Given the following table of industrial processes in a plant. Determine the Hot Utility and the Cold Utility load using the Analytical method Streams Ts (s-supply) T' (t-target) C [kW/C] Q [KW] H1 205 65 2.0 280 H2 175 75 4.0 400 C1 45 180 3.0 405 C2 105 155 4.5 225

Q: 9. The fixed parallel plates kept at 80 mm apart have laminar flow of oil between them with a…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: n=2

A: Given : Initial burette reading Final burette reading    Volume of Na OH flow rate  =

Q: 2. Two confidential process data sets are shown in the fig- res below. Process A uses input of raw…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: The fastest mode of heat transfer is 1. Conduction 2. Radiation 3. Convection 4. all are equally…

A: Heat is a form of energy that gets transferred from system to the surroundings because of a driving…

Q: Calculuate H(1), H(2), H(3), and H(4).  Also, show the process path for each enthalpy

A: A mixture of benzene and toluene is fed to evaporator. The feed is separated into vapor and liquid…

Q: Given a spherical catalyst, having a diameter of d₁ = 15mm is said to be used in a packed bed…

A: a) Mass Flux of A at the Boundary (External Mass Transfer Limiting)b) Mass Flux of A at the Boundary…

Q: 3 3 3 The average copper grade of the ore is 0.7 %. The total pregnant solution flowrate from all…

A: Given: The average copper grade of the oreThe flow rate of all leach pads The average concentration

Q: Compare and give examples of direct acting and reverse acting controllers.

A: Direct Acting Controllers:Definition: Increase in process variable(PV) leads to an increase in…

Q: An engineer wants to look into the kinetics of the degradation of atrazine (A). There are 2 ways for…

A: Given :With a kinetic constant of  degradation of atrazine (A)dealkylation to develop…

Q: The following data were obtained for the adsorption of a certain material (ORA) on activated carbon…

A: Given :temperature the absorption table of a certain material is given

Q: 4

A: Given :Thermal conductivity, The temperature, The heat generation rate, The density, The specific…

Q: Q1: (20 marks) Write in summary what you know about the first and second fundamental theorems of…

A: The first and second fundamental theorems of calculus are two interconnected concepts that are…

Q: For the sparingly soluble salt CaCl. If we add amount of common ion Cl to the solution of the salt…

A: The common ion effect says that adding a common ion to a solution reduces the solubility of the…

Q: 4-83 Determine the specific volume of superheated water vapor at 15 MPa and 350°C using (a) the…

A:

Q: H2. What is the vapor fraction and vapor composition of a mixture of 40% benzene and 60% acetone at…

A: The composition of benzene in the mixture The composition of acetone in the mixture The temperature,…

Q: Question in Chemical Engineering Don't Answer If u Don't know Compulsory I will give multiple…

A: The objective of the question is to discuss the challenges related to catalyst deactivation in…

Q: If silicon (Si) has density of 2.55 g/cm3, what is its lattice parameter? (Given: the atomic mass is…

A: The objective of the question is to calculate the lattice parameter of silicon, given its density,…

Q: en, temperature (Tin)= 300k face temperature (TW = BLOK mel length 2083 6)= 0.05kgls. 1.

A: GivenInlet temperature Tin =300 KSurface temperature Ts = 600 KChannel length = 0.8 mFlow rate =…

Q: You are designing a medical device to collect Carcinoembryonic Antigen (CEA, MW = 180,000 g mol^-1),…

A: Given:Plasma containing 6.1 ug/ml of CEA flows into the chamber at 125 ml/min31.7 mg of CEA is…

Q: Nitrogen dioxide is one of the many oxides of nitrogen (often collectively called "NOX") that are of…

A: The equilibrium reaction that converts nitrogen dioxide to dinitrogen tetroxide can be written as…

Q: Single pass and overall conversion: The figure below depicts the reaction of ethylbenzene with…

A: Stream 2 molar flow rates of components will be equal to sum of molar flow rates of respective…

Q: 3. An array of 10 silicon chips, each of length L = 10 mm on a side, is insulated on one surface and…

A: If the temperature of each chip may not exceed 80 degree C, the maximum allowable power per chip is…

Q: The elementary isomerization exothermic reaction B is carried out isothermally at 400 K in a PBR in…

A: The temperature of the reaction = 400 KThe pressure drop parameter considered for the reaction above…

Q: (use Antoine equation to calculate vapor pressures), for a system at 60 °C. Also, calculate what is…

A:

Q: 4. Water Water at 300 K and a flow rate of 5 kg/s enters a black, thin-walled tube, which passes…

A:

Q: For this problem, the acid gas is 99.0 mol% methane (CH4) and 1.0 mol% H2S will be treated with a…

A:

Q: The following is a temperature-composition phase diagram for a binary system (A-B). Please answer…

A: Azeotropr graph is given.

Q: How do the viscosities of liquids and low-density gases depend on the temperature and pressure?…

A: Viscosity, or a fluid's resistance to flow, varies with temperature and pressure. Liquids and…

Q: In an air-water vapor mixture at 30°C, the partial pressure of the water vapor is 1.7 kPa and the…

A:

Q: The aim is to reduce the thickness of the first steel wall. Between the two walls there is a…

A: Given : Height Thickness Width Expansion rate Weight of wax

Q: A countercurrent extraction system uses 3 steps for acid extraction acetic acid/water/isopropyl…

A: Given :Feed composition:Mass fraction of acetic acid  in feed Mass fraction of water  in feed Feed…

Q: In a column, air contains 3.6 percent 50₂ (sulfur dioxide) Scrubbed with water. Contaminated air at…

A: Given : Air includes the flow rate of the air's  temperature Pressure Equilibrium relation

Q: The aqueous acetone solution is mixed with Methyl isobutyl (MIB) solvent containing 3% acetone by…

A: Given: the molar flow rate of the lower stream, the molar flow rate of the upper stream, the molar…

Q: The dynamic behavior of the liquid level in each leg of a manometer tube, responding to a change in…

A: Below is the clarified and detailed explanation for above tricky question.....if you are ok with my…

Q: Absolute (100%) ethanol is produced from 95% ethanol and 5% water using the Keyes distillation…

A:

Q: tly of ach its ate ties K, mm M.C in a the d ?) The roof of a refrigerated truck compartment is of…

A: refrigerated truckExplanation:Step 1:Step 2: Step 3: Step 4:

Q: Water (T = 20°C) from a reservoir is pumped up at 5 kg/s through a 3-in Sch. 40 pipe connected to a…

A: Given :Fluid Flow and Pumping:Water is being pumped from a reservoir through a The flow rate is Pump…

Q: Polymer 1. Consider a polymeric sphere that has a drug encapsulated in it. The drug is contained…

A: Given: The mass transfer coefficient Drug are in the range of  Polymers are in the range of

Q: A triple-acting evaporator with direct current power must concentrate 15000 kg/h of an aqueous…

A: Given - Apply to each effect: a) Hourly consumption of heating steam b) Boiling temperature c) The…

Q: Differentiate the following terms used in Chemical processing Extraction vs Distillation

A: Extraction and distillation both are unit operations used in chemical industries and chemical…

Q: 1. A reaction with this enzyme is carried out at very low substrate concentrations. Draw and label a…

A:

Q: when Y; P Pi*(T) drive to get this equation lap = Xi 1 YA У в Ус PA(T) PALT) PA(T)

A: Given xi=yiP/Pi∗(T)We have to prove

Q: P.15.3 Water is pumped through a heat exchanger and control valve. At normal conditions, the flow…

A: a. The pressure drop across the valve at normal flow rate condition.b. The total pressure across the…

Q: 11.7-2. Boiling Point, Dew Point, and Flash Vaporization. Following is the composition of a liquid…

A: The boiling point is where the vapor composition pressure is equal to the surrounding pressure of…

Q: 9:21 X Corr Q1.PNG ■LTE Calculate the corrosion rate of iron in oxygen-free acid, pH = 3; if the…

A: The corrosion rate of iron in oxygen-free acid (pH = 3) is approximately 1.112×1032…

Q: Membrane Separation Experiment (Home Experiment) Using plastic mineral water bottle, rubber band,…

A: Time Permeate Weight (g)Cotton Polyester…

Q: 1. a) The Burgers vector () is the shortest repeat distance in the crystal so that its energy is as…

A: The objective of the question is to determine the magnitude of a perfect dislocation in an…

Q: 2. Casson model was discussed in class in the context of blood rheology. This phenomenological model…

A: Given:

Q: 6. Ethylene can be produced by the thermal cracking of ethane C3H6C2H4+H2 C2H60.5 C2H4+Ch4 The…

A:

Q: The over all draft loss of steam generating unit is 410 mm water. Air enters at 101.325 kPa, 26…

A: