HO ∞ H Br KMnO4 NaOH 0 °C 1. KMnO4, NaOH, A 2. dil. H₂SO4, H₂O 1. KMnO4, NaOH, A 2. dil. H₂SO4, H₂O Zn(Hg) HCI NaBH, CN, EtOH, pH 5 PBr3

Q: Procedure A: Molarity (M=g/MM/L) Step 1. Place one-eighth of a teaspoon (this weighs approximately…

A: A saturated solution of NaCl is when we cannot dissolve more NaCl in the solution. In this condition…

Q: Calculate the molarity of H₂SQ if 25.1 ml of it reacts with 0.422 g of sodium carbonate?

A: Molarity of H2SO4 can be calculated from the moles of sulphuric acid required for sodium carbonate.

Q: 2. Two analytical chemists have reported a method for monitoring the concentration of SO₂ in air.…

A: Solution: In this solution we have to calculate the difference between the standard method and the…

Q: Diagram the pi molecular orbitals for the ion below. This drawing should be top view. + CH3…

A:

Q: 1. A solution is made by mixing 3.40 g of tea in 76.0 g of water. What is the mass percent of tea in…

A:

Q: Consider the following chemical reaction: MgO (s) + 2HCl(aq) ---------->MgCl2(aq) + H2O(l)  How…

A: Given mole of hydrochloric acid is 3.20

Q: What type of amine is the molecule below? primuary secondary fertiary quatemary H₂C CH₂ NH

A: What type of amine present is the molecule?

Q: Using Zaitsev's rule, choose the most stable alkene among the following. Draw out the structures of…

A:

Q: A simulated IR spectrum of [Rh(CO)3] is shown below. Use this data to deduce the geometry of the Rh…

A: We have given,  A simulated IR spectrum of [Rh(CO)3] in which 3 peaks are shown.    For deduction of…

Q: Eren, Rochelle, and Sarah were assigned to do a recrystallization experiment using three different…

A:

Q: or the reaction 2Mg(s) + Cu(NO3)2 (aq) -> Cu(s) + 2 MgNO3 (aq) write a net ionic equation, which…

A: write a net ionic equation, which reactant was oxidized, which reactant was reduced, which reactant…

Q: A 10 ml of concentrated acetic acid was added in a sufficient quantity of water to make 350 ml of…

A:

Q: write a rate law for the following reaction if reaction order n=1 2 N2O5 (g) -> 4 NO2 (g) + O2 (g)

A: The relation between the concentration of the reactants and the rate of reaction is expressed by the…

Q: The graph shows the molecular speed of four gases at 27 °C. What, if any, relationship is observed…

A: Most probable speed (Vmp) is defined as the speed acquired by most of the molecules of the gas. From…

Q: A simple cubic cell contains one metal atom with a metallic radius of 100 pm. a. Determine the…

A: Radius of atom R = 100 pm = 100 * 10-12  m = 10-10 m    Note : As per guidelines we are answering…

Q: . Show a reasonable mechanism for the following reaction. benzoic acid 1. NaOH 2. chloroethane ethyl…

A:

Q: A sample of nickel carbonyl, Ni(CO)4, is placed in a vessel and allowed to reach equilibrium.…

A: Given, Ni(CO)4(g)  <---> Ni(s) + 4 CO(g) Reactant                            gaseous  product…

Q: 4. From the following data table find the average rate of reaction between 25 min to 55 minute. t…

A: First of all we need to plot graph between Time and Concentration.  From this graph we can find out…

Q: If 50 ml of 1.00 M of H₂SQ and 50 ml of 2.0 M KOH are mixed what is the concentration of the…

A:

Q: Draw structural formulas for the diene and dienophile that combine in a Diels-Alder reaction to form…

A: The above reaction is proceed by specific mechanism as shown below.

Q: Calculate the pOH of the following solutions at 25 degrees Celsius. 1 [H+] = 1.0 x 10^-7 M* 2 [H+]…

A: First of all we know that relation between pH and pOH is :         pH + pOH = 14  Or.     pOH = 14 -…

Q: Carboxylic acid functional groups can be part of the parent chain of a molecule. This means that the…

A: we have to draw the structure is HOOCCH2CH(COOH)CH2COOH in bond line form

Q: For each of the following aqueous reactions BELOW, identify the acid, the base, the conjugate base,…

A:

Q: A unknown compound containing Si, H, and O underwent decomposition analysis to yield the following:…

A: Molar mass of silicon = 28 g/mol Molar mass of oxygen = 16 g/mol Molar mass of hydrogen = 1 g/mol To…

Q: Give the major organic product of the following reaction. CH CH₂ O ठं CH, CH CH, CH CH, CH F 1. SOC…

A: The given reactant is a carboxylic acid. General formula of carboxylic acid is RCOOH , where R is…

Q: Question 9 Which ion has +3 charge 28 electrons, and an atomic mass of 70 amu?

A:

Q: BHO DIHADIO OT HOITOUCQuestions and Problems 62 Name the following using the IUPAC Nomen System: Cl…

A: First qe have to select longest carbon chain which includes main functional group.  Iupac…

Q: Given the standard enthalpy changes for the following two reactions: (1) 4C(s) + 5H₂(9) C4H10(g) AH°…

A: The enthalpy change is a state function and the Hess law states that the change of enthalpy in a…

Q: What mass of sodium chloride, NaCI, is needed to prepare 1.50L of a 0.250 M solution?

A:

Q: 2. In the synthesis of tert-butyl chloride, the following steps were done EXCEPT? a. Cold HCl was…

A: To identify the step not involved in the formation of the t-butyl chloride from the tertiary butyl…

Q: 2. Rank the ligands in order of their increasing effect on Act for Cr³+. Do this by looking at the…

A:

Q: Electrophilic bromination of an equimolar mixture of methylbenzene (toluene) and…

A: Methyl group is Ortho para director due it's inductive and hyperconjugation effects.

Q: Electrophilic bromination of an equimolar mixture of methylbenzene (toluene) and…

A: Aromatic compounds like benzene give electrophilic substitution reaction. If an electron donating…

Q: Part A A certain reaction has an activation energy of 67.0 kJ/mol and a frequency factor of A₁ =…

A:

Q: (3) draw the major product of the following reaction, and then the arrow-pushing mechanism o H*…

A: In first step, acid is added to increase the electrophilicity of the carbonyl group. Then methyl…

Q: A Chemistry teacher needs to make 0.45 L of 0.2 M NaOH solution for a class experiment. What volume…

A:

Q: Record all masses to the maximum number of sig figs 1. Mass of beaker 2. Mass of beaker + NaHCO3 3.…

A: Given , Mass of beaker = 109.600 g

Q: Phosphorous and sulfur form an extensive series of sulfides with the general formula PxSy. Determine…

A: Recall the measurements, %S=72.1 % Unknown = PxSy

Q: O A) ethanoic acid and 1-butanol only B) butanoic acid and water only C) 1-butanol and 1-propanol…

A: We need to write product of hydrolysis of given compound.

Q: 1. Label the acid (A), base (B), conjugate acid (CA), and conjugate base (CB) in each of the…

A: Dear student , since you have posted multiple questions we are allowed to solve only first question…

Q: The change in the Gibbs energy of a certain constant-pressure process was found to fit the…

A: We need to find delta(S) from delta(G).

Q: What is the process that involves the breaking of intermolecular forces that hold an enzyme into the…

A: We need to determine to process which breaks apart the 3d structure of enzyme.

Q: Laroka decided to titrate 39.3 mL of 0.100 M HCI with 0.190 M NaOH. What is the pH of the solution…

A: pH can said as potential of hydrogen of an aqueous solution as it is used to determine the H+ ion…

Q: 8. Given the following unbalanced redox reaction: CIO (aq) + (aq) → 103(aq) + CH(aq) Basic solution.…

A:

Q: A mass of 7.16 g carbon monoxide is reacted with 6.84 g hydrogen to form methanol. CO(g) + 2 H₂(g) →…

A: CO(g) + H2(g) → CH3OH (g) The reaction performed in 5 L flask at 85°C. We have to calculate the…

Q: Aqueous sulfuric acid (H₂SO4) will react with solid sodium hydroxide (NaOH) to produce aqueous…

A:

Q: Q1 The following table shows the first five ionisation energies of the elements A and Z in kJ mol-¹.…

A: Ionization energy is defined as the energy required to remove an electron from a gaseous atom or…

Q: A chemist must dilute 45.8mL of 769.mM aqueous aluminum chloride (AlCl3)solution until the…

A: Given data is as follows: The initial volume of the aqueous aluminum chloride V1 = 45.8 mL The…

Q: 1. From the following data find the order or the reaction and the reaction rate constant by trial…

A: Graphical method is very helpful for determining reaction rate. For zero order reaction if we plot…

Q: Dye 2 Consider the spectra of a dye mixture shown here: Dye 1 Dye 2 A. Using the information from…

A: Considering the spectra and answering the following question: A. Using the information from the…