H₁ (Z) H₂(Z) = = H3 (2) = + H₁ 1-0.32-1 6 1+0.57' 7 1+0.52-1 H₂ H3 H[n] Find h[n] of the all system.

Q: it shown below For the circuit v = 90 e-50ty and 1=30 e -50t A, t>0 of i Find Land R ii) What…

A: In this question we need to find the following Value of R and L  what fraction of the initial…

Q: 2. Given the circuit diagram as shown below, solve for IT, R₁, R2, V2, V3, V5, V6, 12, 14, and I5. E…

A:

Q: At an operating frequency of 3GHz, what value of capacitance (in pF) is required to shunt resonate a…

A: In this question we need to find value of capacitor required to shunt resonate at frequency of 3…

Q: Q4: (a) For the circuit shown in Figure-4, calculate the load resistance R₁ to be connected across…

A: In this question we need to find the following RL for maximum power transfer to load Maximum power…

Q: Electricity and magnetism exhibit duality. Select the pair of variables that are dual to each other.…

A:

Q: Determine whether the following systems are: a) y[n]= nx[n] b) y(t)= ex(t) i) Memoryless ii) Causal…

A: In this question,  We need to check the memoryless, causality, Linearity and time variant properties…

Q: 9.3 A sinusoidal current is zero at t = 150 µs and increasing at a rate of 20,000 T A/S. The maximum…

A: Given data Current Sinusoidal in nature Zero at t=150μs and increasing at 20000π A/s Maximum…

Q: Ug(t) ( ww 100 Ω 150 Ω 12 Η 40 Ω 8 Η i(t)

A:

Q: SP21: For the circuit shown, determine the State Table and Stale 9' x O 1 ↑select x 70 91 %0 90…

A:

Q: 107. Find the currents (3) in the following "non-simple" circuit V₁-12 V; V2-28 V; V3-22 V. R1-502,…

A: Values of each element is given as, V1=12 V, V2=28 V,V3=22 V, R1=5Ω, R2=8Ω, R3=3Ω, R4=1Ω, R5=4Ω.…

Q: A 7.5 KVA, 240/600-V, 50 Hz, single-phase transformer is tested with the following results. Find the…

A:

Q: $ 7-7 The circuit in Figure P7-7 has 15 V stored across the two capacitors at t=0, with the same…

A: C1 = 10,000 pF, C2 =22,000 pF, R1 = R2 = R3 = 470 kΩ Vc1(0-) = Vc2(0-) = 15 V

Q: An six-pole, 24 KW, 120 V, DC machines has a duplex LAP-wound armature which has 96 coils with 16…

A: In this question,  We need to determine the armature resistance.  We know This is duplex LAP…

Q: d) Linear bilateral elements 2) The Super Position theorem is applicable to a) Linear, non-linear…

A: Step-1-> Ans(1)-> The Superposition theorem is a circuit analysis technique that is applicable…

Q: 1- Simplify the given Boolean functions a) F=XY' +YZ+Y'Z' b) F= (X'+Y')X c) F= (X') (X+Y') (X) d) F…

A: The given boolean function needs to be simplified by using any method.

Q: Sledge laser sledge motor photodetector lens spindle disc lens 7.18 CD-ROM Drive Components and…

A: A CD-ROM (Compact Disc-Read Only Memory) drive is a device used to read data from a CD-ROM disc. The…

Q: Calculate the beamwidth in degrees of a parabolic antenna with a diameter of 3 meters, an efficiency…

A: To calculate the beam width in degrees of a parabolic antenna with a diameter of 3 meters, an…

Q: In the Wheatstone bridge circuit of Figure P4 determine: a) voltage Vs across the current source…

A: For the given circuit we have to find the total voltage, node voltage at node a and b & the…

Q: What is the Z-transform of a signal in the context of digital signal processing? How is it different…

A: In digital signal processing, the Z-transform is a mathematical transformation that maps a…

Q: Q5. Digital logic circuit analysis Find the digital logic circuit output Y as shown above, where the…

A:

Q: 200 204F 504¢ 10MF Find Crotal

A: NOTE : As per our company guidelines we are supposed to solve only one question. Kindly re-post the…

Q: An alternator and a synchronous motor are rated 44.1 MVA, 14.8 kV and each has a subtransient…

A: In this question we need to find RMS value in ampere of subtransient current in the alternator…

Q: Silicon nanowires (SiNW) are thin semiconductor devices (ca. 10nm in diameter and ca. 1 µm in…

A: DNA in solution can be found using a biosensor called an ion-selective field effect transistor…

Q: Determine resistance R such that the voltage gain to/= -1/5. 752 R www 202 10 92 49 0+ 28

A:

Q: 4.46 The electric field intensity in free space is given by E = 2 xyz ax + x²z ay + x²y a₂ V/m…

A: Electric field intensity in free space is, E=2xyzax+x2zay+x2yaz V/m Charge Q=2 C is required to move…

Q: Consider the circuit below in Fig. Q1 with independent voltage sources, a) Using any analysis…

A: Circuit is,

Q: 5. Determine the impedance Z₁ for maximum average power transfer and the value of the maximum power…

A:

Q: 10. A positive-sequence balanced three-phase wye-connected source supplies power to a balanced…

A: As the given system is balanced three phase system,we will do all the calculations on per phase…

Q: What will Vs be if Vg1 is 0.02V?

A:

Q: 2. Determine the load impedance for the circuit that will result in maximum power transfer being…

A:

Q: A 35.2 HP, 250 V, 100 A. 1500 RPM, series DC motor with ndmature reaction is considered in this…

A:

Q: 5. A message signal mi() is normalized to a peak voltage of 15V. The average message power is (1004)…

A: SQNR The quantization error—also known as quantization noise—introduced during the analog-to-digital…

Q: 58. For power measurement in a 3 phase load, two wattme- ter methods were used as shown below: Re…

A: It is given that: VR=4403∠0°=254.08∠0° VVY=4403∠-120°=254.08∠-120° VVB=4403∠-240°=254.08∠-240° V

Q: A ceramic capacitor has a value of C=10,000 pF.  The capacitor consists of a dielectric disc between…

A: We need to find out the electric flux density for given capacitor.

Q: Sketch the voltage transfer characteristics of an ideal voltage amplifier and a real voltage…

A: To Find:  Voltage transfer characteristic sketch of an ideal and practical (Real) voltage amplifier.…

Q: The equivalent circuit of a 22KVA, 11700/450 V, 60Hz, single-phase loaded transformer when referred…

A: The circuit diagram is shown below,

Q: A single phase bridge inverter has an RLC load with R= 20 ohms, L= 32 mH and C = 0.115 mF. The…

A: In this question we need to find the power absorbed by the load Po and the fundamental power Po1 .

Q: 9.2 For the PMOS differential amplifier shown in Fig. P9.2 let V₁ = −0.8 V and k'W/L = 4 mA/V².…

A:

Q: S E R₁ C₁ R3 R₂ C2- R4 R5

A: R1 = 2R, R2 = 2R, R3 = 3R, R4 = 2R, R5 = 3R, C1 = 6, C2 = 6 Vc1(0-) = Vc2(0+) = 0 V Circuit diagram

Q: The equivalent circuit of a 22KVA, 11700/450 V, 60Hz, single-phase loaded transform referred to its…

A:

Q: Consider a step up converter with a resistive load of value R-5 Ohms. It is supplied by a DC power…

A: In this question we need to find the RMS value of load current for the given step up converter.

Q: Question 3 The input to the circuit shown in Figure 3 is the voltage vs. The output is the voltage…

A:

Q: A 220 V shunt DC motor rotates with speed of 1800 rev/min at no load condition when the current is 8…

A:

Q: e=2 sin (cot) Figure 3 RL high-pass filter R = 75 ohms ww L = 2.4 mH Page3 Vout 4. Write below the…

A:

Q: Determine the SWR of a 300-ohm line whose load is 400 + j150 Ω

A:

Q: 12v r 10ohms R1 30ohms Fig 4 R2 In the circuit above, the maximum power transferred by the source to…

A: In this question we need to find the maximum number transfer to load

Q: pistanTV Example 6.2: A uniform surface current density K = 50 â. passed through a loop of radius a…

A: In this question we need to find the total current

Q: What is the total power, current, and resistance? Also what is the current for the second resistor

A:

Q: 7-3 Find the time constants of the circuits in Figure P7-3. 250 mH 250 2 mm 330 Ω Σ 250 mH www C1…

A: In this question we need to find the time constant of the given circuit

Q: For the system whose differential equation is given: i veren sistem için: ÿ+2x+5x=3u, x(0)=0, x(0)=0…

A: Here in given difference x are given but x is taken not possible  to proceed . So it is taken as…

Gradient of a Scalar Field

Consider a room or a place where the temperature is denoted by a scalar field T, such that at each point (x, y, z), the temperature is given as T(x, y, z). It is independent of time, in which the temperature rises most quickly. The gradient of T will show the direction at that point by moving away from (x, y, z). How far will the rise in temperature in that direction be determined by the gradient magnitude? Consider a surface that has a height above sea level at point (x, y) which is given by H(x, y). At that point, pointing in the direction of the steepest slope or grade is the gradient of H. The magnitude of the gradient of the vector gives the steepness of the slope at that point. How a scalar field changes in another direction can be measured by the gradient by taking a dot product rather than just the direction of the greatest change?