If the pressure value of a monatomic gas is 296.063atm, what is the value of the constant Rif the volume of the container is 2L, the temperature is 25C, and the heat capacity is constant volume is 2.98?

If the pressure value of a monatomic gas is 296.063atm, what is the value of the constant Rif the volume of the container is 2L, the temperature is 25C, and the heat capacity is constant volume is 2.98?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter2: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 43P: The product of the pressure and volume of a sample of hydrogen gas at 0.00 is 80.0 J. (a) How many...

See similar textbooks

Related questions

Q: A horizontal power line carries a current of 4140 A from south to north. Earth's magnetic field (85....

Q: frictionless pulley at the top of the inclines as shown, so the blocks can slide together. The mass ...

Q: A weather satellite is to be placed in a circular orbit around the earth at an altitude of 300 miles...

Q: A 45 kg boy whose leg bones are 5 cm² in area and 50 cm long falls through a height of 2 m without b...

Q: Given data : Work done=120 J Displacement=22 m Find force

A: Given data : Displacement=d Work done=W To find : Force

Q: A hydraulic press for compacting pov large cylinder which is 10.0 cm in dia linder with a diameter o...

A: We know that the relation between the pressure and the force is given as Pressure =Force Aera P = F...

Q: 3. A car skids to a stop on an icy road. The car has an initial velocity of 25.0 m/s and skids for a...

A: In this question we have to find the deceleration of the car. Please give positive feedback if the a...

Q: A Nichrome heater dissipates 520 W when the applied potential difference is 110 V and the wire tempe...

A: Let Rh be the resistance at the higher temperature (800°C) and let Rl be the resistance at the lower...

Q: In a downhill ski race surprisingly little advantage is gained by getting a running start. This is b...

Q: Two billiard balls are initially traveling toward each other at speeds of 2.30 m/s for ball 1 and 4....

A: In an elastic collision, the total linear momentum and the total kinetic energy of the system is con...

Q: On a level ground, a meter sticks and a building cast shadows of 1.8 m and 90 m respectively. What i...

Q: Why are two wires used to carry electric current instead of a single one? Explain in not less than 3...

A: Given For electric current to pass we use two wires We have to find the answer, why do we not use si...

Q: To produce a vibration, what three (3) properties of a body must a force overcome?

A: In this question we have to answer the three properties of a body must a force overcome. Please give...

Q: A bullet of mass 11.7 g is fired into an initially stationary block and comes to rest in the block. ...

Q: A student makes a short electromagnet by winding 450 turns of wire around a wooden cylinder of diame...

Q: 1. Find the work done on a 48,500 g object to move it on a 22.55 m up a 25.50 degrees incline. - 397...

Q: Breakdown and explain the motion of a projectile enumerating the relation of its components to a rec...

A: In this question we have to explain the motion of a projectile enumerating the relation of its compo...

Q: QUESTION 40 A 3.7 kg box on a horizontal plane is pulled to the right using a string. The tension in...

A: mass of box (m) = 3.7 kg tension in the string = 25 N coefficient of kinetic friction = 0.4 coeffici...

Q: In a gas that is a mixture of water (two H and one O) and carbon dioxide (one C and two O), if the w...

Q: This time the magnet has mass 6.08 kg and the force pulling it to the right is 110.3 N. When the mag...

Q: Classical Doppler Effect Problems DE-1 Two trais, A and B, are approaching each other on adjacent tr...

Q: 1. What is the capacitance of a parallel plate capacitor with metal plates, each of area 1.00 m², se...

Q: Given data : Voltage=30 Volt Resistance-4 ohm Find current

Q: Three negative point charges lie along a line as shown in the figure below. Find the magnitude and d...

Q: force pulling it to the right is 108.0 N. The length of the cord is 1.13 m, and the ceiling is 2.75 ...

A: Previous question:- The same situation as in the previous two problems this time the magnet s mass ...

Q: After fixing a flat tire on a bicycle you give the wheel a spin. Its initial angular speed was 5.40 ...

Q: A bag falls from an airplane flying horizontally at an altitude of 490 meters. When will it strike t...

Q: A short vertical transmitting antenna erected at the surface of a perfectly conducting earth transmi...

Q: ollege.com/course.html?courseld%3D172213328OpenVellumHMAC=D9208e34104b2ff07559f86fc719d680a#10001 A ...

Q: What is the smallest separation between two slits that will produce a second-order minimum for 720 n...

Q: wo blocks are positioned on surfaces, each inclined at the same angle of 47.7 degrees with respect t...

A: GivenAngle, θ=47.7°Mass of black block, M=7.01 kga=1.5 m/s2

Q: er, a distance 10 m from a burning building, directs a stream of water from a fire hose at an angle ...

A: GivenDistance between firefighter and building, d=10 mAngle of stream of water above horizontal, θ=4...

Q: QUESTION 4 Same situation as in the previous problem this time the magnet has mass 7.83 kg, the for...

Q: Given data: Mass=3 kg Velocity-4 m/s Find momentum

A: Given data : Mass=m Velocity=V To find : Momentum

Q: angle of 54.5 degrees with respect to the horizontal. The blocks are connected by a rope which rests...

Q: What velocity (m/s) must a 10.7 kg object be moving in order to possess a kinetic energy of 1.38J?

A: Given data: Mass (m) = 10.7 kg Kinetic energy (KE) = 1.38 J Required: Velocity in m/s

Q: In the figure circuit section AB absorbs energy at a rate of 47 W when current i = 0.88 A through it...

Q: Two blocks are positioned on surfaces, each inclined at the same angle of 46.2 degrees with respect ...

A: Given: θ=46.2°μ=0.540mass of black block M1=2.56 kgmass of white block M2=?both slides right, with c...

Q: 2. A 10 kW drilling machine is used to drill a bore in a small aluininium block of mass 8-0 kg. How ...

Q: LIFT WING AIR TU111 Pressure exerted by slower-moving air

Q: 1.) For a given voltage, as the resistance in the circuit increases the current: a.) Increases b.)...

Q: A temperature-stable resistor is made by connecting a resistor made of silicon in series with one ma...

Q: A dielectric-filld po allel-plate copacitor Las plate A=10.0cm², plate separation d= 3.00mm and diel...

A: Given, plate area A = 10.0 cm2, plate separation d = 8.00mm dielectric constant k = 4.00 voltage V =...

Q: Part A A dentist wants a small mirror that, when 1.80 cm from a tooth, will produce a 4.5× upright i...

A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a...

Q: Car B gaps Car A by 90 ft as they travel along neighboring highway lanes at t = 0. Determine (a) whe...

A: Part a) Initial time is at t= 0 sec. Let the time taken for the overtake is 't'. The initial velocit...

Q: A student makes a short electromagnet by winding 450 turns of wire around a wooden cylinder of diame...

Q: Same situation as in the previous two problems this time the magnet s mass is 7.20 kg and the magnet...

Q: Two conductors are made of the same material and have the same length. Conductor A is a solid wire o...

Q: A bullet of mass 11.7 g is fired into an initially stationary block and comes to rest in the block. ...

Q: Consider the same situation as in the previous problem. This time the magnet has mass 6.02 kg and th...

A: Option (a) 191.4 N

Question

If the pressure value of a
monatomic gas is 296.063atm,
what is the value of the constant
Rif the volume of the container is
2L, the temperature is 25C, and
the heat capacity is constant
volume is 2.98?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A company advertises that it delivers helium at a gauge pressure of 1.72107 Pa in a cylinder of volume 43.8 L. How many balloons can be inflated to a volume of 4.00 L with that amount of helium? Assume the pressure inside the balloons is 1.72105 Pa and the temperature in the cylinder and the balloons is 25.0 .
A mole of gas has isobaric expansion coefficient dV/dT=R/p and isochoric pressure-temperature coefficient dp/dT=p/T . Find the equation of state of the gas.
One process for decaffeinating coffee uses carbon dioxide ( M=44.0 g/mol) at a molar density of about 14,0 mol/m3 and a temperature of about 60 . (a) Is CO2 a solid, liquid, gas, or supercritical fluid under those conditions? (b) The van der Waals constants for carbon dioxide are a=0.3658 Pa m6/mol2 and b=4.286105 m3/mol. Using the van der Waals equation, estimate pressure of CO2 at that temperature and density. `
The product of the pressure and volume of a sample of hydrogen gas at 0.00 is 80.0 J. (a) How many moles of hydrogen are present? (b) What is the average translational kinetic energy of the hydrogen molecules? (c) What is the value of the product of pressure and volume at 200 ?
Suppose a gas-filled incandescent light bulb is manufactured so that the gas inside the bulb is at atmospheric pressure when the bulb has a temperature of 20.0 . (a) Find the gauge pressure inside such a bulb when it is hot, assuming its average temperature is 60.0 (an approximation) and neglecting any change in volume due to thermal expansion or gas leaks. (b) The actual final pressure for the light bulb will be less than calculated in part (a) because the glass bulb will expand. Is this effect significant?
Under what circumstances would you expect a gas to behave significantly differently than predicted by the ideal gas law?
The 1.8kg gas nitrogen has temperature of 0°C, filled inside 25liter. Calculate the pressure of gas nitrogen. Take gas molecular weight = 28 Please answer in SI unit (even temperature) with no decimals.
ft-lb A certain ideal has a constant gas R= 38.9 Ib-R with k= 1·4. Find the specific heat at constant volume R. if Cv can be computed by 78 t(k) Also, compute BTU for the specific heat at constant pressure.
One mole of an ideal gas does 4500 J of work as it expands isothermally to a final pressure of 1.00 × 105 Pa and volume of 0.031 m3 what was the initial volume ofd the gas inm cubic meters? What is the tenpature of the gas in kelvin?
The deusity of heliuy gas at 0°e Is %o=0.179 Kg Im 3, The terperature is then raised to T- 155°C, but the pressure iskept constant. Assuming that heliM is an ideaf gas, Calculate the new density Pfof the gas. The temperature kg/m3
A monatomic ideal gas is held in a thermally insulated containerwith a volume of 0.0750 m3. The pressure of the gas is 101 kPa, andits temperature is 325 K. (a) At what volume willthe gas have a temperature of 295 K?
What would be the volume of 3.90 moles of an ideal gas, at STP? What is the pressure of this gas, if the temperature was increased from 0 degC to 56.9 degC as it stays in a constant volume container?