he amount of heat required to change the temperature of a given material is inversely oroportional to the mass of the material and temperature change A True B False Neither true nor false
Q: An automobile traveling 85.0 km/h has tires of 78.0 cm diameter. (a) What is the angular speed of th...
A: a) Write the expression for the angular speed of the tires.
Q: A coil used to produce a magnetic field for an electron beam experiment has a radius of 15 cm and ha...
A: Given: The radius of the coil is 15 cm. The number of turns is 300. The strength of the magnetic fie...
Q: 7. A skier whose mass is 70 kg, takes off from ski jump with a velocity of 50 m/s at an unknown angl...
A:
Q: Two ideal polaroid sheets are arranged so that the angle between the pass-axis of the two sheets is ...
A:
Q: The faster the molecules are moving on the average, the lower the temperature would be A) False B) N...
A: The speed of molecules is directly proportional to the temperature. When the molecules of a substanc...
Q: A 4.00 kg hollow cylinder of radius 5.00 cm starts from rest and rolls without slipping down a 30.0 ...
A: Given, mass of the hollow cylinder, M = 4.00 kg radius of the cylinder, r = 5.00 cm inclination angl...
Q: An ideal monoatomic gas expands from 3.8 L at 340 K to 9.7 L at a constant pressure of 3.3 atm. a.) ...
A:
Q: After considering that 24 hours of right ascension complete one rotation around the celestial sphere...
A:
Q: 102 A
A: please send the remaining part in the next post as it is only allowed to solve 3 subparts per questi...
Q: the human hair is combed using a rubber comb. What charge acquired by the hair and by the comb? in 5...
A:
Q: The angular position of a point on a rotating wheel is given by 0 = 5.28 + 1.52t2 + 4.57t³, where e ...
A:
Q: A fuse is a device that is designed to break the circuit. It melts when the current exceeds its valu...
A: A fuse wire is a safety device which melts immediately when a strong current flows through it.
Q: A wave travels from deep water into shallow water. While in deep water, the wave has a speed of 1.9 ...
A: Given data :- In deep water-speed v1 = 1.9 m/swavelength λ1 = 8.8 mIn shallow water-speed v2 = to b...
Q: Please use the interactive area below to draw the Free Body Diagram for the bowling ball. Add Force ...
A:
Q: Two wheels A and B in the figure are connected by a belt that does not slip. The radius of B is 5.68...
A: Given Radius of B is 5.68 times the radius of A. Let radius of A is rA and radius of B is rB. Now ...
Q: The force needed in accelerating a 3 kg mass at 5 m/s? and a 4 kg mass at 4 m/s?, will be: (A) Zero ...
A:
Q: Consider a symmetric laser cavity consisting of two concave mirrors, both of radius of curvature of ...
A:
Q: A soccer ball is kicked from the ground with an initial speed of 18.4 m/s at an upward angle of 42.1...
A: initial speed of ball , u = 18.4 m/s theta = 42.1 degree Range of ball , R = v^2 * sin(2*theta)/g ...
Q: the magnetic field lines of opposite pole for two bar magnets are similar to the electric field line...
A:
Q: a. A person in a canoe moves the paddle backward in the water, and the canoe moves forward in the wa...
A: newton first law is law of inertia: an object which is at rest or moving will continue to be remain ...
Q: in the Force and Motion experiment use the information from the groph shown. When (morm)was kept con...
A:
Q: Y (125)
A:
Q: How would you orient two long, straight, current carrying wires so that there is no net magnetic for...
A:
Q: he parallel plates of an air capacitor are separated by 3.25 mm. Each plate carries a charge of 6.50...
A: Given that Distance between plates d = 3.25 mm = 3.25×10-3 m Charge...
Q: B. Study the usage of breadboard in electronics. Given the symbol of resistor as difference (battery...
A: For breadboard Vertical lines has same potential or same connection
Q: At the centre of a cubical box +Q charge is placed. The value of total flux that is coming out a wal...
A:
Q: Which of the following increases the rotational inertia of a solid diet about its axis, without chan...
A: We want to increase the rotational inertia (moment of inertia ) of a solid diet about it's axis, wit...
Q: A baseball is hit horizontally. It leaves the bat with a speed of 40 m/s. The batter hit the ball at...
A: Given Initial velocity u= 40 m/s Vertical displacement Sy = -1 m MMotion of projectile can be divide...
Q: 6. You throw a snowball horizontally. It hits a target 2 meters away. You notice that it hit 0.9 m b...
A:
Q: 1. How far should a 6 inches object be located from the light source to create a 2 feet shadow on th...
A: we use the relation length of shadow/distance of screen = length of object/distance of object
Q: Using the component method determine the resultant(magnitude and direction) of the following: B = 20...
A:
Q: Case Example: Compute for the number of images produced by a 2 separate mirrors at an angle of 60 d...
A: If the mirrors are at an angle of 90 degrees, the number of images will be:
Q: A wheel is turning at a constant rate. It completes 100 revolutions in 10 seconds. What is its angul...
A:
Q: Problem 13: Two blocks are tied together with a massless string that does not stretch and connected ...
A:
Q: Problem 14: Using a rope, a man pulls a block of ice across a frozen pond at a constant velocity, as...
A:
Q: (a) If half of the weight of a flatbed truck is supported by its two drive wheels, what is the maxim...
A:
Q: "The rebound coeficient in an inelostic collisionis equal to one". tof Select one: O True Folse
A: Given Statement The rebound coefficient in an inelastic collision is equal to one.
Q: Why can we only visually see the Balmer Series? Are other light spectrums(Lyman Series, Paschen Seri...
A: Given statement is Why can we only visually see the Balmer Series? Are other light spectrums(Lyman ...
Q: The only force acting on a 4.0 kg canister that is moving in an xy plane has a magnitude of 5.5 N. T...
A:
Q: Two blocks are connected by a cord running over a pulley. Ignore the mass of the cord and pulley and...
A: According to Newton's second law F = ma
Q: he compressor on an air conditioner draws 40.0A when it starts up. If the start-up time is 0.50s, ca...
A: Given Data:- Current drawn by the air conditioner is I=40.0 A Time t=0.50 s Required:- Number of cha...
Q: A roll of aluminum foil from the grocery store is 12 inches wide by 75 feet long (if you unroll it)....
A: Answer Mass of the foil is given by Mass = density × volume Volume of foil = length × width × thick...
Q: Q2 ) What is the relationship between wavelength and propagation velocity ?
A:
Q: A rigid body is undergoing planar motion with the velocity of its center of mass vc = 2 m/s i + 5 m/...
A: First Option is correct. Explanation-
Q: An infinite uniform line charge, p = 2 nC /m, lies alone the x -axis in free space, while point char...
A:
Q: Consider a capacitor with parallel plates, the area of the plates is 16.8 cm2 and they are separated...
A:
Q: Using Kirchhoff's Law: Find the currents in each branch as shown below. A R1 R3 I3 Loop 1 R4 Loop 2 ...
A:
Q: On a string instrument, the length of the string varies inversely with the frequency of its vibratio...
A:
Q: Two moles of an ideal gas occupy a volume V. The gas expands isothermally and reversibly to a volume...
A: Given No of moles, n = 2 Initial Volume, V1 = V Final volume ,V2 = 3V Isothermal expansion , Cha...
Q: The angular velocity of a spinning body points out of a page. Which way is the body spinning (when v...
A:
15.
Step by step
Solved in 2 steps
- Even when shut down after a period of normal use, a large commercial nuclear reactor transfers thermal energy at the rate of 150 MW by the radioactive decay of fission products. This heat transfer causes a rapid increase in temperature it the cooling system fails (1 watt 2 1 joule/second or 1W=1J/s and 1MW=1megawatt ). (a) Calculate the rate of temperature increase in degrees Celsius per second (C/s) if the mass of the reactor core is 1.60105kg and it has an average specific heat of 0.3349kJ/kgC. (b) How long would it take to obtain a temperature increase of 2000C, which could cause some metals holding the radioactive materials to melt? (The initial rate of temperature increase would be greater than that calculated here because the heat transfer is concentrated in a smaller mass. Later, however, the temperature increase would slow down because the 5105-kg steel containment vessel would also begin to heat up.) Figure 14.32 Radioactive spentfuel pool at a nuclear power plant. Spent fuel stays hot for a long time. (credit: U.S. Department of Energy)Compare the SI units of specific heat and latent heat and explain any differences.The data in the following table represent measurements of the masses and dimensions of solid cylinders of aluminum, copper, brass, tin, and iron. (a) Use these data to calculate the densities of these substances. (b) State how your results compare with those given in Table 14.1.
- Construct Your Own Problem Consider a person outdoors on a cold night. Construct a problem in which you calculate the rate of heat transfer from the person by all three heat transfer methods. Make the initial circumstances such that at rest the person will have a net heat transfer and then decide how much physical activity of a chosen type is necessary to balance the rate of heat transfer. Among the things to consider are the size of the person, type of clothing, initial metabolic rate, sky conditions, amount of water evaporated, and volume of air breathed. Of course, there are many other factors to consider and your instructor may wish to guide you in the assumptions made as well as the detail of analysis and method of presenting your results.A sample of a solid substance has a mass m and a density 0 at a temperature T0. (a) Find the density of the substance if its temperature is increased by an amount T in terms of the coefficient of volume expansion b. (b) What is the mass of the sample if the temperature is raised by an amount T?A sample of gas with a thermometer immersed in the gas is held over a hot plate. A student is asked to give a step-by-step account of what makes our observation of the temperature of the gas increase. His response includes the following steps, (a) The molecules speed up. (b) Then the molecules collide with one another more often. (c) Internal friction makes the collisions inelastic, (d) Heat is produced in the collisions. (e) The molecules of the gas transfer more energy to the thermometer when they strike it, so we observe that the temperature has gone up. (f) The same process can take place without the use of a hot plate if you quickly push in the piston in an insulated cylinder containing the gas. (i) Which of the parts (a) through
- Beryllium has roughly one-half the specific heat of water (H2O). Rank the quantities of energy input required to produce the following changes from the largest to the smallest. In your ranking, note any cases of equality, (a) raising the temperature of 1 kg of H2O from 20C to 26C (b) raising the temperature of 2 kg of H2O from 20C to 23C (c) raising the temperature of 2 kg of H2O from 1C to 4C (d) raising the temperature of 2 kg of beryllium from 1C to 2C (e) raising the temperature of 2 kg of H2O from -1C to 2CA 1.00MT bomb exploded a few kilometers above the ground deposits 25.0% of its energy into radiant heat. (a) Find the calories per cm2 at a distance of 10.0 km by assuming a uniform distribution over a spherical surface at that radius. (b) If this heat falls on a person’s body, what temperature increase does it cause in the affected tissue, assuming it is absorbed in a layer 1.00cm deep?A sample of gas with a thermometer immersed in the gas is held over a hot plate. A student is asked to give a step-by-step account of what makes our observation of the temperature of the gas increase. His response includes the following steps. (a) The molecules speed up. (b) Then the molecules collide with one another more often. (c) Internal friction makes the collisions inelastic. (d) Heat is produced in the collisions. (e) The molecules of the gas transfer more energy to the thermometer when they strike it, so we observe that the temperature has gone up. (f) The same process can take place without the use of a hot plate if you quickly push in the piston in an insulated cylinder containing the gas. (i) Which of the parts (a) through (f) of this account are correct statements necessary for a clear and complete explanation? (ii) Which are correct statements that are not necessary to account for the higher thermometer reading? (iii) Which are incorrect statements?
- For the human body, what is the rate of heat transfer by conduction through the body’s tissue with the following conditions: the tissue thickness is 3.00 cm, the change in temperature is 2.00C, and the skin area is 1.50m2. How does this compare with the average heat transfer rate to the body resulting from an energy intake of about 2400 kcal per day? (No exercise is included.)A pitcher throws a 0.142-kg baseball at 47.2 m/s. As it travels 16.8 m to home plate, the ball slows down to 42.5 m/s because of air resistance. Find the change in temperature of the air through which it passes. To find the greatest possible temperature change, you may make the following assumptions. Air has a molar specific heat of CP = 72IR and an equivalent molar mass of 28.9 g/mol. The process is so rapid that the cover of the baseball acts as thermal insulation and the temperature of the ball itself does not change. A change in temperature happens initially only for the air in a cylinder 16.8 m in length and 3.70 cm in radius. This air is initially at 20.0C.Object A is placed in thermal contact with a very large object B of unknown temperature. Objects A and B are allowed to reach thermal equilibrium; object Bs temperature does not change due to its comparative size. Object A is removed from thermal contact with B and placed in thermal contact with another object C at a temperature of 40C. Objects A and C are of comparable size. The temperature of C is observed to be unchanged. What is the temperature of object B?