How many reaction/s can be found at support A? а. 1 b. 3 С. 2 d. None of the above How many reaction/s can be calculated at support B based on the given applied loads? а. 1 b. 3 С. 2 d. None of the above Determine the resultant of the given applied loads, assume downward force as positive. a. 1400 lb b. 3000 lb c. 3400 lb d. None of the above

Q: The energy absorbed in a body, when it is strained within the elastic limits, is known as

A: Ans: Strain energy

Q: In potential energy of springs , the Datum must be Select one : A) Minimum gravity force B) Second…

A: POTENTIAL ENERGY = IT IS THE ENERGY THAT IS STORED DUE TO CHANGE IN  THE POSITION OF THE PART OF THE…

Q: The motor of a speed boat develop a power of 80 hp when cruising at a speed of 36 m/s. How much…

A: Motor power, P=80 hpCruising speed , V=36 m/s

Q: aple 2: Convert the quantities 300 lb.s and 52 slug/ft’ to appropriate S tion: Using Table 1-2, 1 lb…

A: Solution:

Q: A body of weight mg is hanging on a string that extends in length by l. The work done in extending…

A: Here the Gravitational force exerted on the body by the Earth (F) is, F=mg where g is the…

Q: For any non cyclic process in the closed system, relationship between heat and work shall be dQ = dU…

A:

Q: Which of the following statement is correct? Select one: O Datum energy is potential Energy…

A: Potential energy: An object which is at some position then it holds some energy that energy is known…

Q: below. 200 2000 bn RATE! 36. Determine the reaction at the roller B, in pounds. (b) 228 down (e) 480…

A: Given data : Moment (M)=-2000 lb×ftUDL (w)=200 lb/ft∑MA=0-RB×14-2000+200×4×42=0RB=-28.57 lb…

Q: For the shallow shaft, the inside diameter, d is generally expressed in terms of the outside…

A: Solution of the question is given below:

Q: A horizontal force of 5.0 N is used to push a box up a ramp 5.0 m long that is at an angle of 15°…

A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…

Q: 2. An object with a mass of 50 kg, located on top of a building 20 m high, is allowed to fall freely…

A:

Q: 1-Static : is defined as the state of equilibrium of bodies affected by a system of force does…

A: 1) option d is correct( all option).  Body in static equilibrium should have zero moment and zero…

Q: the moment of a force is a negat

A: To define: If the moment of a force is a negative value, it implies what

Q: In a lever, the load arm is always the part from the __ to the fulcrum. A. Force B. Mass C. Load

A: In a lever, the load arm is always the part from the __ to the fulcrum. A. Force B. Mass C. Load

Q: 20k N Determine the following: a. R in N b. Angles of A in radians c. Orthogonal component of A to B…

A:

Q: 800 lb 800 lb 600 lb 600 lb 400 Ib 3 ft 3 ft 3 ft 3 ft- 0.6 ft 1.2 ft B. 0.6 ft A. NB= 1252.85 lb,…

A:

Q: wo cables tied together at Care loaded as shown. Given: Q = 160 lb. A 30 3 |C Q

A:

Q: f the mango falls from your head to the ground, how much net force acts on it while falling?  a.…

A: Given:The mango is falling from head to the ground,here only gravitational force is acting on the…

Q: A 5 lbm ball starts rolling up a 30deg incline at speed of 20 ft/s. Using conservation of energy,…

A: Given   Mass, m = 5 lbm       Angle = 30o Velocity, v = 20 ft/s Find  Power, P

Q: A construction site has machines that simultaneously excavate and grade Machine A grades: G = 17.8…

A: Let us make a table of the given data as shown below - The total amount of grading to be done = 100…

Q: Total energy of insulated system       a)none       b)always increases       c)may increase or…

A: Insulated system: It is a system which does not allow heat transfer between System and surrounding…

Q: The algebraic sum of positive and negative work is called ______________.         a. Overall Work…

A: It is required to choose correct answer

Q: 1. Determine the components of the force P (Fbc and Fac) whose line of actions are parallel to AC…

A: Given : To find : Force components along BC and AC

Q: Brigde was designed for ten years , and during the first four years was designed to carry 10…

A:

Q: Question # 2 A gas of mass (4)kg undergoes a quasi-static expansion which follows a relationship p…

A:

Q: 73. If a net force acts on a horse while it is pulling a wagon, the horse *

A: The net force on the wagon equals the force the horse exerts minus the friction force the ground…

Q: An agent which produces or tends to produce motion is called ___________ Select one: A) Moment B)…

A: The correct answer is force. Force is defined as the quantity in physics which tries to change the…

Q: in a hydraulic system the load is 9 times larger than the effort force.what is the dimeter D2 of the…

A:

Q: 11) Joe uses 400 Newtons of force to raise an object to a height of 10 meters with help from a…

A: To determine the gain in potential energy.

Q: Question 13 Solve the problem. Find the work done by a force of 200 pounds acting in the direction…

A:

Q: a. Co-efficient of friction b. Normal reaction C. Reaction force d. Limiting friction

A: Friction force has the tendency to stop impending motion.

Q: Given: A= 5i + 4j + 6k lbm B= 2i + 4j + 9k kgm C= 20i + 20k N Find: R in N

A:

Q: Given: Q=14,361.60gpm L=1000ft D=2ft hf=12.58ft. Determine the friction

A: Given     Discharge, Q = 14361.60 gpm = 0.91 m3/s         Length, L = 1000 ft = 304.8 m…

Q: Question 6 6.1 State the law of conservation of energy 6.2. A body is stationary on top of a…

A:

Q: knowing that: 0,2 m, 2,=25 W/(m =0,1 m, 2g=1 W/(m =0,2 m, 23=0,02 W

A:

Q: uces 10 kW indicated power & mechanical efficiency is 80%. The  friction power is

A: given:indicated power ip=10kwηmech=80%

Q: A hoisting engine lifts a 450 kg bucket containing 5,5 m3 broken ore with a density of 1,6 t/m3 a…

A: Bucket mass = 450 kg V = 5.5 m3 ore with a density of 1.6 t/m3 height of 1 500 m in three minutes.…

Q: When calculating work done by forces, the work of an internal force does not have to be considered…

A: In order to move a body through a certain distance, some amount of energy is required. This energy…

Q: In a lever, the load arm is always part from the ___ to the fulcrum.  A. Force  B. Mass C. Load

A: In a lever, the load arm is always part from the ___ to the fulcrum.

Q: Question #3: Given: A 100 Kg roller coaster car has an initial velocity of 5m/s. It starts from a…

A: Given data: The mass of the roller coaster is; m = 100 kg. The initial height of the roller coaster…

Q: : a. An ace b. A heart c. A 6 of spades d. A 10 or a jack

A:

Q: 2 a Why first law of thermodynamics is not sufficient and second law is required? b. What are…

A: Thermodynamics is a  branch dealing with the energy, radiation, and physical properties of heat,…

Q: Unit of force is- a- Joule b- Meter c- Newton d- kg Select the correct option quick fast within one…

A: Given Data⇒ Force

Q: MCQ: Determine the member force CD and DF. 1 kN 2 m 2 m 2 m C D 2 kN 4 m F O a. CD = 2.49 kN & DF…

A:

Q: -3 ft- 0.5 ft B 0.5 ft k = 1.20 lb/ft A 1ft

A: first of all convert all quantities in SI units,then apply energy conservation principle.for…

Q: HOW COMPLETE SOLUTION A 5kg block rests on the smooth incline (30 degrees above horizontal) and is…

A: To find: The total work done by all the forces acting on the block. Given: The mass of block is m=5…

Q: By the sign convention, work is positive when a system does work on its surroundings. O True False

A: In thermodynamics, the classical sign convention for both heat and work is as follows  Work Transfer…