected across a 60...

A:

Q: An electromagnet is used to support a solid piece of steel, as shown in the figure below. A force of...

A:

Q: From the given Ammeter diagram, the span is -- A. J0407 A a. -1 O b. 4 О с. 3 o d. -1 to 3

A: Given, Ammeter diagram  

Q: 10. A silicon diode has a saturation current of 10 nA at 25t. If it operates over a temperature rang...

A:

Q: Find the ripple factor, r, of the following circuits. Use capacitor to serve as filter(use C = 100UF...

A: In this question,  Find the ripple factor?  We know ripple voltage for full wave rectifier  ∆V= Vm /...

Q: 4) How much energy does a 5mF capacitor connected to a 3v battery store? A)67.5 mJ B)7.5 mJ C)22.5 m...

A: Given: Capacitance, C=5 mF Source, V=3 V  

Q: c.1 For the network given below, determine AVNL, Zi, and Zo.

A: DC analysis of the amplifier Thevenin resistanceRth=91k∥12kRth=10.6kΩThevenin voltageVth=12k12k+91k...

Q: The voltage v = 188 sin(100t+50°) V is connected acroos a 8-H inductor. Determine the current at t =...

A:

Q: The voltage v = 188 sin(100t+50°) V is connected acroos a 261-µF capacitor. Determine the current at...

A: The solution is given below 

Q: Find the fourier trans form

A: Delta Function- It is also known as the unit impulse function. It's value is equal to zero everywher...

Q: 70 30

A:

Q: I= 3.8 A, and Ra= 5.6 Ω; Rb= 4.9 Ω; and Rc= 20.2 Ω Calculate the equivalent Norton resistance, RN, ...

A:

Q: The unit impulse response of a causal LTI system is h(t) = e ktu(t), where k > 0. What is the zero- ...

A:

Q: Consider a transformer where the secondary winding is connected in series to a resistor with resista...

A:

Q: Two parallel conducting plates are each 10 cm by 10cm and separated 2mm. The region between the plat...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: (b) For the following filter circuit shown in Figure: 2(b), draw the wave shapes for Vo,in,i, and Vp...

A:

Q: 1. Design a voltage regulator that will maintain an output voltage of 20 V across a 1-k load with an...

A:

Q: 1. In free space, let Q1 = 10nC be at P1(0,-4,0), and Q2 = 20nC be at P2 (0,0,4) a. Find E at the or...

A:

Q: A plane wave propagating in a lossless dielectric medium has an electric field given with a frequenc...

A:

Q: 1. Find the transfer function, G(s) = V(s)/V(s), for the operational amplifier circuit shown in the ...

A: As per company guidelines we can solve only first question kindly post another question separately 

Q: Determine the source voltage and write the answer in polar form.

A:

Q: Add and Suotrant the fllany vectaz given m pectangubr fivims and illustrate the pirct5a googthieally...

A: Given, We have two vectors. We have to find addition and subtraction of those two. Please find the b...

Q: A homogeneous dielectric (ɛ, = 2.5) fills region 1 (x S 0) while region 2 (x2 0) is free space. %3! ...

A: Given, A homogenous dielectric fills region 1 x≤0 while region 2 x≥0 (a) D1=12ax-10ay+4az nCm2 (b) E...

Q: Determine the steady-state output response of the causal system H(s) given below to an input x(t) = ...

A: We need to find out output response for given input and system response

Q: Find the z-transform of x[n] = (;) cos[won]u[n].

A:

Q: Example Determine the baud and minimum bandwidth necessary to pass a 10 kbps binary signal using amp...

A:

Q: Which is the dominant critical frequency of an amplifier that exhibits three critical frequencies im...

A:

Q: 50 0+ 10 ms t = 0 15 A 100 v, 350 mH 20 Ng Problem 7.72. The action of the two switches in the circu...

A:

Q: SaR Suppose that the signals xfm], x[m] and x,[n] are given by and xfn] ='220 25 2mn 2mn ala) = cos)...

A:

Q: S=?

A:

Q: What is the electric field intensity at a point 30cm from a charge of 0.1 coulomb?

A:

Q: R(s) 20 C(s) s+ 20 (b)

A: According to the given question, it is required to determine the Output response (Impulse, Step, Ram...

Q: (313 – 21² + t – 1)e-ªu(t)

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.